Precise of 300-209 exam prep materials and software for Cisco certification for IT learners, Real Success Guaranteed with Updated 300-209 pdf dumps vce Materials. 100% PASS Implementing Cisco Secure Mobility Solutions (SIMOS) exam Today!


2026 New 300-209 Exam Dumps with PDF and VCE Free: https://www.2passeasy.com/dumps/300-209/

Q1. Which feature enforces the corporate policy for Internet access to Cisco AnyConnect VPN users? 

A. Trusted Network Detection 

B. Datagram Transport Layer Security 

C. Cisco AnyConnect Customization 

D. banner message 

Answer: A 

Q2. Which algorithm is replaced by elliptic curve cryptography in Cisco NGE? 

A. 3DES 

B. AES 

C. DES 

D. RSA 

Answer: D 

Q3. Refer to the exhibit. 

Which technology is represented by this configuration? 

A. AAA for FlexVPN 

B. AAA for EzVPN 

C. TACACS+ command authorization 

D. local command authorization 

Answer: A 

Q4. Which option describes the purpose of the shared argument in the DMVPN interface command tunnel protection IPsec profile ProfileName shared? 

A. shares a single profile between multiple tunnel interfaces 

B. allows multiple authentication types to be used on the tunnel interface 

C. shares a single profile between a tunnel interface and a crypto map 

D. shares a single profile between IKEv1 and IKEv2 

Answer: A 

Q5. What is the Cisco recommended TCP maximum segment on a DMVPN tunnel interface when the MTU is set to 1400 bytes? 

A. 1160 bytes 

B. 1260 bytes 

C. 1360 bytes 

D. 1240 bytes 

Answer: C 

Q6. Which two types of authentication are supported when you use Cisco ASDM to configure site-to-site IKEv2 with IPv6? (Choose two.) 

A. preshared key 

B. webAuth 

C. digital certificates 

D. XAUTH 

E. EAP 

Answer: A,C 

Q7. Which equation describes an elliptic curve? 

A. y3 = x3 + ax + b 

B. x3 = y2 + ab + x 

C. y4 = x2 + ax + b 

D. y2 = x3 + ax + b 

E. y2 = x2 + ax + b2 

Answer: D 

Q8. Refer to the exhibit. 

The network administrator is adding a new spoke, but the tunnel is not passing traffic. What 

could cause this issue? 

A. DMVPN is a point-to-point tunnel, so there can be only one spoke. 

B. There is no EIGRP configuration, and therefore the second tunnel is not working. 

C. The NHRP authentication is failing. 

D. The transform set must be in transport mode, which is a requirement for DMVPN. 

E. The NHRP network ID is incorrect. 

Answer: C 

Reference: 

http://www.cisco.com/c/en/us/td/docs/ios/12_4/ip_addr/configuration/guide/hadnhrp.html#w p1055049 

Q9. Which three parameters must match on all routers in a DMVPN Phase 3 cloud? (Choose three.) 

A. NHRP network ID 

B. GRE tunnel key 

C. NHRP authentication string 

D. tunnel VRF 

E. EIGRP process name 

F. EIGRP split-horizon setting 

Answer: A,B,C 

Q10. The following configuration steps have been completeD. 

. WebVPN was enabled on the ASA outside interface. 

. SSL VPN client software was loaded to the ASA. 

. A DHCP scope was configured and applied to a WebVPN Tunnel Group. 

What additional step is required if the client software fails to load when connecting to the ASA SSL page? 

A. The SSL client must be loaded to the client by an ASA administrator 

B. The SSL client must be downloaded to the client via FTP 

C. The SSL VPN client must be enabled on the ASA after loading 

D. The SSL client must be enabled on the client machine before loading 

Answer: C