Breathing of 642-980 training materials and preparation labs for Cisco certification for IT candidates, Real Success Guaranteed with Updated 642-980 pdf dumps vce Materials. 100% PASS Troubleshooting Cisco Data Center Unified Fabric exam Today!


2026 New 642-980 Exam Dumps with PDF and VCE Free: https://www.2passeasy.com/dumps/642-980/

Q1. You receive an error attempting to enable the vPC feature on a Cisco Nexus 7018 Switch. Which Cisco Fabric Services distribution must be operational before the feature can be enabled? 

A. CFSoFC 

B. CFSoIP 

C. CFSoV 

D. CFSoE 

E. CFSoM 

Answer: D 

Q2. When using a Cisco Nexus 5500 and Cisco Nexus 7000 Series Switch, how can a port channel interface be configured? 

A. Layer 3 interface 

B. Layer 3 interface in non-admin VDC only 

C. Layer 3 interface in admin VDC only 

D. Layer 3 interface in VDC 1 only 

Answer: A 

Q3. Refer to the exhibit. 

When your customers have NPV problems, which three actions should you take? (Choose three.) 

A. Verify that the NPV core switch supports NPIV and that it is enabled. 

B. Verify that all ports are properly configured and connected. 

C. Ensure that the VLAN values are configured on both sides of the NPV core switch. 

D. Verify the status of the servers and external interfaces, using the show npv server status command. 

E. Ensure that the VSAN value that is configured on the device links is correct. 

F. For all the device links, ensure that the port mode on the NPV device is in Full_port mode. 

Answer: ABE 

Q4. Which command on a Cisco Nexus 5000 Series Switch will show the interface information for port 10 on the connected FEX 100? 

A. show interface Ethernet 100/10 

B. show fex 100 interface Ethernet 1/10 

C. show interface Ethernet 100/1/10 

D. show interface Ethernet 1/100/10 

Answer: C 

Q5. A customer calls you to report that it receives an error when entering the pinning max-links 4 command in FEX configuration mode on its Cisco Nexus 5596T Switch. Which of these is a likely cause for this condition? 

A. The FEX fabric interface is down. 

B. The transceiver is incorrect. 

C. A fabric interface is in a port channel. 

D. The fabric interface switchport mode is set to Access. 

E. Only two fabric interfaces are connected. 

Answer: C 

Q6. Refer to the exhibit. 

The customer informs you of a problem they are encountering. What is the cause of the problem? 

A. The core upstream switch does not have NPIV enabled. 

B. The downstream switch does not have NPIV enabled. 

C. NPIV has been disabled on all switches. 

D. NPIV has been configured but not enabled on the uplink port. 

Answer: A