Ucertify offers free demo for 640-692 exam. "Supporting Cisco routing and Switching Network Devices", also known as 640-692 exam, is a Cisco Certification. This set of posts, Passing the Cisco 640-692 exam, will help you answer those questions. The 640-692 Questions & Answers covers all the knowledge points of the real exam. 100% real Cisco 640-692 exams and revised by experts!
2026 New 640-692 Exam Dumps with PDF and VCE Free: https://www.surepassexam.com/640-692-exam-dumps.html
Q1. Which command sends an echo request packet to the largest host and then waits for an echo response message?
A. telnet
B. connect
C. access
D. echo
E. ping
Answer: E
Q2. Refer to the exhibit.
Into which port do you insert the card?
A. ATM
B. Gigabit Ethernet
C. Serial
D. Ethernet
Answer: B
Q3. What are two features that are associated with single-mode fiber-optic cable? (Choose two.)
A. a single strand of glass fiber
B. carries higher bandwidth than multimode fiber
C. cost is less than multimode fiber
D. operates over less distance than multimode fiber
Answer: AB
Q4. A null modem cable uses which adapter type?
A. RJ-11
B. RJ-45
C. RS-323
D. RS-232
E. USB
Answer: B
Q5. The pins and RJ-45 are numbered from 1 through 8. With the material points of the plug facing toward you, pin 1 is the leftmost pin. Which two sets are looped on an RJ-45 T1 loopback plug? (Choose two)
A. Pins 1 and 4
B. Pins 1 and 7
C. Pins 2 and 5
D. Pins 2 and 8
E. Pins 1 and 5
F. Pins 2 and 7
Answer: AC
Q6. At the interface configuration prompt, which command returns you to the main configuration prompt?
A. Ctrl-Z
B. end
C. exit
D. quit
Answer: C
Q7. What are two ways to open a command prompt session on a Windows-based computer? (Choose two)
A. Click Start > Control Panel > Command Prompt
B. Click Start > All Programs > Accessories > Command Prompt
C. Click Start > All Programs > Command Prompt
D. Click Start > Run. Enter cmd and click OK
E. Click Start > All Programs > Accessories > Communications > Command Prompt
Answer: BD
Q8. Which type of memory stores the decompressed form of the Cisco IOS software and the running configuration?
A. Flash
B. ROM
C. DRAM
D. NVRAM
Answer: C
Q9. Which two commands are used to set the configuration register value? (Choose two)
A. Router(config)#config-register 0x2102
B. Router(config)#confreg 0x2102
C. rommon>config-register 0x2102
D. rommon>confreg 0x2102
E. Router(config)#configuration-register 0x2102
Answer: AD
Q10. Which of the following best describes how to assign a static IP address to the Ethernet port on a computer?
A. From network Connections, click Create a New Connection and follow the network connection Wizard instructions.
B. From Network Connections, double-click Local Area Connection. Click Protocol (TCP/IP). Click the properties, click the use the Following Address button, and then configure the IP information.
C. Click Start> Run Enter cmd and click OK. Enter ip address XXX.XXX.XXX.XXX.
D. From Network Connections, double-click Local Connection. Click Properties, click iPass Protocol (IEEE), click properties and select static IP.
Answer: B