It is impossible to pass Cisco 352-001 exam without any help in the short term. Come to Pass4sure soon and find the most advanced, correct and guaranteed Cisco 352-001 practice questions. You will get a surprising result by our Avant-garde CCDE Written Exam practice guides.


2026 New 352-001 Exam Dumps with PDF and VCE Free: https://www.2passeasy.com/dumps/352-001/

Q1. In which two ways is IPv4 and IPv6 traffic handled in a network design that uses QoS deployment options? (Choose two.) 

A. IPv6 and IPv4 traffic is treated in the same way by using a single QoS policy that classifies and matches on both protocols. 

B. IPv6 traffic is treated differently than IPv4 by using the flow-label field, which is built into the IPv6 packet header. 

C. IPv6 traffic does not require QoS because it uses to the flow-label field, which classifies and matches on the IPv6 protocol. 

D. IPv6 traffic is treated differently than IPv4 by using two different QoS policies. 

E. IPv6 traffic is treated differently than IPv4 because it uses only the DSCP value and not the IP precedence. 

Answer: AD 

Q2. A network designer wants to improve a company network design due to multiple network crashes. Which technology would allow for the restore of a network connection without informing the Layer 3 protocol? 

A. Bidirectional Forwarding Detection 

B. automatic protection switching 

C. UniDirectional Link Detection 

D. Ethernet OAM 

Answer: B 

Q3. The network administrator of a branch office network has decided to deploy Unicast RPF at the access layer. He insists that the design must guarantee that all the packets arriving on the router interfaces are assigned to the same interface subnet. 

Which mode of Unicast RPF would you recommend as the lead network designer? 

A. uRPF strict mode 

B. uRPF loose mode 

C. uRPF VRF mode 

D. RPF feasible mode 

Answer: A 

Q4. Which multicast technology provides a large, many-to-many connectivity for a new application while minimizing load on the existing network infrastructure? 

A. Bidirectional PIM 

B. PIM Sparse Mode 

C. Any-source Multicast 

D. Source Specific Multicast 

Answer: A 

Q5. You are designing a network to support data, voice and video. Which two main factors will you address to improve network convergence? (Choose two.) 

A. event propagation delay 

B. failure detection delay 

C. forwarding engine update delay 

D. routing table recalculation delay 

Answer: BD 

Q6. Refer to the exhibit. 

In the DWDM network, a ring topology carries multiple services between two sites. Which option describes the employed protection design? 

A. Y-cable protection 

B. Splitter protection 

C. Client protection 

D. UDLD 

E. FEC protection 

Answer: C 

Q7. An MPLS service provider is offering a standard EoMPLS-based VPLS service to Customer A, providing Layer 2 connectivity between a central site and approximately 100 remote sites. Customer A wants to use the VPLS network to carry its internal multicast video feeds, which are sourced at the central site and consist of 20 groups at 5 Mb/s each. Which service provider recommendation is the most scalable? 

A. EoMPLS-based VPLS already carries multicast traffic in a scalable manner. 

B. Replicate the multicast traffic on the P routers. 

C. Replace VPLS with a Layer 3 MVPN solution to carry the streams between sites. 

D. Use GRE tunnels to carry the streams between sites. 

Answer: C 

Q8. When creating a network design, which one of these options provides for basic Layer 2 client isolation to prevent broadcast traffic exposure? 

A. SVI 

B. VLAN 

C. routed port 

D. edge port 

Answer: B 

Q9. A Service Provider is designing a solution for a managed CE service to a number of local customers using a single CE platform and wants to have logical separation on the CE platform using Virtual Routing and Forwarding (VRF) based on IP address ranges or packet length. Which is the most scalable solution to provide this type of VRF Selection process on the CE edge device? 

A. Static Routes for Route Leaking 

B. Policy Based Routing 

C. Multi-Protocol BGP 

D. OSPF per VRF Instance 

Answer: B 

Q10. Refer to the exhibit. 

Acme Corporation hired you as a network designer to upgrade their network so that it supports IPv4 and IPv6 multicast. Which two protocols are needed on the LAN switch? (Choose two.) 

A. PIM sparse mode 

B. IGMP snooping 

C. PIM snooping 

D. Source Specific Multicast 

E. MLD snooping 

Answer: BE