Guaranteed of 9tut ccnp switch 300 115 latest exam materials and practice exam for Cisco certification for IT engineers, Real Success Guaranteed with Updated examcollection 300 115 pdf dumps vce Materials. 100% PASS Implementing Cisco IP Switched Networks exam Today!


2026 New 300-115 Exam Dumps with PDF and VCE Free: https://www.2passeasy.com/dumps/300-115/

Q1. Which option describes a limitation of LLDP?

A. LLDP cannot provide information about VTP.

B. LLDP does not support TLVs.

C. LLDP can discover only Windows servers.

D. LLDP can discover up to two devices per port.

Answer: A

Q2. What effect does the mac address-table aging-time 180 command have on the MAC address-table?

A. This is how long a dynamic MAC address will remain in the CAM table.

B. The MAC address-table will be flushed every 3 minutes.

C. The default timeout period will be 360 seconds.

D. ARP requests will be processed less frequently by the switch.

E. The MAC address-table will hold addresses 180 seconds longer than the default of 10 minutes.

Answer: A

Q3. Which technique allows specific VLANs to be strictly permitted by the administrator?

A. VTP pruning

B. transparent bridging

C. trunk allowed VLANs

D. VLAN access-list

E. L2P tunneling

Answer: C

Q4. An access switch has been configured with an EtherChannel port. After configuring SPAN to monitor this port, the network administrator notices that not all traffic is being replicated to the management server. What is a cause for this issue?

A. VLAN filters are required to ensure traffic mirrors effectively.

B. SPAN encapsulation replication must be enabled to capture EtherChannel destination traffic.

C. The port channel can be used as a SPAN source, but not a destination.

D. RSPAN must be used to capture EtherChannel bidirectional traffic.

Answer: C

Q5. Refer to the exhibit.

Which set of configurations will result in all ports on both switches successfully bundling into an EtherChannel?

A. switch1

channel-group 1 mode active switch2

channel-group 1 mode auto

B. switch1

channel-group 1 mode desirable switch2

channel-group 1 mode passive

C. switch1

channel-group 1 mode on switch2

channel-group 1 mode auto

D. switch1

channel-group 1 mode desirable switch2

channel-group 1 mode auto

Answer: D

Q6. After implementing VTP, the extended VLANs are not being propagated to other VTP switches. What should be configured for extended VLANs?

A. VTP does not support extended VLANs and should be manually added to all switches.

B. Enable VTP version 3, which supports extended VLAN propagation.

C. VTP authentication is required when using extended VLANs because of their ability to cause network instability.

D. Ensure that all switches run the same Cisco IOS version. Extended VLANs will not propagate to different IOS versions when extended VLANs are in use.

Answer: B

Q7. Refer to the exhibit.

The users in an engineering department that connect to the same access switch cannot access the network. The network engineer found that the engineering VLAN is missing from the database. Which action resolves this problem?

A. Disable VTP pruning and disable 802.1q.

B. Update the VTP revision number.

C. Change VTP mode to server and enable 802.1q.

D. Enable VTP pruning and disable 802.1q.

Answer: C

Q8. Refer to the exhibit.

Switch A, B, and C are trunked together and have been properly configured for VTP. Switch C receives VLAN information from the VTP server Switch A, but Switch B does not receive any VLAN information. What is the most probable cause of this behavior?

A. Switch B is configured in transparent mode.

B. Switch B is configured with an access port to Switch A, while Switch C is configured with a trunk port to Switch B.

C. The VTP revision number of the Switch B is higher than that of Switch A.

D. The trunk between Switch A and Switch B is misconfigured.

Answer: A

Q9. Which statement describes what happens when a port configured with root guard receives a superior BPDU?

A. The port goes into errdisabled state and stops forwarding traffic.

B. The port goes into BPDU-inconsistent state and stops forwarding traffic.

C. The port goes into loop-inconsistent state and stops forwarding traffic.

D. The port goes into root-inconsistent state and stops forwarding traffic.

Answer: D

Q10. What is the maximum number of VLANs that can be assigned to an access switchport without a voice VLAN?

A. 0

B. 1

C. 2

D. 1024

Answer: B