What High Value 350-801 Pdf Exam Is

NEW QUESTION 1
Which Cisco Unified Communications Manager service parameter should be enabled disconnect a multiparty call when the call initiator hangs up?

• A. Drop Ad Hoc Conference
• B. H.225 Black Setup Destination
• C. Block OffNet To OffNet Transfer
• D. Enterprise Feature Access Code for Conference

Answer: A

Explanation:
Reference: https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/admin/10_0_1/ccmsys/CUCM_BK_SE5FCFB6_00_cucm-system-guide-100/CUCM_BK_SE5FCFB6_00_cucm-system-guide- 100_chapter_011000.html#CUCM_TK_DFC66444_00

NEW QUESTION 2
Which command in the MGCP gateway configuration defines the secondary Cisco Unified Communications Manager server?

• A. mgcapp
• B. ccm-manager fallback-mgcp
• C. mgcp call-agent
• D. ccm-manager redundant-host

Answer: B

NEW QUESTION 3
Refer to the exhibit.

This INVITE is sent to an endpoint that only supports G729. What must be done for this call to succeed?

• A. Nothing: both sides support G.729.
• B. Add a transcoder that supports G711ulaw and G.729.
• C. Add a media termination point that supports G.711ulaw and G.729.
• D. Nothing: both sides support payload type 101.

Answer: D

NEW QUESTION 4
What is a characteristic of video traffic that governs QoS requirements for video?

• A. Video is typically variable bit rate.
• B. Voice and video traffic are different, but they have the same QoS requirements.
• C. Video is typically constant bit rate.
• D. Voice and video traffic are the same, so they have the same QoS requirements.

Answer: B

Explanation:
Reference: https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/srnd/collab11/collab11/cac.html

NEW QUESTION 5
When a phone is registered over Mobile and Remote Access, where does it register?

• A. Cisco Unified Presence Server
• B. Expressway-E
• C. Cisco Unified Communications Manager
• D. Expressway-C

Answer: B

Explanation:
Reference: https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/admin/12_0_1/systemConfig/cucm_b_system-configuration-guide-1201/cucm_b_system-configuration-guide-1201_chapter_01011010.html QUESTION

NEW QUESTION 6
Refer to the exhibit.

Endpoint A calls endpoint B. What is the only audio codec that can be used for the call?

• A. Telephone-event/8000
• B. G7221/16000
• C. PCMA/8000
• D. G722/8000

Answer: B

NEW QUESTION 7
An engineer configures local route group to simplify a dial plan. Where does the engineer set the route groups according to the local route group names that are configured?

• A. CSS
• B. route pattern
• C. device pool
• D. route list

Answer: D

NEW QUESTION 8
DRAG DROP
According to the QoS Baseline Model, drag and drop the applications from the left onto the correct Per-Hop Behavior values on the right.

• A. Mastered
• B. Not Mastered

Answer: A

Explanation:

NEW QUESTION 9
Due to provider requirements, outgoing calls from the Enterprise to the PSTN must start with channel 1. Which ISDN command changes the channel selection an IOS to meet this requirement?

• A. isdn bchan-number-order decending
• B. isdn bchan-number-order ascending
• C. isdn protocol-emulate network
• D. isdn incoming-voice voice

Answer: B

NEW QUESTION 10
An engineer is notified that the Cisco TelePresence MX800 that is registered in Cisco Unified Communications Manager shows an empty panel, and the Touch 10 shows a corresponding icon with no action when pressed. Where does the engineer go to remove the inactive custom panel?

• A. The Software Upgrades page in CUCM OS Administration
• B. The In-Room Control Editor on the webpage of the MX800
• C. The phone configuration page in CUCM Administration
• D. The SIP Trunk Security Profile page in CUCM Administration

Answer: A

NEW QUESTION 11
Which endpoint feature is supported using Mobile and Remote Access through Cisco Expressway?

• A. SRST
• B. SSO
• C. H.323 registration proxy to Cisco Unified Communications Manager
• D. MGCP gateway registration

Answer: C

NEW QUESTION 12
An engineer wants to manually deploy a Cisco Webex DX80 video endpoint to an end user. Which type of provisioning can be configured on the endpoint?

• A. CUBE
• B. CMS
• C. CUCM
• D. Edge

Answer: C

Explanation:
Reference: https://www.cisco.com/c/en/us/products/collateral/collaboration-endpoints/desktop-collaboration-experience-dx600-series/datasheet-c78-731879.html

NEW QUESTION 13
What causes poor voice quality and video pixelization in a video call?

• A. The QoS is configured incorrectly.
• B. A firewall is blocking the RTP ports.
• C. Cisco Unified Communications Manager is configured to use G.711 instead of G.729.
• D. 1 Gbps network ports are used instead of 100 Mbps network ports.

