Vivid of 300 115 switch question materials and resource for Cisco certification for IT learners, Real Success Guaranteed with Updated ccnp switch 300 115 pdf dumps vce Materials. 100% PASS Implementing Cisco IP Switched Networks exam Today!


2026 New 300-115 Exam Dumps with PDF and VCE Free: https://www.2passeasy.com/dumps/300-115/

Q1. To follow the Layer 2 switching guidelines, a network engineer decides to create a separate spanning tree for every group of 10 VLANs. Which version of spanning tree is appropriate to meet the company policy?

A. MST

B. PVST+

C. RSTP

D. RPVST+

E. STP

Answer: A

Q2. Which statement about LLDP-MED is true?

A. LLDP-MED is an extension to LLDP that operates between endpoint devices and network devices.

B. LLDP-MED is an extension to LLDP that operates only between network devices.

C. LLDP-MED is an extension to LLDP that operates only between endpoint devices.

D. LLDP-MED is an extension to LLDP that operates between routers that run BGP.

Answer: A

Q3. Refer to the exhibit.

Which set of configurations will result in all ports on both switches successfully bundling into an EtherChannel?

A. switch1

channel-group 1 mode active switch2

channel-group 1 mode auto

B. switch1

channel-group 1 mode desirable switch2

channel-group 1 mode passive

C. switch1

channel-group 1 mode on switch2

channel-group 1 mode auto

D. switch1

channel-group 1 mode desirable switch2

channel-group 1 mode auto

Answer: D

Q4. Which private VLAN access port belongs to the primary VLAN and can communicate with all interfaces, including the community and isolated host ports?

A. promiscuous port

B. isolated port

C. community port

D. trunk port

Answer: A

Q5. Which gateway role is responsible for answering ARP requests for the virtual IP address in GLBP?

A. active virtual forwarder

B. active virtual router

C. active virtual gateway

D. designated router

Answer: C

Q6. Which command configures an HSRP group to become a slave of another HSRP group?

A. standby slave

B. standby group track

C. standby follow

D. standby group backup

Answer: C

Q7. After an EtherChannel is configured between two Cisco switches, interface port channel 1 is in the down/down state. Switch A is configured with channel-group 1 mode active, while Switch B is configured with channel-group 1 mode desirable. Why is the EtherChannel bundle not working?

A. The switches are using mismatched EtherChannel negotiation modes.

B. The switch ports are not configured in trunking mode.

C. LACP priority must be configured on both switches.

D. The channel group identifier must be different for Switch A and Switch B.

Answer: A

Q8. Which action allows a network engineer to limit a default VLAN from being propagated across all trunks?

A. Upgrade to VTP version 3 for advanced feature set support.

B. Enable VTP pruning on the VTP server.

C. Manually prune default VLAN with switchport trunk allowed vlans remove.

D. Use trunk pruning vlan 1.

Answer: C

Q9. What is the default value for the errdisable recovery interval in a Cisco switch?

A. 30 seconds

B. 100 seconds

C. 300 seconds

D. 600 seconds

Answer: C

Q10. Which statement describes what happens when a port configured with root guard receives a superior BPDU?

A. The port goes into errdisabled state and stops forwarding traffic.

B. The port goes into BPDU-inconsistent state and stops forwarding traffic.

C. The port goes into loop-inconsistent state and stops forwarding traffic.

D. The port goes into root-inconsistent state and stops forwarding traffic.

Answer: D