Want to know Examcollection 300-209 Exam practice test features? Want to lear more about Cisco Implementing Cisco Secure Mobility Solutions (SIMOS) certification experience? Study Certified Cisco 300-209 answers to Abreast of the times 300-209 questions at Examcollection. Gat a success with an absolute guarantee to pass Cisco 300-209 (Implementing Cisco Secure Mobility Solutions (SIMOS)) test on your first attempt.
2026 New 300-209 Exam Dumps with PDF and VCE Free: https://www.2passeasy.com/dumps/300-209/
Q1. The following configuration steps have been completeD.
. WebVPN was enabled on the ASA outside interface.
. SSL VPN client software was loaded to the ASA.
. A DHCP scope was configured and applied to a WebVPN Tunnel Group.
What additional step is required if the client software fails to load when connecting to the ASA SSL page?
A. The SSL client must be loaded to the client by an ASA administrator
B. The SSL client must be downloaded to the client via FTP
C. The SSL VPN client must be enabled on the ASA after loading
D. The SSL client must be enabled on the client machine before loading
Answer: C
Q2. Where do you configure AnyConnect certificate-based authentication in ASDM?
A. group policies
B. AnyConnect Connection Profile
C. AnyConnect Client Profile
D. Advanced Network (Client) Access
Answer: B
Q3. Scenario:
You are the senior network security administrator for your organization. Recently and junior engineer configured a site-to-site IPsec VPN connection between your headquarters Cisco ASA and a remote branch office.
You are now tasked with verifying the IKEvl IPsec installation to ensure it was properly configured according to designated parameters. Using the CLI on both the Cisco ASA and branch ISR, verify the IPsec configuration is properly configured between the two sites.
NOTE: the show running-config command cannot be used for this exercise.
Topology:
In what state is the IKE security association in on the Cisco ASA?
A. There are no security associations in place
B. MM_ACTIVE
C. ACTIVE(ACTIVE)
D. QM_IDLE
Answer: B
Explanation:
This can be seen from the "show crypto isa sa" command:
Q4. Refer to the exhibit.
Which exchange does this debug output represent?
A. IKE Phase 1
B. IKE Phase 2
C. symmetric key exchange
D. certificate exchange
Answer: A
Q5. Refer to the exhibit.
Which action is demonstrated by this debug output?
A. NHRP initial registration by a spoke.
B. NHRP registration acknowledgement by the hub.
C. Disabling of the DMVPN tunnel interface.
D. IPsec ISAKMP phase 1 negotiation.
Answer: A
Q6. Refer to the exhibit.
The network administrator is adding a new spoke, but the tunnel is not passing traffic. What
could cause this issue?
A. DMVPN is a point-to-point tunnel, so there can be only one spoke.
B. There is no EIGRP configuration, and therefore the second tunnel is not working.
C. The NHRP authentication is failing.
D. The transform set must be in transport mode, which is a requirement for DMVPN.
E. The NHRP network ID is incorrect.
Answer: C
Reference:
http://www.cisco.com/c/en/us/td/docs/ios/12_4/ip_addr/configuration/guide/hadnhrp.html#w p1055049
Q7. Refer to the exhibit.
Which statement about the given IKE policy is true?
A. The tunnel will be valid for 2 days, 88 minutes, and 00 seconds.
B. It will use encrypted nonces for authentication.
C. It has a keepalive of 60 minutes, checking every 5 minutes.
D. It uses a 56-bit encryption algorithm.
Answer: B
Q8. Which Cisco ASDM option configures WebVPN access on a Cisco ASA?
A. Configuration > WebVPN > WebVPN Access
B. Configuration > Remote Access VPN > Clientless SSL VPN Access
C. Configuration > WebVPN > WebVPN Config
D. Configuration > VPN > WebVPN Access
Answer: B
Q9. Which benefit of FlexVPN is not offered by DMVPN using IKEv1?
A. Dynamic routing protocols can be configured.
B. IKE implementation can install routes in routing table.
C. GRE encapsulation allows for forwarding of non-IP traffic.
D. NHRP authentication provides enhanced security.
Answer: B
Q10. A company has decided to migrate an existing IKEv1 VPN tunnel to IKEv2. Which two are valid configuration constructs on a Cisco IOS router? (Choose two.)
A. crypto ikev2 keyring keyring-name
peer peer1
address 209.165.201.1 255.255.255.255
pre-shared-key local key1
pre-shared-key remote key2
B. crypto ikev2 transform-set transform-set-name
esp-3des esp-md5-hmac
esp-aes esp-sha-hmac
C. crypto ikev2 map crypto-map-name
set crypto ikev2 tunnel-group tunnel-group-name
set crypto ikev2 transform-set transform-set-name
D. crypto ikev2 tunnel-group tunnel-group-name
match identity remote address 209.165.201.1
authentication local pre-share
authentication remote pre-share
E. crypto ikev2 profile profile-name
match identity remote address 209.165.201.1
authentication local pre-share
authentication remote pre-share
Answer: A,E