The Up to the immediate present Guide To 300-206 dumps

Q1. When you configure a Cisco firewall in multiple context mode, where do you allocate interfaces? 

A. in the system execution space 

B. in the admin context 

C. in a user-defined context 

D. in the global configuration 

View Answer

Q2. What is the lowest combination of ASA model and license providing 1 Gigabit Ethernet interfaces? 

A. ASA 5505 with failover license option 

B. ASA 5510 Security+ license option 

C. ASA 5520 with any license option 

D. ASA 5540 with AnyConnect Essentials License option 

View Answer

Q3. CORRECT TEXT 

You are a network security engineer for the Secure-X network. You have been tasked with 

implementing dynamic network object NAT with PAT on a Cisco ASA. You must configure the Cisco ASA such that the source IP addresses of all internal hosts are translated to a single IP address (using different ports) when the internal hosts access the Internet. 

To successfully complete this activity, you must perform the following tasks: 

. Use the Cisco ASDM GUI on the Admin PC to configure dynamic network object NAT with PAT using the following parameters: 

. Network object name: Internal-Networks 

. IP subnet: 10.10.0.0/16 

. Translated IP address: 192.0.2.100 

. Source interface: inside 

. Destination interface: outside 

NOTE: The object (TRANSLATED-INSIDE-HOSTS) for this translated IP address has already been created for your use in this activity. 

NOTE: Not all ASDM screens are active for this exercise. 

NOTE: Login credentials are not needed for this simulation. 

. In the Cisco ASDM, display and view the auto-generated NAT rule. 

. From the Employee PC, generate traffic to SP-SRV by opening a browser and navigating to http://sp-srv.sp.public. 

. From the Guest PC, generate traffic to SP-SRV by opening a browser and navigating to http://sp-srv.sp.public. 

. At the CLI of the Cisco ASA, display your NAT configuration. You should see the configured policy and statistics for translated packets. 

. At the CLI of the Cisco ASA, display the translation table. You should see dynamic translations for the Employee PC and the Guest PC. Both inside IP addresses translate to the same IP address, but using different ports. 

You have completed this exercise when you have configured and successfully tested dynamic network object NAT with PAT. 

View Answer

Q4. Which option describes the enhancements that SNMPv3 adds over 1 and 2 versions? 

A. Predefined events that generate message from the SNMP agent to the NMS 

B. Addition of authentication and privacy options 

C. Cleartext transmission of data between SNMP server and SNMP agent 

D. Addition of the ability to predefine events using traps 

E. Pooling of devices using GET-NEXT requests 

F. Use of the object identifier 

View Answer

Q5. Which utility can you use to troubleshoot and determine the timeline of packet changes in a data path within a Cisco firewall? 

A. packet tracer 

B. ping 

C. traceroute 

D. SNMP walk 

View Answer

Q6. Refer to the exhibit. 

Server A is a busy server that offers these services: 

. World Wide Web 

. DNS 

Which command captures http traffic from Host A to Server A? 

A. capture traffic match udp host 10.1.1.150 host 10.2.2.100 

B. capture traffic match 80 host 10.1.1.150 host 10.2.2.100 

C. capture traffic match ip 10.2.2.0 255.255.255.192 host 10.1.1.150 

D. capture traffic match tcp host 10.1.1.150 host 10.2.2.100 

E. capture traffic match tcp host 10.2.2.100 host 10.1.1.150 eq 80 

View Answer

Q7. In which two modes is zone-based firewall high availability available? (Choose two.) 

A. IPv4 only 

B. IPv6 only 

C. IPv4 and IPv6 

D. routed mode only 

E. transparent mode only 

F. both transparent and routed modes 

View Answer

Q8. CORRECT TEXT 

View Answer

Q9. Which two router commands enable NetFlow on an interface? (Choose two.) 

A. ip flow ingress 

B. ip flow egress 

C. ip route-cache flow infer-fields 

D. ip flow ingress infer-fields 

E. ip flow-export version 9 

View Answer

Q10. If the Cisco ASA 1000V has too few licenses, what is its behavior? 

A. It drops all traffic. 

B. It drops all outside-to-inside packets. 

C. It drops all inside-to-outside packets. 

D. It passes the first outside-to-inside packet and drops all remaining packets. 

View Answer