Answer: A

NEW QUESTION 14
Which two configuration elements are part of the Cisco Unified Communications Manager toll-fraud prevention? (Choose two.)

• A. SIP trunk security profile
• B. Calling Search Space
• C. SUBSCRIBE Calling Search Space
• D. feature control policy
• E. partition

Answer: BE

NEW QUESTION 15
A network administrator deleted a user from the LDAP directory of a company. The end user shows as Inactive LOAP Synchronized User in Cisco Unified Communications Manager. Which step is next to remove this user from Cisco Unified Communications Manager?

• A. Delete the user directly from Cisco Unified Communications Manager
• B. Restart the Dirsync service after the user is deleted from LDAP directory.
• C. Execute a manual sync to refresh the local database and delete the end user.
• D. Wait 24 hours for the garbage collector to remove the user.

Answer: B

NEW QUESTION 16
Where is the default for Maximum Session Bit Rate for a region configured?

• A. Service Parameter Configuration
• B. Enterprise Phone Configuration
• C. Enterprise Parameters Configuration
• D. Region Configuration

Answer: A

Explanation:
Reference: https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/admin/9_1_1/ccmcfg/CUCM_BK_A34970C5_00_admin-guide-91/CUCM_BK_A34970C5_00_admin-guide-91_chapter_0111.html

NEW QUESTION 17
You are adding regions in Cisco Unified Communications Manager. Which codec(s) are selected when a call is placed if you set up the max audio bit rate to use 8 kbps?

• A. G.729
• B. G 729 and G.711ulaw
• C. G.711ulaw and G 711alaw
• D. G.722

Answer: A

NEW QUESTION 18
An engineer is designing a high availability and failover solution for two Cisco Unified Border Element routers. The first router (cube1.abс.com) takes 60% of the calls and the second router (cube2.abc.com) takes 40% of the calls. Assume all DNS A records have been created. Which two SRV records are needed for a load balanced solution? (Choose two.)

• A. _sip._udp.abc.com 60 IN SRV 2 60 cube1.abc.com
• B. _sip._udp.abc.com 60 IN SRV 60 1 cube1.abc.com
• C. _sip._udp.abc.com 60 IN SRV 1 40 cube2.abc.com
• D. _sip._udp.abc.com 60 IN SRV 3 60 cube2.abc.com
• E. _sip._udp.abc.com 60 IN SRV 1 60 cube1.abc.com

Answer: CE

NEW QUESTION 19
A user dials 9011841234567 to reach Vietnam. Which steps send the call to the PSTN provider as 011841234567?
A.

• A.
• B.
• C.

Answer: A

NEW QUESTION 20
Which two conditions must a user meet to provision a new device using the Self-Provisioning feature? (Choose two.)

• A. The user must have a primary extension.
• B. At least two DNs must be assigned to the user device.
• C. The user must be part of “Standard CCM Super User”.
• D. The user must have the appropriate universal device template linked to the user profile.
• E. The user must have at least user device profile assigned.

Answer: AD

NEW QUESTION 21
Refer to the exhibit.

A call is failing to establish between two SIP Devices The called device answers with this SOP. Which SDP parameter causes this issue?

• A. The payload for G.711ulaw must be 18.
• B. The calling device did not offer a ptime value.
• C. The media stream is set to sendonly.
• D. The RTP port is set to 0.

Answer: D

NEW QUESTION 22
How does Cisco Unified Communications Manager perform a digit analysis on-hook versus off-hook for an outbound call from a Cisco IP phone that is registered to Cisco Unified CM?

• A. On-hook, Unified CM performs a digit-by-digit analysis, off-hook, Unified GM considers all digits were dialed and does not wait for additional digits.
• B. On-hook, Unified CM considers all digits were dialed and does not wait for additional digits, off-hook, Unified CM performs a digit-by-digit analysis.
• C. On-hook, by pressing the digits and entering "#" to process the call, Unified CM performs a digit-by-digit analysis; off-hoo
• D. Unified CM analyzes all digits as a string.
• E. On-hook, no digit analysis is performed, off-hoo
• F. Unified CM requires the “#* to start the digit analysis.

Answer: C

NEW QUESTION 23
A customer is deploying a SIP IOS gateway for a customer who requires that in-band DTMF relay is first priority and out-of-band DTMF relay is second priority. Which IOS entry sets the required priority?

• A. dtmf-relay rtp-nte sip-notify B.dtmf-relay cisco-rtp
• B. sip-notify dtmf-relay rtp-nte
• C. dtmf-relay sip-kpml cisco-rtp

Answer: A

NEW QUESTION 24
......