Testking ccna wireless 200 355 official cert guide Questions are updated and all cisco 200 355 answers are verified by experts. Once you have completely prepared with our ccna wireless 200 355 official cert guide pdf free download exam prep kits you will be ready for the real ccna wireless 200 355 dumps exam without a problem. We have Up to the minute Cisco ccna wireless 200 355 official cert guide pdf free download dumps study guide. PASSED ccna wireless 200 355 pdf First attempt! Here What I Did.
2026 New 200-355 Exam Dumps with PDF and VCE Free: https://www.2passeasy.com/dumps/200-355/
Q1. An engineer is conducting an active survey for indoor coverage in a warehouse. The warehouse has long aisles with racks that extend to the ceiling. Which antenna type has a radiation pattern that is suited to provide coverage in each aisle?
A. Yagi
B. patch
C. omnidirectional
D. dipole
Answer: B
Q2. When using the CLI command eping, configured for auto-anchor mobility wireless guest access, which type of packet is tested?
A. data packets
B. mobility unencrypted packets
C. mobility encrypted packets
D. SNMP control packets
E. NTP control packets
Answer: A
Q3. Which type of management tasks can be completed on a Cisco WLC remotely from a wireless client?
A. All management and configuration tasks can be performed from a wireless client except for using debug commands.
B. In the default configuration, no management or configuration is possible through the GUI or CLI on the Cisco WLC.
C. The default configuration of the Cisco WLC allows only CLI access and then only the use of show commands, so no configuration is possible.
D. All management and configuration tasks, except uploads from and downloads to the Cisco WLC, are permitted.
Answer: B
Q4. A customer has completed the installation of an 802.11ac greenfield deployment at their corporate headquarters. They would like to leverage 802.11ac enhanced speeds on the trusted employee WLAN. In order to configure the employee WLAN, what Layer 2 security policies are valid?
A. WPA2 (TKIP)
B. WPA(AES)
C. OPEN
D. WEP
Answer: C
Q5. Which statement about the impact of configuring a single SSID to support TKIP and AES encryption simultaneously is true?
A. The overhead associated with supporting both encryption methods significantly degrades client throughput.
B. Some wireless client drivers might not handle complex SSID settings and may be unable to associate to the WLAN.
C. This configuration is unsupported and the Cisco Wireless Control System generates alarms continuously until the configuration is corrected.
D. This configuration is common for migrating from WPA to WPA2. No problem is associated with using this configuration.
Answer: B
Q6. A network engineer in the GUI of WCS version 7 wants to add an autonomous access point. Where can this command be found in the drop-down menu?
A. Configure > Access Point > Add Autonomous APs
B. Manage > Access Points > Add Autonomous APs
C. Administration > Access Point > Add Autonomous APs
D. Location > Access Point > Add Autonomous APs
Answer: A
Q7. The introduction of consumer phones and tablets into enterprise WLANs can have an impact on 802.11a/b/g/n deployments. The Apple iPhone 4 and iPad 2 are very common examples.
Which statement best describes the abilities of these devices?
A. The Apple iPhone 4 and the iPad 2 use 2.4 GHz and 5 GHz. The Apple iPhone 4 uses only one spatial stream and the iPad 2 uses two spatial streams.
B. The Apple iPhone 4 uses only 2.4 GHz and the iPad 2 only uses 5 GHz. The Apple iPhone 4 uses only one spatial stream and the iPad 2 uses two spatial streams.
C. The Apple iPhone 4 uses 2.4 GHz and the iPad 2 uses 2.4 GHz or 5 GHz. The Apple iPhone 4 only uses one spatial stream and the iPad 2 uses two spatial streams.
D. The Apple iPhone 4 uses 2.4 GHz and the iPad 2 uses 2.4 GHz or 5 GHz. The Apple iPhone 4 and the iPad 2 use only one spatial stream.
Answer: D
Q8. You have a lightweight AP that has been moved to a new subnet and has become stranded because DNS and DHCP servers are unavailable. The AP cannot connect to the controller.
When connected to the console port, which three minimum parameters must you configure? (Choose three.)
A. AP IP address
B. controller name
C. AP hostname
D. default gateway IP address
E. controller IP address
F. username and password
Answer: A,D,E
Q9. A customer wants to deploy a mesh network with 2 root access points and 10 mesh access points. The root access points should be configured as which mode on the WLC?
A. mesh
B. FlexConnect
C. bridge
D. rouge detection
E. sniffer
Answer: C
Q10. A network engineer at a retail store needs a wireless deployment that can be easily maintained and verified for PCI compliance. What solution will meet this need with the least work?
A. Cloud
B. Autonomous
C. FlexConnect
D. Centralized
Answer: A