Exam Code: ccda 200 310 official cert guide download (Practice Exam Latest Test Questions VCE PDF)
Exam Name: Designing for Cisco Internetwork Solutions
Certification Provider: Cisco
Free Today! Guaranteed Training- Pass 200 310 desgn pdf Exam.
2026 New 200-310 Exam Dumps with PDF and VCE Free: https://www.2passeasy.com/dumps/200-310/
Q1. An enterprise campus module is typically made up of four sub modules, as described by the Cisco Enterprise Architecture Model. Which two sub modules are part of this module?
A. DMZ
B. enterprise branch
C. building distribution
D. server farm/data center
E. MAN
Answer: C,D
Q2. Which three options are valid Cisco STP tools used to ensure best-practice access layer design for the enterprise campus? (Choose three.)
A. Port fast
B. UDLD
C. Root Guard
D. BPDU Guard
E. Flex Links
F. SPAN
G. Ether Channel
Answer: A,C,D
Explanation:
Access layer Limit VLANs to a single closet when possible to provide the most deterministic and highly available topology.
Use RPVST+ if STP is required. It provides the best convergence.
Set trunks to ON and ON with no-negotiate
Manually prune unused VLANs to avoid broadcast propagation.
Use VTP Transparent mode, because there is little need for a common VLAN database in hierarchical networks.
Disable trunking on host ports, because it is not necessary. Doing so provides more security and speeds up Port Fast.
Consider implementing routing in the access layer to provide fast convergence and Layer 3 load balancing.
Use Cisco STP Toolkit, which provides Port Fast, Loop Guard, Root Guard, and BPDU Guard.
Q3. DRAG DROP
Answer:
Q4. Which three protocols support VLSM? (Choose three.)
A. RIPv2
B. RIPv1
C. EIGRP
D. OSPF
E. IGRP
Answer: A,C,D
Q5. Your supervisor has asked you to deploy a routing protocol within the lab environment that will allow for unequal cost multipath routing. Which should you choose?
A. EIGRP
B. OSPF
C. IS-IS
D. RIP
Answer: A
Q6. A hierarchical design of the EIGRP domain facilitates which two of the following? (Choose two.)
A. route summarization
B. faster convergence
C. unequal cost load balancing
D. redistribution
E. virtual links
Answer: A,B
Q7. Which two methods are used to reduce the mesh links required between iBGP peers in the same AS? (Choose two.)
A. community
B. router reflectors
C. local preference
D. confederations
E. atomic aggregate
F. MED
Answer: B,D
Q8. An engineer has configured a router to send level 7 messages to a syslog server. What severity level are these messages?
A. error
B. warning
C. debug
D. informational
E. notice
Answer: C
Q9. A circuit order has been placed for Gigabit Ethernet and is 80KM from the carrier equipment. What type of SFP will be required?
A. TX
B. SX
C. ZX
D. LX
Answer: C
Q10. What is the first step when creating a network security policy?
A. define what should be protected
B. investigate how likely an attack is to occur
C. implement measures to protect assets
D. hire a security firm to perform penetration tests
Answer: A