Cause all that matters here is passing the Cisco 642-980 exam. Cause all that you need is a high score of 642-980 Troubleshooting Cisco Data Center Unified Fabric exam. The only one thing you need to do is downloading Exambible 642-980 exam study guides now. We will not let you down with our money-back guarantee.


2026 New 642-980 Exam Dumps with PDF and VCE Free: https://www.2passeasy.com/dumps/642-980/

Q1. Refer to the exhibit. 

Customer is having problems with a device in VLAN100? What would fix the problem? 

A. Move the trunk port into VSAN 100. 

B. Change interface fc1fc1/1 into a trunk port and remove VSAN 100. 

C. Change interface fc2/4 into a trunk port. 

D. Change interface fc2/4 into VSAN 100. 

E. Change interface fc1fc1/2 into VSAN 100. 

Answer: D 

Q2. Refer to the exhibit. 

A customer is having a problem getting NPV to work. What is causing the problem? 

A. The core NPV switch port is not an F port. 

B. The core NPV switch port is in a shutdown state. 

C. The core NPV switch port is not configured on both ends. 

D. The core NPV switch port is not configured on the other end. 

E. The core NPV switch ports are in the wrong domain. 

Answer: A 

Q3. Which three commands will show all the MAC addresses learned from remote sites in an OTV overlay? (Choose three.) 

A. show otv arp-nd-cache 

B. show otv route overlay 

C. show otv vlan 

D. show ip arp 

E. show mac address-table 

F. show otv site 

Answer: ABE 

Q4. Which statement is true regarding LACP configuration? 

A. With LACP, you can bundle up to 16 interfaces in a channel group. 

B. LACP configuration is global and can be only configured by admin. 

C. After removing LACP configuration, you need to reboot the device. 

D. You can disable LACP while any LACP configurations are present. 

Answer: A 

Q5. What is the correct configuration for interface Ethernet 1/1 of a Cisco Nexus 5000 Series Switch when it is a member of port channel 101 connected to FEX 101? 

A. interface Ethernet1/1 

switchport mode trunk 

switchport trunk native vlan 10 

switchport trunk allowed vlan 20,30 

fex associate 101 

channel-group 101 

B. interface Ethernet1/1 

switchport mode fex-fabric 

channel-group 101 

C. interface Ethernet1/1 

switchport mode access 

switchport access vlan 10 

fex associate 101 

channel-group 101 

D. interface Ethernet1/1 

switchport mode fex-fabric 

fex associate 101 

channel-group 101 

Answer: D 

Q6. Refer to the exhibit. 

VSAN traffic is not being routed through SAN fabric. Which action is helpful to resolve the problem? 

A. Make sure that the FSPF hello interval value matches on both switches. 

B. Change the FSPF hello timer back to the default of 5 seconds. 

C. Make sure that the FSPF hello timers are different so that they do not compete. 

D. Make sure that the FSPF dead timers are both set to 0. 

Answer: A