Your success in Cisco 640-878 is our sole target and we develop all our 640-878 braindumps in a way that facilitates the attainment of this target. Not only is our 640-878 study material the best you can find, it is also the most detailed and the most updated. 640-878 Practice Exams for Cisco CCNA Service Provider 640-878 are written to the highest standards of technical accuracy.
2026 New 640-878 Exam Dumps with PDF and VCE Free: https://www.2passeasy.com/dumps/640-878/
Q1. Which three statements about VLAN implementation in a Layer 2 switch environment are true? (Choose three.)
A. The Cisco IOS switchport access vlan interface configuration command is used to configure the native VLAN on the switch port.
B. 802.1AD supports VLAN overlap.
C. VLANs can span across multiple switches.
D. 802.1Q encapsulation is used to identify different VLANs on a trunk port.
E. Inter-VLAN routing is performed between VLAN tunnel ports.
Answer: B,C,D
Q2. Refer to the exhibit.
***Exhibit is Missing***
Which statement is true?
A. VLAN 1 traffic is sent untagged on the fa0/11 trunk port.
B. All VLANs traffic, including the native VLAN traffic, is tagged with a VLAN ID when it is sent over the fa0/11 trunk port.
C. The switchport trunk allowed vlan command is not configured; therefore, no VLANs are allowed on the trunk.
D. The encapsulation type that is used is 802.1ad.
E. The switchport trunk native vlan command is not configured; therefore, the trunk is not operational.
Answer: A
Q3. When configuring a new VLAN on Cisco IOS switches, which configuration parameter is required?
A. VLAN name
B. native VLAN ID
C. VLAN ID
D. VLAN map
E. VLAN MTU
Answer: C
Q4. Which three are common ISP access network technologies? (Choose three.)
A. DSL
B. Cable modem
C. DWDM
D. MPLS
E. PON
F. MP-BGP
Answer: A,B,E
Q5. When configuring an ACL entry, which network and wildcard mask matches only IP addresses
10.8.144.0 to 10.8.151.255?
A. 10.8.144.0 0.0.3.255
B. 10.8.144.0 0.0.7.255
C. 10.8.144.0 0.0.15.255
D. 10.8.144.0 0.0.252.255
E. 10.8.144.0 0.0.248.255
F. 10.8.144.0 0.0.240.255
Answer: B
Q6. Refer to the topology diagram in the exhibit.
***Exhibit is Missing***
Which two interface configuration commands on the Cisco ME 3400-1 switch Fa 0/1 interface are required to support the VLANs for Customer A to be trunked across the service provider network? (Choose two.)
A. switchport access vlan 30
B. switchport mode trunk
C. switchport mode dot1q-tunnel
D. switchport trunk allowed vlan 1-100
Answer: A,C
Q7. You have installed a new router and configured OSPF on it. However, this new router is not able to establish an OSPF neighbor relationship with the neighbor OSPF router. Which four conditions could cause this problem? (Choose four.)
A. mismatched OSPF hello/dead interval between the new router and the neighbor router
B. mismatched OSPF area ID between the new router and the neighbor router
C. mismatched OSPF authentication data between the new router and the neighbor router
D. mismatched OSPF router ID between the new router and the neighbor router
E. mismatched interface MTU between the new router and the neighbor router
F. mismatched interface bandwidth between the new router and the neighbor router
Answer: A,B,C,E
Refer to the Cisco IOS XR configuration exhibit.
***Exhibit is Missing***
Which statement about the configuration is true?
A. This is a Level-2-only router.
B. This is a Level-1-only router.
C. The maximum IS-IS path metric is 63.
D. This router belongs to area ID 0001.
E. This configuration is missing the net configuration for the IPv6 unicast address family.
Q8. Which three Cisco platforms are classified as core routers? (Choose three.)
A. Cisco XR 12000
B. Cisco ME 3400
C. Cisco ASR 1006
D. Cisco CRS-3
E. Cisco ASR 9010
F. Cisco 3900
Answer: A,D,E
Q9. ISPs use which protocol to establish peering sessions in an Internet exchange point environment?
A. LDP
B. IS-IS
C. BGP
D. OSPF
Answer: C
Q10. Which two statements about the BGP weight attribute on Cisco routers are true? (Choose two.)
A. It is a well-known discretionary attribute.
B. It is only locally significant.
C. Routes with higher weight are the preferred routes.
D. It is used to influence the inbound traffic from the upstream AS.
E. It is set to 100 by default.
Answer: B,C