Real of ccna wireless 200 355 pdf download actual test materials and guidance for Cisco certification for IT specialist, Real Success Guaranteed with Updated 200 355 pdf pdf dumps vce Materials. 100% PASS Implementing Cisco Wireless Network Fundamentals exam Today!


2026 New 200-355 Exam Dumps with PDF and VCE Free: https://www.2passeasy.com/dumps/200-355/

Q1. When using multiple SSIDs on a lightweight AP, how does the traffic of each SSID reach the 802.3 network? 

A. provide routing between them at the core so that the SSIDs can reach the internet 

B. configure 802.11q trunking on the Ethernet switch port that is connected to the AP 

C. configure ACLs at the switch port that will allow all desired SSIDs to pass traffic 

D. configure the SSIDs on the WLC and it will regulate the traffic based on traffic type 

Answer: B 

Q2. Refer to the exhibit. Based on the diagram, what two design requirements must be met? (Choose two.) 

A. WGB is Autonomous 

B. WGB is Universal 

C. WGB can be Autonomous or Universal 

D. Upstream AP is Aironet 

E. Upstream AP is not Aironet 

F. Upstream AP can be any make/model 

Answer: A,D 

Q3. What path displays the current maps within the WCS version 7 GUI? 

A. Monitor > Maps 

B. Reports > Maps 

C. Services > Maps 

D. Administration > Maps 

E. Configure > Maps 

F. Tools > Maps 

Answer: A 

Q4. An engineer has been noticing the power settings on several of the office APs change from day to day ever since two more APs were installed. After logging into the WLC, the engineer verifies that the power levels on 4 of the 802.11n radios are fluctuating up and down. What is the reason for this? 

A. The controller has the APs in H-REAP mode and are on a Layer 2 connection instead of Layer 3. 

B. The RRM has revealed a bad survey and is attempting to power down some of the radios to make up for it. 

C. The WLC has created temporary coverage holes while stepping through power levels for some of the APs. 

D. Several APs have high levels of overlapping coverage in the same area and the WLC is using RRM to correct the cell sizes AP coverage. 

Answer: D 

Q5. When using DHCP option 43, the discovery option supports vendor specific identifiers in order to obtain what IP address? 

A. core router's gateway 

B. closest distribution switch 

C. local WLAN controller 

D. local Radius Server 

Answer: C 

Q6. RAG DROP 

Answer:  

Q7. Which three Cisco Unified Wireless Network capabilities use information that is provided by Radio Resource Management neighbor messages? (Choose three.) 

A. aggressive load balancing 

B. dynamic channel assignment 

C. hybrid remote edge access point 

D. inter controller mobility (that is, mobility groups) 

E. over-the-air provisioning 

F. rogue AP classification 

Answer: B,E,F 

Q8. The results of a Cisco WCS client troubleshooting tool are summarized into a simple visual representation of a four-part progression of the connection status for a wireless client. 

What are the four parts? (Choose four.) 

A. client MAC address 

B. 802.11 authentication 

C. IP address assignment 

D. 802.11 association 

E. successful association 

F. authentication method 

G. SSID 

H. client radio type 

Answer: B,C,D,E 

Q9. Refer to the exhibit. 

You made a manual configuration change to a controller and now you need to compare the controller configuration seen on Cisco WCS to the configuration that is present in the controller. 

Which menu can you use to do compare the configurations? 

A. Reports 

B. Monitor 

C. Configure 

D. Services 

E. Administration 

F. Tools 

Answer: C 

Q10. Refer to the exhibit. 

Which option must be chosen if only the WPA is needed? 

A. WPA+WPA2 

B. Static-WEP + 802.1X 

C. 802.1X 

D. CKIP 

Answer: A