It is impossible to pass Cisco atr 42 300 320 exam without any help in the short term. Come to Ucertify soon and find the most advanced, correct and guaranteed Cisco 300 320 vce practice questions. You will get a surprising result by our Up to the minute Designing Cisco Network Service Architectures practice guides.


2026 New 300-320 Exam Dumps with PDF and VCE Free: https://www.2passeasy.com/dumps/300-320/

Q1. Which VPN technology supports dynamic creation of spoke-to-spoke VPN tunnels to provide a scalable design? 

A. IPsec 

B. GRE over IPsec 

C. DMVPN 

D. GRE 

Answer: C 

Q2. Which route summarization most efficiently reduces perceived network complexity that is composed of subnetworks ranging from 172.16.20.0/24 to 172.16.36.0/24? 

A. 172.16.8.0/21 

B. 172.16.8.0/19 

C. 172.16.20.0/20 

D. 172.16.0.0/18 

E. 172.16.20.0/19 

Answer: D 

Q3. There are 3 steps to confirm whether a range of IP addresses can be summarized. Which of the following is used in each of these 3 steps? 

A. The first number in the contiguous block of addresses 

B. The last number in the contiguous block of addresses 

C. The size of the contiguous block of addresses 

D. The subnet mask of the original network address 

Answer: C 

Q4. Refer to the exhibit. 

The network engineer wants to ensure that receiver A does not receive traffic from the video conference. 

For multicast traffic, where must the filtering be placed to fulfill that requirement? 

A. R1 

B. Video Conference 

C. A 

D. S1 

E. R2 

Answer: D 

Q5. Which two protocol characteristics should be most considered when designing a single unified fabric for the Data Center? (Choose two.) 

A. FCIP or FCoE allow for easier integration by using the Fibre Channel Protocol (FCP) and Fibre Channel framing 

B. iSCSI uses a special EtherType and an additional header containing additional control information 

C. FCIP and iSCSI has higher overhead than FCoE owing to TCP/IP 

D. FCoE was initially developed to be used as a switch-to-switch protocol, while FCIP is primarily meant to be used as an access layer protocol to connect hosts and storage to a Fibre Channel SAN 

E. FCoE requires gateway functionality to integrate into an existing Fibre Channel network 

Answer: A,C 

Q6. Which two modes does LACP support? (Choose two.) 

A. on 

B. passive 

C. associated 

D. link 

Answer: A,B 

Q7. Which three options are the three layers of the Cisco design in the data center architecture? (Choose three.) 

A. core layer 

B. distribution layer 

C. service layer 

D. aggregation layer 

E. Layer 2 domain sizing 

F. access layer 

Answer: A,D,F 

Q8. Which protocol should be configured if a network administrator has the following requirements? 

. Multiple physical gateways participating simultaneously in packet forwarding. 

. All hosts in the VLAN configured with the same default gateway address. 

A. HSRP 

B. VRRP 

C. VTP 

D. GLBP 

Answer: D 

Q9. Which protocol is used in an in-band network and why? 

A. UDP, because it is connectionless 

B. SSH, because the username and password are encrypted 

C. Telnet, because the username and password are sent in clear 

D. MSDP, because it uses TCP as its transport protocol 

Answer: B 

Q10. Which action can be taken on a multiaccess segment with OSPF speakers to reduce the performance impact during widespread convergence events? 

A. Separate the network into multiple areas for each new multiaccess segment. 

B. Enable LSA throttling in the core to slow link state advertisement updates during times of network instability. 

C. Ensure that the elected DR or BDR router can support high-volume convergence events. 

D. Verify that fewer than 50 OSPF speakers are on the segment. 

Answer: C