It is more faster and easier to pass the Cisco 200 310 dumps exam by using Virtual Cisco Designing for Cisco Internetwork Solutions questuins and answers. Immediate access to the Abreast of the times ccda 200 310 pdf Exam and find the same core area ccda 200 310 questions with professionally verified answers, then PASS your exam with a high score now.
2026 New 200-310 Exam Dumps with PDF and VCE Free: https://www.2passeasy.com/dumps/200-310/
Q1. Which first-hop redundancy protocol dynamically distributes client traffic between multiple routers?
A. HSRP
B. VRRP
C. GLBP
D. IGRP
Answer: C
Q2. During which phase of the PPDIOO model would you conduct interviews with supporting staff to develop and propose a viable solution?
A. Prepare
B. Plan
C. Design
D. Implement
E. Operate
F. Optimize
Answer: A
Explanation:
Prepare Phase The Prepare phase establishes organization and business requirements, develops a network strategy, and proposes a high-level conceptual architecture to support the strategy. Technologies that support the architecture are identified. This phase creates a business case to establish a financial justification for a network strategy.
Q3. What is the benefit of VLSM?
A. reduces configuration complexity by using the same subnet mask length
B. reduces the routing table size by using automatic route summarization
C. reduces the routing table size by using manual route summarization
D. allows the subnet mask and classful routing updates to be advertised
E. secures the hosts on a subnet by using RFC 1918 addresses
Answer: C
Q4. Which three options are valid Cisco STP tools used to ensure best-practice access layer design for the enterprise campus? (Choose three.)
A. Port fast
B. UDLD
C. Root Guard
D. BPDU Guard
E. Flex Links
F. SPAN
G. Ether Channel
Answer: A,C,D
Explanation:
Access layer Limit VLANs to a single closet when possible to provide the most deterministic and highly available topology.
Use RPVST+ if STP is required. It provides the best convergence.
Set trunks to ON and ON with no-negotiate
Manually prune unused VLANs to avoid broadcast propagation.
Use VTP Transparent mode, because there is little need for a common VLAN database in hierarchical networks.
Disable trunking on host ports, because it is not necessary. Doing so provides more security and speeds up Port Fast.
Consider implementing routing in the access layer to provide fast convergence and Layer 3 load balancing.
Use Cisco STP Toolkit, which provides Port Fast, Loop Guard, Root Guard, and BPDU Guard.
Q5. When designing a WAN backup for voice and video applications, what three types of connections should be used? (Choose three.)
A. Private WAN
B. internet
C. ISDN
D. MPLS
E. dial-up
F. ATM
G. DSL
Answer: A,C,D
Q6. A network engineer is using the traditional switched hierarchical design. The client has asked to increase uplink utilization from the access layer to the distribution. How can the engineer attain this new requirement without adding new physical connections?
A. enable spanning-tree portfast
B. enable VSS at the distribution layer
C. increase the MTU size on the uplink interfaces
D. ensure the root bridge priority is equal on both distribution switches
Answer: B
Q7. Which three options represents the components of the Teleworker Solution? (Choose three.)
A. Cisco Unified IP Phone
B. Cisco 880 Series Router
C. Aironet Office Extend Access Point
D. Catalyst 3560 Series Switch
E. Cisco 2900 Series Router
F. MPLS Layer 3 VPN
G. Leased lines
Answer: A,B,E
Q8. The evolution of the Data Center is best represented by the 3.0 architecture component of virtualization. Which of the following is not an example of the virtualization taking place in the Data Center?
A. Virtualized media access utilizing Fiber Channel over Ethernet
B. VLANs and virtual storage area networks (VSANs) provide for virtualized LAN and SAN connectivity, separating physical networks and equipment into virtual entities
C. Virtual Machines that run an application within the client operating system, which is further virtualized and running on common hardware
D. Storage devices virtualized into storage pools, and network devices are virtualized using device contexts
Answer: A
Q9. Which protocol is used for voice bearer traffic?
A. MGCP
B. RTP
C. SCCP
D. CDP
E. ICMP
Answer: B
Explanation:
VoIP Control and Transport Protocols
A number of different protocols are used in a VoIP environment for call control, device provisioning, and addressing.
Figure 14-15 shows those protocols focused on VoIP control and transport.
Q10. Where in the network hierarchy should network access control be performed?
A. backbone
B. core
C. access
D. distribution
Answer: C