we provide Precise Cisco 300-080 test question which are the best for clearing 300-080 test, and to get certified by Cisco Troubleshooting Cisco IP Telephony and Video. The 300-080 Questions & Answers covers all the knowledge points of the real 300-080 exam. Crack your Cisco 300-080 Exam with latest dumps, guaranteed!


2026 New 300-080 Exam Dumps with PDF and VCE Free: https://www.surepassexam.com/300-080-exam-dumps.html

Q1. Refer to the exhibit. 

When the user tried to configure the command maximum sessions 5 under the dspfarm profile 1, the error shown in the exhibit was reported. Which course of action will resolve this issue? 

A. The maximum conference-participants value must be configured >0. 

B. Ensure that the conference bridge is not registered in Cisco Unified Communications Manager. 

C. The command dsp services dspfarm must be configured under the voice-card configuration. 

D. Configure the dspfarm all command under the voice card. 

Answer: C 

Q2. Which CLI command monitors ILS replication progress? 

A. utils ils findxnode 

B. utils ils show peer info 

C. utils ils showpeerinfo 

D. utils ils lookup 

Answer: C 

Q3. Refer to Exhibit: After reviewing the trace in the exhibit, what was the Directory number of the called party? 

A. 2001 

B. 5010 

C. 1905 

D. 2003 

Answer: D 

Q4. Some users report that they cannot dial out from headquarters on their Cisco IP Phones to PSTN users, but others can. Which troubleshooting approach is the most direct to isolate the source of the failure of the users that cannot dial out to the PSTN? 

A. Use DNA to analyze the dialing permissions of the Cisco IP Phones. 

B. Use DNA to generate actual calls to the PSTN. 

C. Use RTMT to analyze the dialing permissions of the Cisco IP Phones. 

D. Use RTMT to generate actual calls to the PSTN. 

Answer: A 

Q5. Refer to the exhibits. 

Assume that all learned SAF routes are placed in the SAF_Pt partition. An IP phone CSS contains the following partitions in this order: Internal_Pt, SAF_Pt. When the IP phone places a call to 3001, what will occur? 

A. The call will succeed and will be placed via the SAF network. SAF-learned routes always take precedence. 

B. The call will fail because it will be blocked by the route pattern. 

C. The call will be placed in a round-robin fashion between the SAF network and SIP_Trunk. 

D. The call will be placed in a round-robin fashion between the SAF network and SIP_Trunk. Every other call will fail. 

Answer: B 

Q6. Cisco Unified Communications Manager failed to register with the Cisco SAF Forwarder. Assuming that the Cisco IOS SAF Forwarder is configured correctly, which minimum configuration would be needed on Cisco Unified Communications Manager to test registration? 

A. SAF trunk, SAF security profile, Cisco SAF Forwarder, and CCD advertising service 

B. SAF trunk, SAF security profile, Cisco SAF Forwarder, and CCD requesting service 

C. SAF trunk, SAF security profile, Cisco SAF Forwarder, CCD requesting service, and CCD advertising service 

D. SAF trunk, SAF security profile, and Cisco SAF Forwarder 

E. SAF trunk, CCD requesting service, and CCD advertising service 

Answer: B 

Q7. Refer to topology and Exhibits below: Which command can be used to obtain the status of an MGCP gateway from the IOS device, as shown in the given output? 

A. show mgcp registration 

B. show mgcp-gw 

C. show mgcp connection 

D. show ccm-manager 

Answer: D 

Q8. Refer to the exhibit. 

The exhibit shows the output of debug isdn q931. An inbound PSTN call was received by a SIP gateway that is reachable via a SIP trunk that is configured in Cisco Unified Communications Manager. The call failed to ring extension 3001. If the phone at extension 3001 is registered and reachable through the gateway inbound CSS, which three actions can resolve this issue? (Choose three.) 

A. Change the significant digits for inbound calls to 4 on the SIP trunk configuration in Cisco Unified Communications Manager. 

B. Configure the digit strip 4 on the SIP trunk under Incoming Called Party Settings in Cisco Unified Communications Manager. 

C. Configure a translation pattern in Cisco Unified Communications Manager that can be accessed by the trunk CSS to truncate the called number to four digits. 

D. Configure a called-party transformation CSS on the gateway in Cisco Unified Communications Manager that includes a pattern that transforms the number from ten digits to four digits. 

E. Configure a voice translation profile in the SIP Cisco IOS gateway with a voice translation rule that truncates the number from ten digits to four digits. 

F. Configure the Cisco IOS command num-exp 2288223001 3001 on the gateway ISDN interface. 

Answer: A,C,E 

Q9. A user using a CP-9971 SIP phone reports that during a video call, the video portion of the call freezes. What should you do in order to point to and troubleshoot the issue? 

A. Restart the phone. 

B. On the phone, navigate to Administrator Settings > Status > Call Statistics > Video > Video statistics > Rcvr Packets statistics. Verify if the phone is receiving packets. 

C. Make sure that the camera is connected to the USB. 

D. Verify if the camera shutter is open. 

E. Perform a factory reset of the phone. 

Answer: B 

Q10. Refer to the exhibits. 

Assume that all learned SAF routes are placed in the SAF_Pt partition. The 3XXX directory number pattern is being advertised by a remote cluster and is also being blocked by the local cluster that is shown in the exhibit. An IP phone is attached to the local cluster and is configured with a CSS that contains the following partitions: SAF_Pt and Internal_Pt in this order. When the IP phone places a call to 3001, what will occur? 

A. The call will succeed and will be placed via the SIP_Trunk. 

B. The call will fail because it will be blocked by the CCD Blocked Learned Route configuration. 

C. The call will be placed in a round-robin fashion between the SAF network and SIP_Trunk. 

D. The call will placed in a round-robin fashion between the SAF network and SIP_Trunk. Every other call will fail. 

Answer: A