The Regenerate Guide To 300-070 exam dumps

Q1. Which protocol is recommended to be used between Cisco Unified Communications Manager and thevoice gateway to simplify the dial plan? 

A. SIP. 

B. SCCP. 

C. H323. 

D. RSVP. 

E. MGCP. 

View Answer

Q2. Which parameter is required on MCU for ad hoc conferencing? 

A. Media Port reservation 

B. incoming calls to unknown conferences or auto-attendants 

C. DSP reservation for video 

D. MCU type 

E. MCU Conference Bridge SIP Port 

View Answer

Q3. Which configuration output indicates a properly configured T1 digital voice interface? 

A. controller T1 0/0/0 

framing esf 

linecode b8zs 

pri-group timeslots 1-24 

! 

B. isdn switch-type primary-ni 

! 

controller T1 0/0/0 

framing esf 

linecode b8zs 

! 

C. isdn switch-type primary-ni 

! 

controller T1 0/0/0 

framing esf 

linecode b8zs 

pri-group timeslots 1-24 

isdn switch-type primary-ni 

! 

D. isdn switch-type primary-ni 

! 

controller T1 0/0/0 

framing esf 

linecode b8zs 

! 

dial-peer voice 1 pots 

destination-pattern 54…. 

direction-inward.dial 

port 0/0/0:23 

View Answer

Q4. Which type of IOS Conference bridge requires all users to use the same video format in order to participate in a video conference? 

A. Ad Hoc Conferencing 

B. Homogenous Conferencing 

C. HeterogeneousConferencing 

D. Guaranteed Audio Video Conferencing 

E. Meet-Me Conferencing 

View Answer

Q5. The Ajax Corporation is designing an IP telephony network using Cisco MCS 7845 Series 

servers, eachone capable of supporting 7500 devices. The design must meet these requirements: 

-Be cost-effective 

-Support up to 7500 phones 

-Provide a minimal level of redundancy 

A. Two Cisco Unified Communications Manager servers: 

1 publisher and TFTP server combined. 

1 primary subscriber. 

B. Three Cisco Unified Communications Manager servers: 

1 publisher and TFTP server combined. 

1 primary subscriber. 

1 backup subscriber. 

C. Four Cisco Unified Communications Manager servers: 

1 publisher. 

1 TFTP server. 

1 primary subscriber. 

1 backup subscriber. 

D. Five Cisco Unified Communications Manager servers: 

1 publisher. 

1 TFTP server. 

1 primary subscriber. 

2 backup subscribers. 

View Answer

Q6. Refer to the exhibit. 

When users call number 00044156789453, they have to wait for several seconds before the call is sent. Which action sends the call immediately? 

A. In the translation pattern, change the CSS. 

B. In the route pattern, check the Allow Device Override check box. 

C. In the route pattern, check the Urgent Priority check box. 

D. In the translation pattern, check the Route Next Hop By Calling Party Number check box. 

View Answer

Q7. Which statement about translation patterns and transformation patterns is true? 

A. Both transformation patterns and translations patterns support only numeric values. 

B. Both transformation patterns and translations patterns support numeric and alphanumeric values. 

C. Transformation patterns support numeric and alphanumeric values, whereas translations patterns supportonly numeric values. 

D. Translation patterns support numeric and alphanumeric values, whereas transformation patterns supportonly numeric values. 

View Answer

Q8. What is the difference between policing and shaping? 

A. Policing: Transmit and mark, then transmit the packets. Shaping: Buffer the exceeding packets. 

B. Policing: Transmit the packets. Shaping: Buffer the exceeding packets. 

C. Policing: Transmit, drop or mark, then transmit the packets. Shaping: Buffer the exceeding packets. 

D. Policing: Buffer the exceeding packets. Shaping: Transmit and mark, then transmit the packets. 

View Answer

Q9. Where do you configure the region for a group of devices? 

A. Common device profile. 

B. Device defaults. 

C. Common device configuration. 

D. Common phone profile. 

E. Device pool. 

View Answer

Q10. ABC SA de CV is a Company located in New York City and has 3 Branch Offices in Laredo, Bryan, and Houston Texas. The network Administrator has the requirement to configure that all international calls goes out first for Houston Texas, if the GW of Houston goes down then the international call goes out for Bryan Texas and if GW of Bryan goes down, the international call will go out of Laredo Texas. What does the Administrator have to configure to achieve this requirement? 

A. Configure a Route Pattern selecting all possible gateways. 

B. Configure a Line Group for international calls selecting the first option GW of Houston, then Bryan and finally Laredo. After this he has to configure a Hunt List for international calls selecting the Line Group for international calls and finally create the Hunt Pilot for International calls selecting the Hunt List created for international calls. 

C. Configure a New Partition and New CSS for international calls. 

D. Configure a Route Group for international calls selecting the first option GW of Houston, then Bryan and finally Laredo. After this he has to configure a Route List for international calls selecting the Route Group for international calls and finally create the Route Pattern for International calls selecting the Route List created for international calls. 

View Answer