2026 New 300-510 Exam Dumps with PDF and VCE Free: https://www.surepassexam.com/300-510-exam-dumps.html
Examcollection 300-510 Questions are updated and all 300-510 answers are verified by experts. Once you have completely prepared with our 300-510 exam prep kits you will be ready for the real 300-510 exam without a problem. We have Up to the immediate present Cisco 300-510 dumps study guide. PASSED 300-510 First attempt! Here What I Did.
Online Cisco 300-510 free dumps demo Below:
NEW QUESTION 1
Refer to the exhibit. Routers R1 and R2 cannot form a neighbor relationship, but the network is otherwise configured correctly and operating normally. Which two statements describe the problem? (Choose two.)
- A. The two routers are in the same area
- B. The two routers are in different subnets
- C. The two routers have password mismatch issues
- D. The two routers have the same network ID
- E. The two routers are in different areas
Answer: BE
NEW QUESTION 2
Which output from the show isis interface command helps an engineer troubleshoot an IS-IS adjacency problem on a Cisco IOS-XR platform?
- A. metric
- B. priority
- C. circuit type
- D. hello interval
Answer: D
NEW QUESTION 3
Refer to the exhibit. A network operator is working to filter routes from being advertised that are covered under an aggregate announcement. The receiving router of the aggregate announcement block is still getting some of the more specific routes plus the aggregate. Which configuration change ensures that only the aggregate is announced now and in the future if other networks are to be added?
- A. Configure the summary-only keyword on the aggregate command
- B. Set each specific route in the AGGRO policy to drop instead of suppress-route
- C. Filter the routes on the receiving router
- D. Set each specific route in the AGGRO policy to remove instead of suppress-route
Answer: A
NEW QUESTION 4
Refer to the exhibit. XR1 and XR2 are sending the prefix 10.11.11.0/24 to XR3. A configured policy on XR1 is incorrectly prepending AS path 11 11 12 12 onto this prefix. A network operator wants to add a policy onto XR3 that will not allow the falsely prepending prefix from being installed. Which policy configuration applied to the XR3 neighbor configuration for XR1 can accomplish this requirement without impact to other or future received routes?
- A.
- B.
C.
- C.
Answer: D
NEW QUESTION 5
Refer to the exhibit. CE1 and CE2 cannot communicate through the service provider BGP peering is established between PE1 and PE2. IS-IS is the only routing protocol running in the service provider core. What step can be done to troubleshoot the issue?
- A. Switch the IGPs running in the core from IS-IS to OSPF to support a Cisco MPLS TE tunnel from PE1 to PE2.
- B. Configure BGP between CE and PE routers.
- C. Confirm that IS-IS is running with metric-style narrow.
- D. Verify the MPLS LSPs.
Answer: C
NEW QUESTION 6
Refer to the exhibit. A network operator is getting the route for 10.11.11 0/24 from two upstream providers on #XR3. The network operator must configure #XR3 to force the 10.11.11.0/24 prefix to route via next hop of 10.0.0.9 as primary when available. Which of these can the operator use the routing policy language for, to enforce this traffic forwarding path?
- A. weight of 0 on the prefix coming from 192.168.0.2
- B. lower local preference on the prefix coming from 192.168.0.2
- C. higher local preference on the prefix coming from 192.168.0.1
- D. weight of 100 on the prefix coming from 192.168.0.1
Answer: C
NEW QUESTION 7
Refer to the exhibit. How are packets directed through the data plane when SRv6 is implemented?
- A. An ordered list of segments is encoded in a routing extension header
- B. The MPLS data plane is used to push labels onto IGP routes
- C. A stack of labels represents an ordered list of segments
- D. The packet is encapsulated with a header and trailer encoding the ordered list of segments
Answer: A
NEW QUESTION 8
What is used by SR-TE to steer traffic through the network?
- A. shortest path calculated by IGP
- B. dynamic rules
- C. path policy
- D. explicit maps
Answer: C
NEW QUESTION 9
You have configured MSDP peering between two autonomous systems that pass traffic between two sites, but the peering has failed to come up. Which task do you perform to begin troubleshooting the problem?
- A. Verify that multicast has been disabled globally
- B. Verify that PIM-DM is configured on the source interface
- C. Verify that both source interfaces are reachable from both peers
- D. Verify that the two MSDP peers allow asymmetric routing
Answer: C
NEW QUESTION 10
A network consultant is troubleshooting IS-IS instances to identify why a routing domains is having communication problems between the two instances. Which description of the possible cause of issues in the routing domain is true?
