Your success in Cisco 352-001 is our sole target and we develop all our 352-001 braindumps in a way that facilitates the attainment of this target. Not only is our 352-001 study material the best you can find, it is also the most detailed and the most updated. 352-001 Practice Exams for Cisco CCDE 352-001 are written to the highest standards of technical accuracy.
2026 New 352-001 Exam Dumps with PDF and VCE Free: https://www.2passeasy.com/dumps/352-001/
Q1. After the recent implementation of a new design that incorporated GRE tunnels into the network, the network operations staff is seeing the following syslog message in multiple routers on the network - %TUN-5-RECURDOWN: Tunnel0 temporarily disabled due to recursive routing.
From a design perspective, what was not taken into account prior to implementing the solution?
A. The neighboring routers cannot respond within the specified hold time.
B. The interface on the router that is the source of the tunnel is down.
C. The interface on the neighboring router that is the source of the tunnel is down.
D. The router is learning the route to the tunnel destination address using the tunnel interface.
E. The tunnel interface on the router is not receiving any keepalives within the specified hold time.
Answer: D
Q2. Acme Corporation indicates that their network design must support the ability to scale to support a high number of remote sites. Which IGP is considered to scale better for a hub-and-spoke topology?
A. BGP
B. OSPF
C. IS-IS
D. EIGRP
Answer: D
Q3. Network designers plan to interconnect two geographically separated data centers using an Ethernet-over-MPLS pseudowire. Within that design, the link between the sites is stable, there are no apparent loops in the topology, and the root bridges for the respective VLANs are stable and unchanging. What additional aspect of the design should be adjusted to mitigate the chance of connectivity issues to the peer data center when the connection takes place?
A. Enable 802.1d on one data center, and 802.1w on the other.
B. Ensure that the spanning tree diameter for one or more VLANs is not too large.
C. Enable UDLD on the link between the data centers.
D. Enable root guard on the link between the data centers.
Answer: B
Q4. In a large enterprise network with multiple data centers and thousands of access devices, OSPF is becoming unstable due to link flapping. The current design has the access devices multihomed to large aggregation routers at each of the data centers. How would you redesign the network to improve stability?
A. Add a layer of regional Layer 3 aggregation devices, but leave the ABR function on the data center aggregation routers.
B. Add a layer of regional Layer 2 aggregation devices, but leave the ABR function on the data center aggregation routers.
C. Add a layer of regional Layer 3 aggregation devices and move the ABR function to the regional aggregation device.
D. Add a layer of regional Layer 2 aggregation devices and move the ABR function to the regional aggregation device.
Answer: C
Q5. When designing a large full mesh network running OSPF, how would you reduce LSA repetition?
A. Elect a DR and BDR.
B. Use access control lists to control outbound advertisements.
C. Choose one or two routers to re-flood LSA information.
D. Put each of the point-to-point links in your full mesh networking into a separate area.
Answer: C
Q6. A designer is working with a large bank to redesign their network. The designer wants to minimize complaints regarding slow application response times across the WAN. It is suspected that currently traffic is not being classified and marked correctly somewhere in the network. Which tool should the designer recommend to validate quality of service mappings and use?
A. SNMP
B. IPFIX
C. IP SLA
D. protocol analyzer
E. NBAR
Answer: B
Q7. You are working on a network design plan for a company with approximately 2000 sites. The sites will be connected using the public Internet. You plan to use private IP addressing in the network design, which will be routed without NAT through an encrypted WAN network. Some sites will be connected to the Internet with dynamic public IP addresses, and these addresses may change occasionally. Which VPN solution will support these design requirements?
A. GET VPN must be used, because DMVPN does not scale to 2000 sites.
B. DMVPN must be used, because GET VPN does not scale to 2000 sites.
C. GET VPN must be used, because private IP addresses cannot be transferred with DMVPN through the public Internet.
D. DMVPN must be used, because private IP addresses cannot be transferred with GET VPN through the public Internet.
E. GET VPN must be used, because DMVPN does not support dynamic IP addresses for some sites.
F. DMVPN must be used, because GET VPN does not support dynamic IP addresses for some sites.
Answer: D
Q8. In order to meet your service level agreement, your network designer created a design solution that includes interface dampening. In which two ways will interface dampening benefit your overall network design? (Choose two.)
A. Interface dampening uses an exponential backoff algorithm to suppress event reporting to the upper-level protocols.
B. When the interface is dampened, further link events are not reported to the upper protocol modules.
C. When the interface is dampened, further link events are reported to the upper protocol module.
D. Periodic interface flapping that affects the routing system as a whole should have a period shorter than the system convergence time.
Answer: AB
Q9. You have been tasked to create a Layer 2 network design that uses vPC to provide resiliency and avoid loops. vPC removes Layer 2 loops while providing redundancy through which mechanism?
A. dual-active detection
B. address synchronization
C. strict forwarding rules
D. Bridge Assurance
Answer: C
Q10. AS100 and AS200 each have two peering points in different parts of their network. AS100 would like to use one of the links and keep the other link as backup. What should be changed for the design inside AS100 for prefixes received from AS200?
A. MED
B. weight
C. AS-PATH
D. local preference
Answer: D