Pass4sure offers free demo for 200-150 exam. "DCICN Introducing Cisco Data Center Networking", also known as 200-150 exam, is a Cisco Certification. This set of posts, Passing the Cisco 200-150 exam, will help you answer those questions. The 200-150 Questions & Answers covers all the knowledge points of the real exam. 100% real Cisco 200-150 exams and revised by experts!
2026 New 200-150 Exam Dumps with PDF and VCE Free: https://www.2passeasy.com/dumps/200-150/
Q1. Which two layers of the OSI model are combined in the Internet protocol suite application layer? (Choose two.)
A. 2
B. 3
C. 4
D. 5
E. 6
F. 7
Answer: D,E
Explanation:
http://en.wikipedia.org/wiki/Internet_protocol_suite
Q2. Which command can change the sequence of a router boot process?
A. config-register
B. configuration-register
C. conf-register
D. config-registration
Answer: A
Q3. Refer to the exhibit.
Two Layer 2 Cisco Nexus switches are connected to application servers in a data center. Server A cannot communicate with servers that are in VLANs 3 and 4, but t can communicate with server B and C. What is the cause of the problem?
A. inter VLANs routing is not enabled on both switches
B. Switch I and switch 2 are not physically connected via an access link.
C. A router must be connected to both switches and provide inter VLAN routing.
D. Switch 1 and switch 2 not physically connected via a trunk link.
Answer: C
Q4. Which statement describes the purpose of the MAC address forwarding table of a switch?
A. The switch consults the forwarding table to determine the best route to a destination.
B. The switch consults the forwarding table to determine the output port.
C. The switch consults the forwarding table to determine if the packet is routable.
D. The switch consults the forwarding table to determine if access control permits the packet.
Answer: B
Q5. A network engineer wants to apply for new license key file. Which command should be used to obtain the switch serial number?
A. MDS-A# show license serial-number
B. MDS- A# show running-config | include serial-number
C. MDS- A# show host-id
D. MDS- A# show license host-id
Answer: D
Q6. What two actions can be taken to enable inter-VLAN communications in the data center? (Choose two.)
A. extend Layer 2 services to a Layer 3 capable VLAN using Layer 3 tunneling.
B. use a routing protocol to direct packets into the Layer 2 network
C. connect Layer 2 VLANs together with 802.1Q trunks
D. deploy a router as a Layer 3 services gateway attached inside each Layer 2 VLAN
E. install a Layer 3 capable switch in the data center.
Answer: D,E
Q7. Which address and subnet combination is valid for a host assignment?
A. 172.23.175.210/15
B. 10.100.74.127/25
C. 192.168.73.223/29
D. 10.230.33.15/28
Answer: A
Q8. What is the maximum of fabric modules that can be installed in a Cisco Nexus 7000 chassis?
A. 5
B. 6
C. 4
D. 7
Answer: A
Q9. An engineer is configuring a new MDS switch. The switch is powered on, the customer connects to the console, and the initial setup script is started.
Which two items can be configured during this setup process?
A. default port-channel mode
B. default port VSAN membership
C. default switch port interface state
D. default zone mode
E. default storage VDC
Answer: C,D
Q10. Which two options are multicast addresses? (Choose two.)
A. FD00::2
B. 192.168.2.2
C. FF05::2
D. 226.10.10.10
E. 240.1.0.1
Answer: C,D