Tested CCIE Routing and Switching 400-101 practice test

Q7. When you cpnfigure an IPv6 IPSec tunnel which two fields can represent the ISAKMP identity of a peer?(Choose Jwo)

A. encryption algorithm

B. DH group identifier

C. hostname

D. IPv6 address

View Answer

Q8. Which three conditions must be met for the IP routing state of an interface to be up?(choose three.

A. The interface must have a known IP address

B. Active IP routing must be enabled

C. Cisco express forwarding must be enabled

D. Cisco discovery protocol must be enabled on the inter face

E. A backup interface must be defined

F. The interface line-protocol state must be up

View Answer

Q9. Which effect of configuring the passive-interface S0/0 command under the EIGRP routing process is true?

A. It prevents EIGRP neighbor relationships from being formed over interface S0/0

B. It configures interface S0/0 to send hello packets with the passive-interface bit set

C. It configures interface S0/0 to suppress all outgoingrouting updates

D. It configures_interface S0/0 to reject al-I incoming routing updates

View Answer

Q10. How is a targeted LDP session different from a standard LOP session?

A. Targeted LDP is used only for neighbors on different segments.

B. Targeted LDP requires SDP to be enabled.

C. Targeted LDP requires RSVP to be enabled.

D. Targeted LDP uses unicast hello messages to peer with other devices

View Answer

Q11.

Refer to the exhibit. R1 and R2 have been configured as BGP neighbors, but their session is stuck in active. Which action can you take that will enable a session to beestablished?

A. Enable synchronization on R1 R2

B. Issue the neighbor 10.1.12 .2 activate command on R'1

C. Configure 10.1.12.1 as the BGP router 10 on R1

D. Configure a neighbor relation ship with the Loopback0 address of R1 on R2

View Answer

Q12. Which two statements about SNMP are true?(Choose two.)

A. SNMPv3 uses the SHA encryption algonthm to provide authorization.

B. SNMPv2c can provide authentication as well as encryption.

C. SNMFV3 uses the 3DES encryption algonthm to provide data privacy.

D. The SNMP agent is responsible for collecting data from the MIB

E. The SNMP manager is responsible for collecting data from the MIB.

F. SNMPv2c supports only 32-bit counters

View Answer

Q13. Which option describes how the IP address is assigned when you configure a Layer 3 EtherChannel interface?

A. You must assign the IP address to the tunnel interface.

B. The last IP address added to the EtherChannel is used automatically.

C. You must assign the IP address to a port channel logical interface.

D. The first IP address added to the EtherChannel is used automatically.

View Answer

Q14. QUESTIN TEXT IS NOT AVAILABLE

which three statements about EIGRP and BFD are true ? (choose three.

A. BFD is independent of the routing protocol,so it can be used as a generic failure detection mechanism for EIGRP.

B. Some parts of BFD can be distributed to the data plane,so it can be less CPU-intensive than reduced timers, which exist wholly at the control plane.

C. Reduced EIGRP timers have an absolut minimum detection timer of 1-2 seconds; BFD can provide sub-second failure detection

D. BFD is tied to specific routing protocols and can be used for generic fault detection for the OSPF,EIGRP and BGP routing protocol

E. BFD is dependent on the EIGRP routing protocol,so it can be used as a specific failure detection mechanism

F. BFD resides on the control plane,so it is less CPU-intensive than if it resided on the date plane

View Answer

Q15. Refer to the exhibit.

Which statement is true?

A. The Cisco PfR state is UP; however, the external interface Et0/1 of border router

10.1.1.1 has exceeded the maximum available bandwidth threshold.

B. The Cisco PfR state is UP; however, an issue is preventing the border router from establishing a TCP session to the master controller.

C. The Cisco PfR state is UP and is able to monitor traffic flows; however, MD5 authentication has not been successful between the master controller and the border routers.

D. The Cisco PfR State is UP; however, the receive capacity was not configured for inbound traffic.

E. The Cisco PfR state is UP, and the link utilization out-of-policy threshold is set to 90 percent for traffic exiting the external links.

View Answer

Q16. Refer to the exhibit.

What are two effects of the given configuration?(Choose two)

A. The router will fail to form neighbor adjacencies over all EIGRP interfaces except F0/0

B. The router will fail to form neighbor adjacencies over interface F0/0

C. The router will advertise the 192.168.12.0/27 network

D. The router will manuallu summarize the 192.168.12.0/27 network

E. Auto-summarization will be enabled on the F0/0 interface

View Answer