Exam Code: cisco 200 310 (Practice Exam Latest Test Questions VCE PDF)
Exam Name: Designing for Cisco Internetwork Solutions
Certification Provider: Cisco
Free Today! Guaranteed Training- Pass ccda 200 310 official cert guide pdf Exam.
2026 New 200-310 Exam Dumps with PDF and VCE Free: https://www.2passeasy.com/dumps/200-310/
Q1. In which operation mode does the AP act as a dedicated sensor for location-based and intrusion detection services?
A. monitor mode
B. promiscuous mode
C. discovery mode
D. sniffer mode
Answer: A
Q2. Which is the equation used to derive a 64 Kbps bit rate?
A. 2 x 8 kHz x 4-bit code words
B. 8 kHz x 8-bit code words
C. 2 x 4-bit code words x 8 kHz
D. 2 x 4 kHz x 8-bit code words
Answer: D
Q3. What three considerations should be taken into account when selecting a routing protocol? (Choose three.)
A. classful routing
B. scalability
C. default route origination
D. multi vendor support
E. link load balancing
F. hop count
Answer: B,D,E
Q4. The enterprise campus core layer has requirements that are unique from the distribution and access layers. Which of the following is true about the core layer?
A. The core layer provides convergence using Layer 2 and Layer 3 services and features.
B. The core layer provides high availability to support the distribution layer connections to the enterprise edge.
C. The campus core layer is optional.
D. The core layer requires high performance to manage the traffic policing across the backbone.
Answer: B
Q5. A secure WAN design requires dynamic routing and IP multicast. What two VPN protocols meet these requirements? (Choose two.)
A. Standard IPsec
B. P2P GRE over IPsec
C. DMVPN
D. AnyConnect
E. PPTP
F. Easy VPN
G. SSL/TLS
Answer: B,C
Q6. DRAG DROP
Answer:
Q7. Your company's Cisco routers are operating with EIGRP. You need to join networks with an acquisition's heterogeneous routers at 3 sites, operating with EIGRP and OSPF. Which describes the best practice for routing protocol deployment?
A. Apply OSPF throughout both networks
B. Apply one-way redistribution exclusively at each location
C. Apply two-way redistribution exclusively at each location
D. Apply two-way redistribution at each location with a route filter at only one location
E. Apply two-way redistribution at each location with a route filter at each location
F. Apply EIGRP with the same autonomous system throughout both networks
Answer: E
Explanation: Without filters there is possibility of routing loops.
Link:
http://www.cisco.com/en/US/tech/tk365/technologies_tech_note09186a008009487e.shtml
Q8. What part of the network does a top-down network design focus on for solution development?
A. presentation
B. hardware
C. session
D. application
E. data link
F. transport
Answer: D
Q9. You are tasked with designing a new branch office that will support 75 users with possible expansion in the future and will need a highly available network. Which of the branch design profiles should be implemented?
A. large branch design
B. medium branch design
C. teleworker design
D. small branch design
Answer: B
Explanation:
Medium Branch Design The medium branch design is recommended for branch offices of 50 to 100 users, which is similar to the small branch but with an additional access router in the WAN edge (slightly larger) allowing for redundancy services. Typically, two 2921 or 2951 routers are used to support the WAN, and separate access switches are used to provide LAN connectivity.
Q10. Refer to the exhibit.
Which statement accurately represents the characteristics of the core layer in this design?
A. QoS should only be performed only in the core.
B. Load balancing should never be implemented or used.
C. Access lists should be used in the core to perform packet manipulation.
D. Partial mesh should be used as long as it is connected to each device by multiple paths.
E. Policy-based traffic control should be implemented to enable prioritization and ensure the best performance for all time-critical applications.
Answer: D