Download of 400-051 book materials and faq for Cisco certification for examinee, Real Success Guaranteed with Updated 400-051 pdf dumps vce Materials. 100% PASS CCIE Collaboration exam Today!


2026 New 400-051 Exam Dumps with PDF and VCE Free: https://www.2passeasy.com/dumps/400-051/

P.S. Download 400-051 faq are available on Google Drive, GET MORE: https://drive.google.com/open?id=1AN2bFpCB-qcZP9p7zG0zM-XgNuMP9vne


New Cisco 400-051 Exam Dumps Collection (Question 14 - Question 23)

Q14. Refer to the exhibit.

A collaboration engineer configures Cisco Unified CM location using G.711 and iLBC for each site. The bandwidth for each link is shown. Which two options represent the maximum concurrent number of calls supported from Grand Junction to Casper for each Codec? (Choose two)

A. 20 G.711 calls

B. 18 G.711 calls

C. 36 iLBC calls

D. 42 iLBC calls

E. 11 G.711 calls

F. 51 iLBC calls

Answer: CE


Q15. Refer to the exhibit.

A CUCM engineer is working with Globalization and localization on H323 gateway. Which four configuration changes are needed to achieve the result on the exhibit? (Choose four)

A. Create as CSS and PT for calling party transformation pattern

B. Create a transformation profile and add 9011 in the international number prefix field

C. Assign a transformation profile in the incoming transformation profile setting in the E 164 transformation number prefix field

D. Assign the calling party transformation CSS to the device pools in the cluster

E. Uncheck the use device pool calling party transformation CSS on all the phones

Answer: ABCD


Q16. Refer to the exhibit.

An engineer is trying to provision CUCME with three 8841 phones. However all phone fail to register. Which two changes in the configuration would allow the phones to register? (Choose two)

A. The registrar server command must be added under the voice register global configuration

B. The lP address trusted authenticate command must be added under voice service voip

C. The source-address command must be added under the voice register global configuration

D. The local SlP proxy address must be configuration under the sip-ua configuration

E. The registrar server command must be added under the sip section of voice service voip

Answer: CE


Q17. Which OpenStack component can be used to create on object-based storage strategy?

A. Glance

B. Swift

C. Nova

D. Neutron

Answer: B


Q18. Which two services must be enabled on the routing servers when configuring Partitioned lntradomain

Federation? (Choose two.)

A. Cisco XCP Directory Service

B. Cisco XCP Router

C. Cisco Presence Engine

D. Cisco XCP SlP Federation Connection Manager

E. Cisco XCP Connection Manager

F. Cisco SlP Proxy

Answer: BC


Q19. Refer to the exhibit.

Which two statements about the show command output are true? (Choose two)

A. T1 0/2/1 terminates Q.921 signalling to a Cisco Unified Communications Manager server

B. T1 0/2/1 terminates Q.931 signalling on the gateway

C. T1 0/0/0 terminates Q.931 signalling to a Cisco Unified Communications Manager server

D. T1 0/0/0 terminates SlP signalling to a Cisco Unified Communications Manager server

E. T1 0/0/0 terminates Q.921 signalling on the gateway

Answer: CE


Q20. Which statement about a virtual SNR DN-configured Cisco Unified Communications Manager Express-enabled Cisco lOS router is true?

A. Virtual SNR DN supports either SCCP or SlP lP phone DNs.

B. A virtual SNR DN is a DN that is associated with multiple registered lP phones.

C. Calls in progress can be pulled back from the phone that is associated with the virtual SNR DN.

D. The SNR feature can only be invoked if the virtual SNR DN is associated with at least one registered lP

phone.

E. A call that arrived before a virtual SNR DN is associated with a registered phone, and still exists after association is made, but cannot be answered from the phone.

Answer: E

Explanation:

SCCP: Configuring a Virtual SNR DN

To configure a virtual SNR DN on Cisco Unified SCCP lP phones, perform the following steps.

Prerequisites

Cisco Unified CME 9.0 ora later version.

Restrictions

Virtual SNR DN only supports Cisco Unified SCCP lP phone DNs.

Virtual SNR DN provides no mid-call support.

Mid-calls are either of the following:

- Calls that arrive before the DN is associated with a registered phone and is still present after the DN is associated with the phone.

- Calls that arrive for a registered DN that changes state from registered to virtual and back to registered.

Mid-calls cannot be pulled back, answered, or terminated from the phone associated with the DN.

State of the virtual DN transitions from ringing to hold or remains on hold as a registered DN.

http://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucme/admin/configuration/guide/cmeadm/cmesnr.html#38281


Q21. Refer to the exhibit.

Which three facts can be determined about the audio parameters of this call from this session description protocol? (Choose Three)

A. The DTMF relay will be RFC2833

B. The codec will be G711

C. The codec will be G729

D. VAD will be disabled for this call

E. VAD will be enabled for this call

F. The call will be a T38 fax call

Answer: ACD


Q22. The Video engineer wants to enable the LATM codec to allow video endpoint to communicate over audio with other lP devices. Which two Characteristic should the engineer be aware of before enabling LATM on the Cisco Unified border element router? (Choose two)

A. Dual tone Multifrequency interworking with LATM codec is not supported.

B. Codec transcoding between LATM and other codecs is not supported.

C. SlP UPDATE massage outlined in RFC3311 is not supported.

D. Box-to-Box High availability support feature is not supported.

E. Configure LATM under a voice class or dial peer is not supported.

F. Basic calls using flow-around or flow-through is not supported.

Answer: AB

Explanation:

http://www.cisco.com/c/en/us/td/docs/ios-xml/ios/voice/cube/configuration/cube-book.pdf


Q23. Which three issues prevent a customer from seeing the presence status of a new contact in their Jabber

contact list? (Choose three.)

A. lncoming calling search space on SlP trunk to lM&P

B. lM&P incoming ACL blocking inbound status

C. Subscribe calling search space on SlP trunk to lM&P

D. PC cannot resolve the FQDN of lM&P

E. Owner user lD is not set on device

F. Primary DN is not set in end user configuration for that user

G. Subscriber calling search space is not defined on user's phone

Answer: BCD

Explanation:

No Presence lnformation After Login Problem

You receive no Presence information after login. Solution

Complete these steps in order to resolve this issue:

Make sure that the DNS server the PC is pointed to can resolve the fully qualified name of the CUPS server.

The host entry will not suffice, you must resolve via DNS.

Check the SUBSCRlBE CSS on the SlP trunk to CUP.

This CSS must include the partitions of the devices you are trying to receive status on.

The CUP SlP proxy incoming access control list (ACL) is not allowing incoming SlP presence messages to reach the

presence engine. As a test, set the incoming ACL to ALL and reset the SlP proxy and presence engine. Log in again to

the CUPC and try to reconfigure the incoming ACL properly.

http://www.cisco.com/c/en/us/support/docs/voice-unified-communications/unified-presence/97443-cups-cupc-ts.html


100% Up to the immediate present Cisco 400-051 Questions & Answers shared by Examcollectionplus, Get HERE: https://www.examcollectionplus.net/vce-400-051/ (New 705 Q&As)