Our pass rate is high to 98.9% and the similarity percentage between our 642-980 study guide and real exam is 90% based on our seven-year educating experience. Do you want achievements in the Cisco 642-980 exam in just one try? I am currently studying for the Cisco 642-980 exam. Latest Cisco 642-980 Test exam practice questions and answers, Try Cisco 642-980 Brain Dumps First.
2026 New 642-980 Exam Dumps with PDF and VCE Free: https://www.2passeasy.com/dumps/642-980/
Q1. Refer to the exhibit.
What command should you execute next in resolving a lock failure?
A. ntp execute
B. ntp commit
C. ntp lock
D. ntp help
E. ntp detail
Answer: B
Q2. Which statement is true regarding the port channel 100 and 101 configurations between the Nexus 7010 switches?
A. The vPC assignments on N7010-C2 are incorrectly swapped
B. N7010-C1 is not allowing any active VLAN traffic to pass on Po100 and Po101.
C. LACP is not configured to initiate negotiations.
D. The vPC peer-keepalive is down between the two Nexus 7000 switches.
Answer: A
Explanation:
The vPC assignments on N7010-C2 are incorrectly swapped.
The “show vpc” command will show you that the keepalives are active, and that there areactive VLANs. The “show port-channel summary” command shows that LACP is enabled.
Q3. Which command displays the traffic statistics for a port channel interface?
A. show interface port-channel channel-number
B. show port-channel traffic
C. show port-channel usage
D. show port-channel compatibility-parameters
Answer: B
Q4. Which statement is true regarding how OTV edge devices will react based on the configuration of the VLANs being extended across the overlay network?
A. Any VLANs not extended will not be populated in the local OTV route table.
B. Only the same-site edge AED device controls which VLANs are to be extended.
C. Any extended VLANs will not be populated in the remote OTV route table.
D. By default, all VLANs on an edge device will be extended.
Answer: A
Q5. A customer is deploying multihop FCoE in its network. Which guideline must the customer follow with respect to VE ports to make this deployment possible?
A. Auto mode on the vFC interface is supported.
B. VE-port trunking is supported over FCoE-enabled VLANs.
C. VE-port interface binding to MAC addresses is supported.
D. A VE port is disabled for trunk mode by default.
Answer: B
Q6. Which command would you use to find the AED of an extended VLAN in a dual-homed site of an OTV network?
A. show otv aed on the AED
B. show otv site on any edge devices in the site
C. show otv vlan on the AED
D. show otv aed on any edge devices in the site
E. show otv vlan on any edge devices in the site
Answer: C
Q7. Which command on a Cisco Nexus 5000 Series Switch will show the interface information for port 10 on the connected FEX 100?
A. show interface Ethernet 100/10
B. show fex 100 interface Ethernet 1/10
C. show interface Ethernet 100/1/10
D. show interface Ethernet 1/100/10
Answer: C
Q8. A customer reports that a 10-Gb interface between a Cisco Nexus 7009 Switch and a Cisco Nexus 5548UP Switch is not passing traffic. The Nexus 7009 interface indicates up/up. The Nexus 5548UP interface indicates up/down. Which feature should you enable to help isolate the root cause?
A. CDP
B. GOLD
C. UDLD
D. DAI
E. LACP
Answer: C
Q9. Which statement is true regarding Cisco FabricPath?
A. It is necessary to first install the Cisco FabricPath feature set in the default VDC.
B. Cisco FabricPath is only available on Cisco Nexus 7010 Switches with the Supervisor 2 engine.
C. Cisco FabricPath cannot be disabled explicitly for a specific VDC.
D. If the Cisco FabricPath feature is not installed, the fabricpath keyword will be available in the feature-set command.
Answer: A
Q10. Which tools can assist in the troubleshooting of FC-0 issues? (Choose three.)
A. FC analyzer
B. SPAN
C. Device Manager
D. show interface fc1/1 optical-power-budget
E. PAA
F. a portable protocol analyzer
Answer: ACF