What Download 300-115 vce Is?

Q1. When you design a switched network using VTPv2, how many VLANs can be used to carry user traffic?

A. 1000

B. 1001

C. 1024

D. 2048

E. 4095

F. 4096

View Answer

Q2. RSPAN has been configured on a Cisco Catalyst switch; however, traffic is not being replicated to the remote switch. Which type of misconfiguration is a cause?

A. The RSPAN designated VLAN is missing the remote span command.

B. The local and remote RSPAN switches are configured using different session IDs.

C. The local RSPAN switch is replicating only Rx traffic to the remote switch.

D. The local switch is overloaded with the amount of sourced traffic that must be replicated to the remote switch.

View Answer

Q3. while doing network discovery using Cisco Discovery Protocol, it is found that rapid error tracking is not currently enabled. Which option must be enabled to allow for enhanced reporting mechanisms using Cisco Discovery Protocol?

A. Cisco Discovery Protocol version 2

B. Cisco IOS Embedded Event Manager

C. logging buffered

D. Cisco Discovery Protocol source interface

E. Cisco Discovery Protocol logging options

View Answer

Q4. Refer to the exhibit.

How many bytes are added to each frame as a result of the configuration?

A. 4-bytes except the native VLAN

B. 8-bytes except the native VLAN

C. 4-bytes including native VLAN

D. 8-bytes including native VLAN

View Answer

Q5. Which type of information does the DHCP snooping binding database contain?

A. untrusted hosts with leased IP addresses

B. trusted hosts with leased IP addresses

C. untrusted hosts with available IP addresses

D. trusted hosts with available IP addresses

View Answer

Q6. What is the function of NSF?

A. forward traffic simultaneously using both supervisors

B. forward traffic based on Cisco Express Forwarding

C. provide automatic failover to back up supervisor in VSS mode

D. provide nonstop forwarding in the event of failure of one of the member supervisors

View Answer

Q7. Refer to the exhibit.

A network engineer investigates a recent network failure and notices that one of the interfaces on the switch is still down. What is causing the line protocol on this interface to be shown as down?

A. There is a layer 1 physical issue.

B. There is a speed mismatch on the interface.

C. The interface is configured as the target of the SPAN session.

D. The interface is configured as the source of the SPAN session.

E. There is a duplex mismatch on the interface.

View Answer

Q8. After reviewing UDLD status on switch ports, an engineer notices that the." Which statement describes what this indicates about the status of the port?

A. The port is fully operational and no known issues are detected.

B. The bidirectional status of "unknown" indicates that the port will go into the disabled state because it stopped receiving UDLD packets from its neighbor.

C. UDLD moved into aggressive mode after inconsistent acknowledgements were detected.

D. The UDLD port is placed in the "unknown" state for 5 seconds until the next UDLD packet is received on the interface.

View Answer

Q9. What effect does the mac address-table aging-time 180 command have on the MAC address-table?

A. This is how long a dynamic MAC address will remain in the CAM table.

B. The MAC address-table will be flushed every 3 minutes.

C. The default timeout period will be 360 seconds.

D. ARP requests will be processed less frequently by the switch.

E. The MAC address-table will hold addresses 180 seconds longer than the default of 10 minutes.

View Answer

Q10. On which interface can port security be configured?

A. static trunk ports

B. destination port for SPAN

C. EtherChannel port group

D. dynamic access point

View Answer