Certleader offers free demo for cisco 300 320 exam. "ARCH Designing Cisco Network Service Architectures", also known as 300 320 arch pdf exam, is a Cisco Certification. This set of posts, Passing the Cisco ccdp arch 300 320 pdf exam, will help you answer those questions. The ccdp 300 320 Questions & Answers covers all the knowledge points of the real exam. 100% real Cisco 300 320 arch exams and revised by experts!
2026 New 300-320 Exam Dumps with PDF and VCE Free: https://www.2passeasy.com/dumps/300-320/
P.S. Precise 300-320 pdf are available on Google Drive, GET MORE: https://drive.google.com/open?id=1u7ZxDW95o-qJm-u3EZrQA04Chp9tcD0F
New Cisco 300-320 Exam Dumps Collection (Question 14 - Question 23)
New Questions 14
What are the two methods of ensuring that the RPF check passes? (Choose two.)
A. implementing static mroutes
B. implementing OSPF routing protocol
C. implementing MBGP
D. disabling the interface of the router back to the multicast source
E. disabling BGP routing protocol
Answer: A,C
New Questions 15
What is the primary benefit of deployment MPLS over the WAN as opposed to extending VRF-lite across the WAN?
A. convergence time
B. low operating expense
C. low latency
D. dynamic fault-tolerance
Answer: B
New Questions 16
A network engineer is designing an access layer that requires all uplinks to be active. Furthermore, VLANs must span across the entire switch block. What design fulfills this requirement?
A. Layer 2 looped triangle
B. Layer 2 looped square
C. Layer 2 loop-free U
D. Layer 2 loop-free inverted U
Answer: D
New Questions 17
An engineer is configuring QoS to meet the following requirement:
- all traffic that exceeds the allocated bandwidth will still traverse the infrastructure but will be forwarded later.
What will be requirements? (E)
A. Per-Hop behaviours
B. Weighted Fair Queuing
C. IP Precedence
D. Shaping
Answer: D
New Questions 18
Which command can you enter to inject BGP routes into an IGP?
A. redistribute bgp
B. redistribute static
C. redistribute static subnet
D. default-information originate
Answer: A
New Questions 19
Which two values does EIGRP use to calculate the metric of a route in a converged EIGRP topology (choose two):
A. redundancy
B. bandwidth
C. cost
D. delay
E. hops
Answer: B,D
New Questions 20
A network link is going up and down rapidly, and it is hindering network performance and
routing table stability. Which option can be configure to insulate against the performance impact of
interface or link failure throughout the network?"
A. Distributed Cisco Express Forwarding switching
B. Secondary IP addressing
C. route summarization
D. default route propagation
Answer: C
New Questions 21
Which STP feature can prevent other switches on the network from becoming the root
switch, but still allow that interface to participate in STP otherwise?
A. Root Guard
B. Loop Guard
C. BPDU Guard
D. BPDU Filter
Answer: A
New Questions 22
Which two elements comprise the backbone area while designing a new network utilizing IS-IS as the interior gateway protocol (choose two)
A. contiguous chain of Level 2 capable routers
B. contiguous chain of Level1/Level 2 capable routers
C. set of Level 2 configured interfaces
D. contiguous Level 1 capable routers
E. set of Level 1 configured interfaces
Answer: A,B
Explanation:
https://www.cisco.com/en/US/products/ps6599/products_white_paper09186a00800a3e6f.s html
"Backbone IS-IS does not have a backbone area like the OSPF area 0. The IS-IS backbone is a contiguous collection of Level 2-capable routers, each of which can be in a different area"
http://www.ciscopress.com/articles/article.asp?p=26850&seqNum=3
"In most designs with routing hierarchy, the Level 2 routers are also Level 1 routers by virtue of their
identification with a certain area. Therefore, in IS-IS, a router can function as Level 1-only or Level 2-only and possibly as both Level 1 and Level 2 (Level 1-2). Level 1-2 routers act as border routers to their respective areas, providing connectivity to other areas. The Level 2 backbone is essentially a virtual IS-IS area consisting of routers engaged in Level 2 routing"
New Questions 23
A customer with a single Cisco Adaptive Security Appliance wants to separate multiple segments of the ecommerce network to allow for different security policies. What firewall technology accommodates these design requirements?
A. Routed mode
B. Virtual-context
C. Transparent mode
D. Virtual private network
E. private VLANs
F. admission control
Answer: B
P.S. Easily pass 300-320 Exam with Examcollection Precise Dumps & pdf vce, Try Free: http://www.examcollectionuk.com/300-320-vce-download.html (482 New Questions)