Actual of 300-207 simulations materials and preparation for Cisco certification for customers, Real Success Guaranteed with Updated 300-207 pdf dumps vce Materials. 100% PASS Implementing Cisco Threat Control Solutions (SITCS) exam Today!


2026 New 300-207 Exam Dumps with PDF and VCE Free: https://www.2passeasy.com/dumps/300-207/

Q1. Which three features does Cisco CX provide? (Choose three.) 

A. HTTPS traffic decryption and inspection 

B. Application Visibility and Control 

C. Category or reputation-based URL filtering 

D. Email virus scanning 

E. Application optimization and acceleration 

F. VPN authentication 

Answer: A,B,C 

Q2. The security team needs to limit the number of e-mails they receive from the Intellishield Alert Service. Which three parameters can they adjust to restrict alerts to specific product sets? (Choose three.) 

A. Vendor 

B. Chassis/Module 

C. Device ID 

D. Service Contract 

E. Version/Release 

F. Service Pack/Platform 

Answer: A,E,F 

Q3. What action will the sensor take regarding IP addresses listed as known bad hosts in the Cisco SensorBase network? 

A. Global correlation is configured in Audit mode fortesting the feature without actually denying any hosts. 

B. Global correlation is configured in Aggressive mode, which has a very aggressive effect on deny actions. 

C. It will not adjust risk rating values based on the known bad hosts list. 

D. Reputation filtering is disabled. 

Answer: D 

Explanation: 

This can be seen on the Globabl Correlation – Inspection/Reputation tab show below: 

Q4. Which two practices are recommended for implementing NIPS at enterprise Internet edges? (Choose two.) 

A. Integrate sensors primarily on the more trusted side of the firewall (inside or DMZ interfaces). 

B. Integrate sensors primarily on the less trusted side of the firewall (outside interfaces). 

C. Implement redundant IPS and make data paths symmetrical. 

D. Implement redundant IPS and make data paths asymmetrical. 

E. Use NIPS only for small implementations. 

Answer: A,C 

Q5. Which Cisco technology combats viruses and malware with virus outbreak filters that are downloaded from Cisco SenderBase? 

A. ASA 

B. WSA 

C. Secure mobile access 

D. IronPort ESA 

E. SBA 

Answer: D 

Q6. Which sensor deployment mode does Cisco recommend when interface capacity is limited and you need to increase sensor functionality? 

A. inline interface pair mode 

B. inline VLAN pair mode 

C. inline VLAN group mode 

D. VLAN group mode 

Answer: C 

Q7. Which role does Passive Identity Management play in the Cisco Cloud Web Security architecture? 

A. It provides user-level information that is received from Active Directory. 

B. It enables the administrator to control web access for users and user groups. 

C. It defines a standard for exchanging authentication and authorization data. 

D. It controls content that passes into and out of the network. 

Answer: A 

Q8. Which command is used to enable strong ciphers on the Cisco Web Security Appliance? 

A. interfaceconfig 

B. strictssl 

C. etherconfig 

D. adminaccessconfig 

Answer: B 

Q9. How does a user access a Cisco Web Security Appliance for initial setup? 

A. Connect the console cable and use the terminal at 9600 baud to run the setup wizard. 

B. Connect the console cable and use the terminal at 115200 baud to run the setup wizard. 

C. Open the web browser at 192.168.42.42:8443 for the setup wizard over https. 

D. Open the web browser at 192.168.42.42:443 for the setup wizard over https. 

Answer: C 

Q10. Which three statements about Cisco CWS are true? (Choose three.) 

A. It provides protection against zero-day threats. 

B. Cisco SIO provides it with threat updates in near real time. 

C. It supports granular application policies. 

D. Its Roaming User Protection feature protects the VPN from malware and data breaches. 

E. It supports local content caching. 

F. Its Cognitive Threat Analytics feature uses cloud-based analysis and detection to block threats outside the network. 

Answer: A,B,C