Master the 300-209 Implementing Cisco Secure Mobility Solutions (SIMOS) content and be ready for exam day success quickly with this Exambible 300-209 free exam. We guarantee it!We make it a reality and give you real 300-209 questions in our Cisco 300-209 braindumps.Latest 100% VALID Cisco 300-209 Exam Questions Dumps at below page. You can use our Cisco 300-209 braindumps and pass your exam.
2026 New 300-209 Exam Dumps with PDF and VCE Free: https://www.2passeasy.com/dumps/300-209/
Q1. You are troubleshooting a site-to-site VPN issue where the tunnel is not establishing. After issuing the debug crypto isakmp command on the headend router, you see the following output. What does this output suggest?
1d00h: ISAKMP (0:1): atts are not acceptable. Next payload is 0
1d00h: ISAKMP (0:1); no offers accepted!
1d00h: ISAKMP (0:1): SA not acceptable!
1d00h: %CRYPTO-6-IKMP_MODE_FAILURE. Processing of Main Mode failed with peer at 10.10.10.10
A. Phase 1 policy does not match on both sides.
B. The transform set does not match on both sides.
C. ISAKMP is not enabled on the remote peer.
D. There is a mismatch in the ACL that identifies interesting traffic.
Answer: A
Q2. In FlexVPN, what is the role of a NHRP resolution request?
A. It allows these entities to directly communicate without requiring traffic to use an intermediate hop
B. It dynamically assigns VPN users to a group
C. It blocks these entities from to directly communicating with each other
D. It makes sure that each VPN spoke directly communicates with the hub
Answer: A
Q3. Which NGE IKE Diffie-Hellman group identifier has the strongest cryptographic properties?
A. group 10
B. group 24
C. group 5
D. group 20
Answer: D
Q4. Which interface is managed by the VPN Access Interface field in the Cisco ASDM IPsec Site-to-Site VPN Wizard?
A. the local interface named "VPN_access"
B. the local interface configured with crypto enable
C. the local interface from which traffic originates
D. the remote interface with security level 0
Answer: B
Q5. Which statement is true when implementing a router with a dynamic public IP address in a crypto map based site-to-site VPN?
A. The router must be configured with a dynamic crypto map.
B. Certificates are always used for phase 1 authentication.
C. The tunnel establishment will fail if the router is configured as a responder only.
D. The router and the peer router must have NAT traversal enabled.
Answer: C
Q6. Which three plugins are available for clientless SSL VPN? (Choose three.)
A. CIFS
B. RDP2
C. SSH
D. VNC
E. SQLNET
F. ICMP
Answer: B,C,D
Q7. CORRECT TEXT
Answer: Here are the steps as below:
Step 1: configure key ring
crypto ikev2 keyring mykeys
peer SiteB.cisco.com
address 209.161.201.1
pre-shared-key local $iteA
pre-shared key remote $iteB
Step 2: Configure IKEv2 profile
Crypto ikev2 profile default
identity local fqdn SiteA.cisco.com
Match identity remote fqdn SiteB.cisco.com
Authentication local pre-share
Authentication remote pre-share
Keyring local mykeys
Step 3: Create the GRE Tunnel and apply profile
crypto ipsec profile default
set ikev2-profile default
Interface tunnel 0
ip address 10.1.1.1 255.255.255.0
Tunnel source eth 0/0
Tunnel destination 209.165.201.1
tunnel protection ipsec profile default
end
Q8. Which two examples of transform sets are contained in the IKEv2 default proposal? (Choose two.)
A. aes-cbc-192, sha256, 14
B. 3des, md5, 5
C. 3des, sha1, 1
D. aes-cbc-128, sha, 5
Answer: B,D
Q9. Where do you configure AnyConnect certificate-based authentication in ASDM?
A. group policies
B. AnyConnect Connection Profile
C. AnyConnect Client Profile
D. Advanced Network (Client) Access
Answer: B
Q10. Refer to the exhibit.
Which VPN solution does this configuration represent?
A. Cisco AnyConnect
B. IPsec
C. L2TP
D. SSL VPN
Answer: B