The Secret of Cisco 352-001 exam dumps

Q1. A Service Provider is designing a solution for a managed CE service to a number of local customers using a single CE platform and wants to have logical separation on the CE platform using Virtual Routing and Forwarding (VRF) based on IP address ranges or packet length. Which is the most scalable solution to provide this type of VRF Selection process on the CE edge device? 

A. Static Routes for Route Leaking 

B. Policy Based Routing 

C. Multi-Protocol BGP 

D. OSPF per VRF Instance 

View Answer

Q2. A company plans to use BFD between its routers to detect a connectivity problem inside the switched network. An IPS is transparently installed between the switches. Which packets should the IPS forward for BFD to work under all circumstances? 

A. IP packets with broadcast IP source addresses 

B. IP packets with identical source and destination IP addresses 

C. fragmented packets with the do-not-fragment bit set 

D. IP packets with the multicast IP source address 

E. IP packets with the multicast IP destination address 

F. IP packets with the destination IP address 0.0.0.0 

View Answer

Q3. Which two statements describe how including Cisco IPoDWDM proactive protection in an optical design would minimize packet loss in the event of a fiber cut? (Choose two). 

A. It uses the FEC field on the OTN frame to trigger protection. 

B. It uses a "not to exceed" predefined BER threshold to cause traffic redirection. 

C. It reroutes the optical circuit after an event that impacts service. 

D. It is effective both when you have redundant and nonredundant Layer 3 MPLS paths. 

View Answer

Q4. You are designing a network that will run EIGRP over a Metro Ethernet service that does not employ a link-loss technology. What will be the impact on convergence if there is a break in the end-to-end Layer 2 connectivity within the service provider network? 

A. The routers will immediately lose their adjacencies and converge. 

B. The routing protocol will not converge until the hold timers have expired. 

C. The switch ports connected to the router will go down and the routers will immediately converge. 

D. The VLAN on the switches will go inactive, the ports associated on the switch will go down, and the routers will immediately converge. 

View Answer

Q5. You are the lead network designer hired by Service Provider XYZ to deploy CoS functionality on the core MPLS network (P routers). The goal of the network design is to provide a complete CoS solution to all customers that purchase services such as dedicated Internet access, MPLS L3VPN, and L2VPN (pseudowire). Service Provider XYZ has these design requirements: 

The network supports four service queues with equal treatment for delay, jitter, and packet loss. 

Queues are numbered 0-3, where 0 is the default queue. 

Three queues have one treatment. 

One queue has either one or two treatments. 

If your design includes eight CoS queues on the Service Provider XYZ MPLS PE router ingress (CE facing) interface, how will customer traffic be classified as it enters the MLS P routers? 

A. The eight CoS queues in the MPLS P router are remapped to the eight CoS queues. 

B. Traffic is classified on the MPLS PE routers on core facing interface. The DSCP value is mapped into EXP field where multiple EXP settings (2+) will be assigned to a single queue throughout the MPLS P routers. 

C. Discard the traffic from the eight CoS queues that does not match the four CoS queues of the MPLS P routers. 

D. The 8 CoS queues in the MPLS P router are remapped to four 4 flow-label queues. 

View Answer

Q6. Refer to the exhibit. 

What limitations exist in this design, given that the access layer devices are expected to steadily increase by two devices per week for the next year? 

A. scalability 

B. serviceability 

C. redundancy 

D. resiliency 

View Answer

Q7. What should be taken into consideration when designing IPsec networks using Authentication Header (AH)? 

A. NAT 

B. transform set 

C. crypto maps 

D. ISAKMP 

View Answer

Q8. Acme Corporation wants to minimize the risk of users plugging unauthorized switches and hubs into the network. Which two features can be used on the LAN access ports to support this design requirement? (Choose two.) 

A. BPDU Guard 

B. PortFast 

C. Loop Guard 

D. Port Security 

E. UDLD 

View Answer

Q9. Refer to the exhibit. 

In the DWDM network, a ring topology carries multiple services between two sites. Which option describes the employed protection design? 

A. Y-cable protection 

B. Splitter protection 

C. Client protection 

D. UDLD 

E. FEC protection 

View Answer

Q10. After the recent implementation of a new design that incorporated GRE tunnels into the network, the network operations staff is seeing the following syslog message in multiple routers on the network - %TUN-5-RECURDOWN: Tunnel0 temporarily disabled due to recursive routing. 

From a design perspective, what was not taken into account prior to implementing the solution? 

A. The neighboring routers cannot respond within the specified hold time. 

B. The interface on the router that is the source of the tunnel is down. 

C. The interface on the neighboring router that is the source of the tunnel is down. 

D. The router is learning the route to the tunnel destination address using the tunnel interface. 

E. The tunnel interface on the router is not receiving any keepalives within the specified hold time. 

View Answer