Testking fortinet nse4 exam dumps Questions are updated and all nse4 fortinet answers are verified by experts. Once you have completely prepared with our fortinet nse4 exam prep kits you will be ready for the real fortinet nse4 dumps exam without a problem. We have Abreast of the times Fortinet nse4 fortinet dumps study guide. PASSED fortinet nse4 exam First attempt! Here What I Did.


2026 New NSE4 Exam Dumps with PDF and VCE Free: https://www.2passeasy.com/dumps/NSE4/

Q1. - (Topic 2) 

What is the maximum number of FortiAnalyzer/FortiManager devices a FortiGate unit can be configured to send logs to? 

A. 1 

B. 2 

C. 3 

D. 4 

Answer: C 

Q2. - (Topic 22) 

Which is one of the conditions that must be met for offloading the encryption and decryption of IPsec traffic to an NP6 processor? 

A. No protection profile can be applied over the IPsec traffic. 

B. Phase-2 anti-replay must be disabled. 

C. Both the phase 1 and phases 2 must use encryption algorithms supported by the NP6. 

D. IPsec traffic must not be inspected by any FortiGate session helper. 

Answer: C

Q3. - (Topic 11) 

In the case of TCP traffic, which of the following correctly describes the routing table lookups performed by a FortiGate operating in NAT/Route mode, when searching for a suitable gateway? 

A. A lookup is done only when the first packet coming from the client (SYN) arrives. 

B. A lookup is done when the first packet coming from the client (SYN) arrives, and a second one is performed when the first packet coming from the server (SYN/ACK) arrives. 

C. Three lookups are done during the TCP 3-way handshake (SYN, SYN/ACK, ACK). 

D. A lookup is always done each time a packet arrives, from either the server or the client side. 

Answer: B 

Q4. - (Topic 11) 

A static route is configured for a FortiGate unit from the CLI using the following commands: config router static edit 1 set device "wan1" set distance 20 set gateway 192.168.100.1 next end Which of the following conditions are required for this static default route to be displayed in 

the FortiGate unit’s routing table? (Choose two.) 

A. The administrative status of the wan1 interface is displayed as down. 

B. The link status of the wan1 interface is displayed as up. 

C. All other default routes should have a lower distance. 

D. The wan1 interface address and gateway address are on the same subnet. 

Answer: B,D 

Q5. - (Topic 6) 

An administrator wants to create an IPsec VPN tunnel between two FortiGate devices. 

Which three configuration steps must be performed on both units to support this scenario? (Choose three.) 

A. Create firewall policies to allow and control traffic between the source and destination IP addresses. 

B. Configure the appropriate user groups to allow users access to the tunnel. 

C. Set the operating mode to IPsec VPN mode. 

D. Define the phase 2 parameters. 

E. Define the Phase 1 parameters. 

Answer: A,D,E 

Q6. - (Topic 15) 

Which statement is an advantage of using a hub and spoke IPsec VPN configuration 

instead of a fully-meshed set of IPsec tunnels? 

A. Using a hub and spoke topology provides full redundancy. 

B. Using a hub and spoke topology requires fewer tunnels. 

C. Using a hub and spoke topology uses stronger encryption protocols. 

D. Using a hub and spoke topology requires more routes. 

Answer: B 

Q7. - (Topic 2) 

What logging options are supported on a FortiGate unit? (Choose two.) 

A. LDAP 

B. Syslog 

C. FortiAnalyzer 

D. SNMP 

Answer: B,C 

Q8. - (Topic 11) 

Examine the static route configuration shown below; then answer the question following it. config router static edit 1 set dst 172.20.1.0 255.255.255.0 set device port1 set gateway 172.11.12.1 set distance 10 set weight 5 next edit 2 set dst 172.20.1.0 255.255.255.0 set blackhole enable set distance 5 set weight 10 next end Which of the following statements correctly describes the static routing configuration 

provided? (Choose two.) 

A. All traffic to 172.20.1.0/24 is dropped by the FortiGate. 

B. As long as port1 is up, all traffic to 172.20.1.0/24 is routed by the static route number 1. If the interface port1 is down, the traffic is routed using the blackhole route. 

C. The FortiGate unit does NOT create a session entry in the session table when the traffic is being routed by the blackhole route. 

D. The FortiGate unit creates a session entry in the session table when the traffic is being 

routed by the blackhole route. 

Answer: A,C 

Q9. - (Topic 14) 

In HA, the option Reserve Management Port for Cluster Member is selected as shown in the exhibit below. 

Which statements are correct regarding this setting? (Choose two.) 

A. Interface settings on port7 will not be synchronized with other cluster members. 

B. The IP address assigned to this interface must not overlap with the IP address subnet assigned to another interface. 

C. When connecting to port7 you always connect to the master device. 

D. A gateway address may be configured for port7. 

Answer: A,D 

Q10. - (Topic 1) 

How is the FortiGate password recovery process? 

A. Interrupt boot sequence, modify the boot registry and reboot. After changing the password, reset the boot registry. 

B. Log in through the console port using the “maintainer” account within several seconds of physically power cycling the FortiGate. 

C. Hold down the CTRL + Esc (Escape) keys during reboot, then reset the admin password. 

D. Interrupt the boot sequence and restore a configuration file for which the password has 

been modified. 

Answer: B