Your success in Cisco 200 310 desgn pdf is our sole target and we develop all our 200 310 dumps braindumps in a way that facilitates the attainment of this target. Not only is our ccda 200 310 pdf study material the best you can find, it is also the most detailed and the most updated. ccda 200 310 dump Practice Exams for Cisco CCDA cisco 200 310 are written to the highest standards of technical accuracy.
2026 New 200-310 Exam Dumps with PDF and VCE Free: https://www.2passeasy.com/dumps/200-310/
Q1. When considering the three VoIP design models - single site, centralized multisite, and distributed multisite - which question below would help to eliminate one of the options?
A. Will the switches be required to provide inline power?
B. Will users need to make offsite calls, beyond the enterprise?
C. Will users require applications such as voice mail and interactive voice response?
D. Are there users whose only enterprise access is via a QoS-enabled WAN?
Answer: D
Q2. Which one of these statements is an example of how trust and identity management solutions should be deployed in the enterprise campus network?
A. Authentication validation should be deployed as close to the data center as possible.
B. Use the principle of top-down privilege, which means that each subject should have the privileges that are necessary to perform their defined tasks, as well as all the tasks for those roles below them.
C. Mixed ACL rules, using combinations of specific sources and destinations, should be applied as close to the source as possible.
D. For ease of management, practice defense in isolation - security mechanisms should be in place one time, in one place.
Answer: C
Explanation: Validating user authentication should be implemented as close to the source as possible, with an emphasis on strong authentication for access from untrusted networks. Access rules should enforce policy deployed throughout the network with the following guidelines:
.Source-specific rules with any type destinations should be applied as close to the source as possible.
.Destination-specific rules with any type sources should be applied as close to the destination as possible.
.Mixed rules integrating both source and destination should be used as close to the source as possible.
An integral part of identity and access control deployments is to allow only the necessary access. Highly distributed rules allow for greater granularity and scalability but, unfortunately, increase the management complexity. On the other hand, centralized rule deployment eases management but lacks flexibility and scalability.
Practicing “defense in depth” by using security mechanisms that back each other up is an important concept to understand. For example, the perimeter Internet routers should use ACLs to filter packets in addition to the firewall inspecting packets at a deeper level.
Cisco Press CCDA 640-864 Official Certification Guide Fourth Edition, Chapter 13
Q3. Which three pieces of information should be documented for each step in a design implementation plan? (Choose three.)
A. step description
B. design document references
C. easy guidelines in case of failure
D. estimated implementation time
E. simple implementation guidelines
F. estimated rollback time in case of failure
Answer: A,B,D
Q4. DRAG DROP
Drag the characteristics of the traditional campus network on the left to the most appropriate hierarchical network layer on the right.
Answer:
Q5. What is the most compact representation of the following IPv6 address?
2001:db8:0000:0000:cafe:0000:0000:1234
A. 2001:db8::cafe::1234
B. 2001:db8::cafe:0000:0000:1234
C. 2001:db8:0:0:cafe::1234
D. 2001:db8::cafe:0:1234
Answer: C
Q6. What device virtualization technology allows for a single point of management and a centralized routing instance?
A. ACE
B. VSS
C. VDC
D. VM
Answer: B
Q7. Refer to the exhibit.
A standard Layer 2 campus network design is pictured. Which numbered box represents the core layer?
A. #1
B. #2
C. #3
D. #4
E. #5
Answer: C
Q8. An engineer receives a resource utilization alert on a router. What command should be used to investigate the issue?
A. show processes cpu
B. show memory
C. show running-config
D. show version
Answer: A
Q9. OSPF will be used as the IGP within a campus network. Which two things should you consider before deployment? (Choose two.)
A. All areas need to connect back to area 0.
B. The OSPF process number on each router should match.
C. NSSA areas should be used when an area cannot connect directly to area 0.
D. Stub areas should be connected together using virtual links.
E. ECMP may cause undesired results depending on the environment.
Answer: A,E
Q10. What characteristic separates link state routing protocols from a distance vector?
A. creates a topological view of the entire network
B. path calculation utilizes a more granular metric
C. does not scale well for large networks
D. constantly shares link state updates throughout the topology
Answer: A