Testking offers free demo for 300 320 arch pdf exam. "Designing Cisco Network Service Architectures", also known as ccdp arch 300 320 pdf exam, is a Cisco Certification. This set of posts, Passing the Cisco cisco 300 320 exam, will help you answer those questions. The 300 320 vce Questions & Answers covers all the knowledge points of the real exam. 100% real Cisco 300 320 dumps exams and revised by experts!
2026 New 300-320 Exam Dumps with PDF and VCE Free: https://www.2passeasy.com/dumps/300-320/
Q1. Which two of these correctly describe asymmetric routing and firewalls? (Choose two.)
A. only operational in routed mode
B. only operational in transparent mode
C. only eight interfaces can belong to an asymmetric routing group
D. operational in both failover and non-failover configurations
E. only operational when the firewall has been configured for failover
Answer: C,D
Q2. What SAN technology can accomplish fabric infrastructure implementation using multiple fabrics?
A. VSAN
B. IVR
C. SCSI
D. NAS
Answer: A
Q3. A network engineer is designing a dual router, dual ISP solution and must prefer one ISP for inbound traffic over the other. Which two BGP attributes can be manipulated to accomplish this goal? (Choose two.)
A. AS path
B. MED
C. local preference
D. weight
E. origin code
Answer: A,B
Q4. A network engineer must perform posture assessments on Cisco ASA remote access VPN clients and control their network access based on the results. What mode is the Cisco best practice NAC deployment design for this situation?
A. Layer 2 in-band real IP gateway mode
B. Layer 2 out-of-band real IP gateway mode
C. Layer 3 in-band virtual gateway mode
D. Layer 3 out-of-band virtual gateway mode
Answer: C
Q5. Which two services are provided at the aggregation layer in a data center design? (Choose two.)
A. service module integration
B. default gateway redundancy
C. high-speed packet switching backplane
D. network interface card teaming
E. Layer 3 domain definitions
Answer: A,B
Q6. Which option is a benefit of the vPC+ feature?
A. Cisco FabricPath is not required in the network domain.
B. This feature provides fault domain separation.
C. Nonfabric devices, such as a server or a classic Ethernet switch, can be connected to two fabric switches that are configured with vPC.
D. The control plane and management plane are combined into one logical plane.
Answer: C
Q7. A e-commerce network has many devices that often need to be upgraded on a regular basis. What technology will ensure IP packets continue to be forwarded even during a device failover?
A. stateful switchover
B. nonstop forwarding
C. route processor redundancy
D. optimized edge routing
E. enhanced object tracking
Answer: B
Q8. Which type of connectivity is required for VPLS?
A. full mesh
B. partial mesh
C. star
D. bus
E. ring
Answer: A
Q9. Which action can be taken on a multiaccess segment with OSPF speakers to reduce the performance impact during widespread convergence events?
A. Separate the network into multiple areas for each new multiaccess segment.
B. Enable LSA throttling in the core to slow link state advertisement updates during times of network instability.
C. Ensure that the elected DR or BDR router can support high-volume convergence events.
D. Verify that fewer than 50 OSPF speakers are on the segment.
Answer: C
Q10. Which two design concerns must be addressed when designing a multicast implementation? (Choose two.)
A. only the low-order 23 bits of the MAC address are used to map IP addresses
B. only the low-order 24 bits of the MAC address are used to map IP addresses
C. only the high-order 23 bits of the MAC address are used to map IP addresses
D. only the low-order 23 bits of the IP address are used to map MAC addresses
E. the 0x01004f MAC address prefix is used for mapping IP addresses to MAC addresses
F. the 0x01005e MAC address prefix is used for mapping IP addresses to MAC addresses
Answer: A,F