Free of ccnp route 300 101 dumps free exam materials and paper for Cisco certification for IT learners, Real Success Guaranteed with Updated ccnp 300 101 pdf dumps vce Materials. 100% PASS ROUTE Implementing Cisco IP Routing exam Today!
2026 New 300-101 Exam Dumps with PDF and VCE Free: https://www.2passeasy.com/dumps/300-101/
P.S. Free 300-101 paper are available on Google Drive, GET MORE: https://drive.google.com/open?id=1oF6hAYEiseB3LPIXYA2sgTXv0r2MX46d
New Cisco 300-101 Exam Dumps Collection (Question 8 - Question 17)
New Questions 8
Which statement about stateless and stateful IPv6 autoconfiguration are true?
A. Both stateless and stateful autoconfiguration require additional setup
B. Stateless autoconfiguration requires no additional setup, whereas stateful autoconfiguration requires additional setup
C. Stateless autoconfiguration requires additional setup, whereas stateful autoconfiguration requires no additional setup
D. Both stateless and stateful autoconfiguration require no additional setup
Answer: B
New Questions 9
What does the following access list, which is applied on the external interface FastEthernet 1/0 of the perimeter router, accomplish?
router(config)#access-list 101 deny ip 10.0.0.0 0.255.255.255 any log
router (config)#access-list 101 deny ip 192.168.0.0 0.0.255.255 any log
router (config)#access-list 101 deny ip 172.16.0.0 0.15.255.255 any log router (config)#access-list 101 permit ip any any
router (config)#interface fastEthernet 1/0 router (config-if)#ip access-group 101 in
A. It prevents incoming traffic from IP address ranges 10.0.0.0-10.0.0.255, 172.16.0.0- 172.31.255.255, 192.168.0.0-192.168.255.255 and logs any intrusion attempts.
B. It prevents the internal network from being used in spoofed denial of service attacks and logs any exit to the Internet.
C. It filters incoming traffic from private addresses in order to prevent spoofing and logs any intrusion attempts.
D. It prevents private internal addresses to be accessed directly from outside.
Answer: C
New Questions 10
A network engineer needs to verify IP SLA operations on an interface that shows an indication of excessive traffic. Which action use to complete this action?
A. show track
B. show frequency
C. show reachability
D. show threshold
Answer: A
New Questions 11
For security purposes, an IPv6 traffic filter was configured under various interfaces on the local router. However, shortly after implementing the traffic filter, OSPFv3 neighbor adjacencies were lost. What caused this issue?
A. The traffic filter is blocking all ICMPv6 traffic.
B. The global anycast address must be added to the traffic filter to allow OSPFv3 to work properly.
C. The link-local addresses that were used by OSPFv3 were explicitly denied, which caused the neighbor relationships to fail.
D. IPv6 traffic filtering can be implemented only on SVIs.
Answer: C
New Questions 12
The Cisco SA 500 Series Security Appliances are built specifically for businesses with less than 100 employees. What are three important benefits of this device? (Choose three)
A. business-grade firewall
B. premium support via SMART net
C. site-to-site VPN for remote offices
D. Cisco IOS software-based
E. email security
F. XML support
Answer: A,C,E
New Questions 13
Refer to the exhibit.
Which statement is correct regarding the operation of NAT-PT between the IPv4 and IPv6 networks shown?
A. The router will determine the IPv4 destination address.
B. The source IPv6 host can use DNS to determine the IPv6-to-IPv4 address mapping.
C. The host is statically configured with the IPv6-to-IPv4 address mapping.
D. ICMP can be used to determine the IPv6-to-IPv4 address mapping.
Answer: B
New Questions 14
Which two types of authentication does EIGRP offer? (Choose two)
A. TKIP
B. MD5
C. WPA
D. Plain text
Answer: B,D
Explanation: The router uses two types of authentication:
u2711 Simple password authentication (also called plain text authentication)u2014Supported by Integrated System-Integrated System (IS-IS), Open Shortest Path First (OSPF), and Routing Information Protocol Version 2 (RIPv2)
u2711 MD5 authenticationu2014Supported by OSPF, RIPv2, BGP, and EIGRP
New Questions 15
Refer to the exhibit.
After configuring the routes, the network engineer executes the show ip route command. What is the expected results?
A. Gateway of last resort is 10.0.2.1 to network 0.0.0.0 10.0.0.0/24 is subnetted, 2 subnetsC 10.0.2.0 is directly connected, FastEthernet0/0 10.0.1.0 is directly connected, FastEthernet0/1S"0.0.0.0/0 [1/0] via 10.0.2.1(1/0] via 10.0.1.1Router#
B. Gateway of last resort is 10 0.2 1 to network 0 0 00 10 0.0 0/24 is subnetted, 1 subnet C
10.0.2 is directly connected, FastEthernet 0/0 Su201d 0.0.0 0/0 [1/0] via 10.0.2.1 Router #
C. Gateway of last report is not setRouter #
D. Gateway of test resort is 10.0.1.1 to network 0.0.0.0 10.0.0.0/24 is subnetted 1 subnet C
10.0.1.0 is directly connected FastEthernet0/1 Su201d 0.0.0.0/0 [1/0] via 10.0.1.1 Router #
Answer: C
New Questions 16
Which value does a Cisco router use as its default username for CHAP authentication?
A. ppp
B. Cisco
C. its own hostname
D. chap
Answer: C
Explanation: https://www.cisco.com/c/en/us/support/docs/wan/point-to-point-protocol-ppp/25647-understanding-ppp-chap.html
New Questions 17
A network engineer initiates the ip sla responder tcp-connect command in order to gather statistics for performance gauging. Which type of statistics does the engineer see?
A. connectionless-oriented
B. service-oriented
C. connection-oriented
D. application-oriented
Answer: C
Recommend!! Get the Free 300-101 dumps in VCE and PDF From Allfreedumps, Welcome to download: https://www.allfreedumps.com/300-101-dumps.html (New 436 Q&As Version)