- A. The same interface cannot be advertised in two different IS-IS instances
- B. The IS-IS “ISP” and “ISP2” instances are unrelated and unable to intercommunicate
- C. The configured IS-IS NSEL value is not allowing the routing systems to establish a neighborship
- D. The interface mode ip router is-is command was not included in the script
Answer: A
NEW QUESTION 11
Which statement about BFD on Cisco IOS XR Software is true?
- A. Cisco IOS XR router must use LDP to route back to the Cisco IOS router to establish the peer relationship.
- B. Cisco IOS XR Software does not support BFD multihop for IPv4.
- C. Cisco IOS XR router must use dynamic routing or a static route back to the Cisco IOS router to establish the peer relationship.
- D. BFD is not compatible between Cisco IOS XR and Cisco IOS Software.
Answer: C
NEW QUESTION 12
Refer to the exhibit. After troubleshooting BGP traffic steering issue, which action did the network operator take to achieve the correct effect of this configuration?
- A. Routes that have passed through AS 65517 have the local preference set to 150.
- B. Routes that have originated through AS 65517 have the local preference set to 150.
- C. Routes directly attached to AS 65517 have the local preference set to 150.
- D. Routes that have passed through AS 65517 have the local preference set to 150 and the traffic is denied.
Answer: A
NEW QUESTION 13
DRAG DROP
Drag and drop the attributes for the BGP route selection on the left into the correct order on the right. Not all options are used.
Select and Place:
- A. Mastered
- B. Not Mastered
Answer: A
NEW QUESTION 14
Which two characteristics unique to SSM when compared to ASM are true? (Choose two.)
- A. It uses SPT switchover
- B. It uses (*,G) exclusively
- C. It uses IGMPv3
- D. It uses RP
- E. It uses (S,G) exclusively
Answer: CE
NEW QUESTION 15
Refer to the exhibit. R1 is directly connected to R2 and R3. R1 is in BGP AS 123, R2 is in BGP AS 2, and R3 is in BGP AS 3. Assume that there is no connectivity issue between R1, R2 and R1, R3. Which result between BGP peers R1, R2 and R1, R3 is true?
- A. The BGP session does not come up between R1 and R2 and between R1 and R3.
- B. The BGP session comes up between R1 and R2 and between R1 and R3.
- C. The BGP session comes up between R1 and R3, but not between R1 and R2.
- D. The BGP session comes up between R1 and R2, but not between R1 and R3.
Answer: B
NEW QUESTION 16
DRAG DROP
An engineer is troubleshooting end-to-end customer traffic across an MPLS VPN service provider network. Which tasks should the engineer use to solve the routing issues? Drag and drop the table types from the left onto the most useful troubleshooting tasks/router types on the right. (Not all options are used.)
Select and Place:
- A. Mastered
- B. Not Mastered
Answer: A
NEW QUESTION 17
Refer to the exhibit. CE1 is the gateway router into the provider network via PE1. A network operator must inject a default route into OSPF area 0. All devices inside area 0 must be able to reach PE1. Which configuration achieves this goal?
- A.
B.
Answer: B
NEW QUESTION 18
Refer to the exhibit. After troubleshooting an OSPF adjacency issue, routers 1, 2, and 3 have formed OSPF neighbor relationships. Which statement about the configuration is true?
- A. Router 2 receives a Type 5 LSAs from router 1 for its connected subnets
- B. Router 2 uses router 3 as the next hop for 192.168.0.0/24
- C. Router 2 uses router 1 as the next hop for 192.168.0.0/24
- D. Router 2 receives a Type 7 LSAs from router 3 for its connected subnets
Answer: A
NEW QUESTION 19
Which two statements about mapping multicast IP addresses to MAC addresses are true? (Choose two.)
- A. All mapped multicast MAC addresses begin with 0x0100.5E
- B. The router performs the mapping before it hands the packet off to a switch
- C. All multicast MAC addresses end with 0x0100.5E
- D. The mapping process may generate overlapping addresses, which can cause receivers to receive unwanted packets
- E. All destination MAC addresses begin with an octet of binary 1s
Answer: AD
NEW QUESTION 20
What can be used to determine a path from the head-end to a tail-end router when implementing SR-TE with a head-end, with little information on the network topology?
- A. traffic controller
- B. path computation engine
- C. tail-end router
- D. SNMP server
Answer: B
NEW QUESTION 21
Refer to the exhibit. Which LSA type is indicated by this router output?
- A. type 3 LSA
- B. type 4 LSA
- C. type 1 LSA
- D. type 2 LSA
Answer: C
NEW QUESTION 22
......
100% Valid and Newest Version 300-510 Questions & Answers shared by Surepassexam, Get Full Dumps HERE: https://www.surepassexam.com/300-510-exam-dumps.html (New 60 Q&As)