Exact of cisco 200 355 exam answers materials and dump for Cisco certification for IT specialist, Real Success Guaranteed with Updated ccna wireless 200 355 pdf dumps vce Materials. 100% PASS Implementing Cisco Wireless Network Fundamentals exam Today!


2026 New 200-355 Exam Dumps with PDF and VCE Free: https://www.2passeasy.com/dumps/200-355/

Q1. What is Cisco WCS Navigator? 

A. a single point of management for multiple Cisco WCS servers 

B. a server for storing and reviewing Cisco Spectrum Expert station data 

C. a server for storing the location data of wireless clients 

D. a GUI for displaying the data of Cisco CleanAir APs, aligned with an uploaded map 

E. a single point of management for multiple Cisco WLC systems 

Answer: A 

Q2. Refer to the exhibit. In an effort to identify RF characteristics at a customer location, an RF engineer uses the Spectrum Analyzer tool that is shown. Which feature that is native to the Spectrum Analyzer is identified by the exhibit? 

A. Real-Time FFT 

B. Duty Cycle 

C. Max Hold 

D. Time Domain 

Answer: A 

Q3. An engineer is trying to identify if radar has impacted the wireless network at a customer site. When using the controller GUI, which dashboard in the Monitor section presents this information? 

A. 802.11a/n - Air Quality Reports 

B. Clean Air - Worst Air Quality Report 

C. 802.11b/g/n - Interfering Devices 

D. Statistics - Mobility Statistics 

Answer: A 

Q4. An installation uses a 21dBi parabolic dish. It is connected to the 802.11n radio via low loss antenna coax rated at 4dB loss/100 feet. After testing, it has been determined that 2mW of power will be lost in the cable. An EIRP producing 200mW is desired. What should the transmit power be set to? 

A. 8mW 

B. 3dBm 

C. 3.16mW 

D. 5mW 

Answer: C 

Q5. When using Cisco WCS version 7.0, which two features are available for the client troubleshooting tool when a Cisco Compatible Extensions v5 wireless client gets connected? (Choose two.) 

A. Request CleanAir reports from the client 

B. Send text messages to the client 

C. Aggregated Cisco ACS authentication client information 

D. Request the client to ping the DHCP-supplied IP gateway 

E. Display a summary of client event history 

Answer: B,D 

Q6. Which three options relate to event-driven RRM? (Choose three.) 

A. any 802.11n AP models 

B. specific AP models 

C. minimum of AP and WLC 

D. minimum of AP, WLC, and WCS 

E. minimum of AP, WLC, WCS, and MSE 

F. configurable in WLC at 802.11b/g/n > RRM > TPC 

G. configurable in WLC at 802.11b/g/n > RRM > DCA 

Answer: B,C,G 

Q7. An AP has been configured for personal wireless access to the Internet using appropriate security and cloaking. Which two items should be configured on the wireless client? (Choose two.) 

A. RF channel 

B. BSS 

C. PSK 

D. 802.1X/EAP 

E. broadcast SSID 

F. manual SSID 

G. IBSS 

Answer: C,F 

Q8. A customer wants to deploy Cisco Cloud Wireless architecture with 802.11ac capabilities. Which two access points would meet the customers requirements? (Choose two.) 

A. Cisco 3700 Access Points 

B. Cisco MR34 Access Points 

C. Cisco MR18 Access Points 

D. Cisco 3600 Access Points 

E. Cisco MR72 Access Points 

F. Cisco 1570 Access Points 

G. Cisco MR26 Access Points 

Answer: B,E 

Q9. Which portion of a WLAN deployment can WLC message logs help to troubleshoot? 

A. RF issues 

B. encryption issues between APs and clients 

C. configuration verification issues 

D. infrastructure and client Issues 

E. AP placement issues 

Answer: D 

Q10. Which RRM feature allows an access point to avoid non-IEEE 802.11 interference? 

A. DCA 

B. TPC 

C. RF groups 

D. coverage hole detection 

Answer: A