Pass4sure ccda 200 310 official cert guide download Questions are updated and all ccda 200 310 official cert guide download answers are verified by experts. Once you have completely prepared with our 200 310 desgn pdf exam prep kits you will be ready for the real ccda 200 310 official cert guide exam without a problem. We have Avant-garde Cisco ccda 200 310 dump dumps study guide. PASSED ccda 200 310 official cert guide download First attempt! Here What I Did.
2026 New 200-310 Exam Dumps with PDF and VCE Free: https://www.2passeasy.com/dumps/200-310/
Q1. Which three types of WAN topologies can be deployed in the Service Provider Module? (Choose three.)
A. ring
B. star
C. full mesh
D. core/edge
E. collapsed core
F. partial mesh
Answer: B,C,F
Q2. Which is the equation used to derive a 64 Kbps bit rate?
A. 2 x 8 kHz x 4-bit code words
B. 8 kHz x 8-bit code words
C. 2 x 4-bit code words x 8 kHz
D. 2 x 4 kHz x 8-bit code words
Answer: D
Q3. A network engineer is attempting to separate routing domains using a virtualization technology. What protocol can be configured to perform this task?
A. VLAN
B. VSAN
C. VRF
D. VPC
Answer: C
Q4. OSPF will be used as the IGP within a campus network. Which two things should you consider before deployment? (Choose two.)
A. All areas need to connect back to area 0.
B. The OSPF process number on each router should match.
C. NSSA areas should be used when an area cannot connect directly to area 0.
D. Stub areas should be connected together using virtual links.
E. ECMP may cause undesired results depending on the environment.
Answer: A,E
Q5. What submodule is found within the Enterprise Edge module?
A. enterprise WAN
B. remote branch
C. campus IPS
D. building distribution
Answer: A
Q6. An organization is conducting an evaluation on the migration to IPv6 within the enterprise network and has requested clarification on recommended migration strategies. What three migration models would accomplish the organization's goal? (Choose three.)
A. Dual Stack
B. Service Block
C. Top-Down
D. Hybrid
E. Tunneled
F. Fork-Lift
Answer: A,B,D
Q7. Which network access control technology is recommended to use with Layer 2 access layer switches?
A. 802.1q
B. 802.1x
C. 802.3af
D. 802.3q
E. 802.11n
Answer: B
Q8. Which WLC interface is dedicated for WLAN client data?
A. virtual interface B. dynamic interface
C. management interface
D. AP manager interface
E. service port interface
Answer: B
Explanation:
WLC Interface Types
A WLC has five interface types:
Management interface (static, configured at setup, mandatory) is used for in-band management, connectivity to AAA, and Layer 2 discovery and association.
Service-port interface (static, configured at setup, optional) is used for out-of-band management. It is an optional interface that is statically configured.
AP manager interface (static, configured at setup, mandatory except for 5508 WLC) is used for Layer 3 discovery and association. It has the source IP address of the AP that is statically configured.
Dynamic interface (dynamic) is analogous to VLANs and is designated for WLAN client data.
Virtual interface (static, configured at setup, mandatory) is used for leaver 3 security authentication, DHCP relay support, and mobility management.
Q9. DRAG DROP
Answer:
Q10. You are tasked with designing a new branch office that will support 75 users with possible expansion in the future and will need a highly available network. Which of the branch design profiles should be implemented?
A. large branch design
B. medium branch design
C. teleworker design
D. small branch design
Answer: B
Explanation:
Medium Branch Design The medium branch design is recommended for branch offices of 50 to 100 users, which is similar to the small branch but with an additional access router in the WAN edge (slightly larger) allowing for redundancy services. Typically, two 2921 or 2951 routers are used to support the WAN, and separate access switches are used to provide LAN connectivity.