Pass4sure offers free demo for examcollection 300 115 exam. "Implementing Cisco IP Switched Networks", also known as ccnp switch 300 115 pdf exam, is a Cisco Certification. This set of posts, Passing the Cisco 300 115 dumps exam, will help you answer those questions. The cbt nuggets ccnp switch 300 115 download Questions & Answers covers all the knowledge points of the real exam. 100% real Cisco ccnp 300 115 exams and revised by experts!


2026 New 300-115 Exam Dumps with PDF and VCE Free: https://www.2passeasy.com/dumps/300-115/

Q1. What is the default HSRP priority?

A. 50

B. 100

C. 120

D. 1024

Answer: B

Q2. DHCP snooping and IP Source Guard have been configured on a switch that connects to several client workstations. The IP address of one of the workstations does not match any entries found in the DHCP binding database. Which statement describes the outcome of this scenario?

A. Packets from the workstation will be rate limited according to the default values set on the switch.

B. The interface that is connected to the workstation in question will be put into the errdisabled state.

C. Traffic will pass accordingly after the new IP address is populated into the binding database.

D. The packets originating from the workstation are assumed to be spoofed and will be discarded.

Answer: D

Q3. Which statement describes what happens when a switch enters dual active recovery mode?

A. The switch shuts down and waits for the VSL link to be restored before sending traffic.

B. All interfaces are shut down in the formerly active virtual switch member, but the new active virtual switch forwards traffic on all links.

C. The switch continues to forward traffic out all links and enables spanning tree on VSL link and all other links to prevent loops.

D. The VSS detects which system was last in active state and shuts down the other switch.

Answer: B

Q4. Which feature describes MAC addresses that are dynamically learned or manually configured, stored in the address table, and added to the running configuration?

A. sticky

B. dynamic

C. static

D. secure

Answer: A

Q5. Refer to the exhibit.

Which option describes the reason for this message in a GLBP configuration?

A. Unavailable GLBP active forwarder

B. Incorrect GLBP IP address

C. HSRP configured on same interface as GLBP

D. Layer 2 loop

Answer: D

Q6. Refer to the exhibit.

When a network administrator is attempting an SSH connection to the device, in which order does the device check the login credentials?

A. RADIUS server, local username, line password

B. RADIUS server, line password, local username

C. Line password, local username, RADIUS server

D. Line password, RADIUS server, local username

Answer: A

Q7. Which command creates a login authentication method named "login" that will primarily use RADIUS and fail over to the local user database?

A. (config)# aaa authentication login default radius local

B. (config)# aaa authentication login login radius local

C. (config)# aaa authentication login default local radius

D. (config)# aaa authentication login radius local

Answer: B

Q8. Which gateway role is responsible for answering ARP requests for the virtual IP address in GLBP?

A. active virtual forwarder

B. active virtual router

C. active virtual gateway

D. designated router

Answer: C

Q9. After reviewing UDLD status on switch ports, an engineer notices that the." Which statement describes what this indicates about the status of the port?

A. The port is fully operational and no known issues are detected.

B. The bidirectional status of "unknown" indicates that the port will go into the disabled state because it stopped receiving UDLD packets from its neighbor.

C. UDLD moved into aggressive mode after inconsistent acknowledgements were detected.

D. The UDLD port is placed in the "unknown" state for 5 seconds until the next UDLD packet is received on the interface.

Answer: A

Q10. A server with a statically assigned IP address is attached to a switch that is provisioned for DHCP snooping. For more protection against malicious attacks, the network team is considering enabling dynamic ARP inspection alongside DHCP snooping. Which solution ensures that the server maintains network reachability in the future?

A. Disable DHCP snooping information option.

B. Configure a static DHCP snooping binding entry on the switch.

C. Trust the interface that is connected to the server with the ip dhcp snooping trust command.

D. Verify the source MAC address of all untrusted interfaces with ip dhcp snooping verify mac-address command.

Answer: B