It is impossible to pass Cisco 300-207 exam without any help in the short term. Come to Testking soon and find the most advanced, correct and guaranteed Cisco 300-207 practice questions. You will get a surprising result by our Latest Implementing Cisco Threat Control Solutions (SITCS) practice guides.


2026 New 300-207 Exam Dumps with PDF and VCE Free: https://www.2passeasy.com/dumps/300-207/

Q1. Which IPS engine detects ARP spoofing? 

A. Atomic ARP Engine 

B. Service Generic Engine 

C. ARP Inspection Engine 

D. AIC Engine 

Answer: A 

Q2. What is the default CX Management 0/0 IP address on a Cisco ASA 5512-X appliance? 

A. 192.168.1.1 

B. 192.168.1.2 

C. 192.168.1.3 

D. 192.168.1.4 

E. 192.168.1.5 

F. 192.168.8.8 

Answer: F 

Q3. Which Cisco WSA is intended for deployment in organizations of up to 1500 users? 

A. WSA S370 

B. WSA S670 

C. WSA S370-2RU 

D. WSA S170 

Answer: D 

Q4. When you deploy a sensor to send connection termination requests, which additional traffic-monitoring function can you configure the sensor to perform? 

A. Monitor traffic as it flows to the sensor. 

B. Monitor traffic as it flows through the sensor. 

C. Monitor traffic from the Internet only. 

D. Monitor traffic from both the Internet and the intranet. 

Answer: B 

Q5. Which port is used for CLI Secure shell access? 

A. Port 23 

B. Port 25 

C. Port 22 

D. Port 443 

Answer: C 

Q6. The Web Cache Communication Protocol (WCCP) is a content-routing protocol that can facilitate the redirection of traffic flows in real time. Your organization has deployed WCCP to redirect web traffic that traverses their Cisco Adaptive Security Appliances (ASAs) to their Cisco Web Security Appliances (WSAs). 

The simulator will provide access to the graphical user interfaces of one Cisco ASA and one Cisco WSA that are participating in a WCCP service. Not all aspects of the GUIs are implemented in the simulator. The options that have been implemented are sufficient to determine the best answer to each of the questions that are presented. 

Your task is to examine the details available in the simulated graphical user interfaces and select the best answer. 

Between the Cisco ASA configuration and the Cisco WSA configuration, what is true with respect to redirected ports? 

A. Both are configured for port 80 only. 

B. Both are configured for port 443 only. 

C. Both are configured for both port 80 and 443. 

D. Both are configured for ports 80, 443 and 3128. 

E. There is a configuration mismatch on redirected ports. 

Answer: C 

Explanation: This can be seen from the WSA Network tab shown below: 

\psfHomeDesktopScreen Shot 2015-01-27 at 9.42.49 AM.png 

Q7. A user is deploying a Cisco IPS appliance in a data center to mitigate most attacks, including atomic attacks. Which two modes does Cisco recommend using to configure for this? (Choose two.) 

A. VLAN pair 

B. interface pair 

C. transparent mode 

D. EtherChannel load balancing 

E. promiscuous mode 

Answer: A,D 

Q8. Which command allows the administrator to access the Cisco WSA on a secure channel on 

port 8443? 

A. strictssl 

B. adminaccessconfig 

C. ssl 

D. ssh 

Answer: A 

Q9. Which three features does Cisco CX provide? (Choose three.) 

A. HTTPS traffic decryption and inspection 

B. Application Visibility and Control 

C. Category or reputation-based URL filtering 

D. Email virus scanning 

E. Application optimization and acceleration 

F. VPN authentication 

Answer: A,B,C 

Q10. Which two conditions must you configure in an event action override to implement a risk rating of 70 or higher and terminate the connection on the IPS? (Choose two.) 

A. Configure the event action override to send a TCP reset. 

B. Set the risk rating range to 70 to 100. 

C. Configure the event action override to send a block-connection request. 

D. Set the risk rating range to 0 to 100. 

E. Configure the event action override to send a block-host request. 

Answer: A,B