All About Real 642-997 braindumps

Q1. Which statement about implementation of Cisco TrustSec on Cisco Nexus 5546 or 5548 switches are true? 

A. Cisco TrustSec support varies depending on Cisco Nexus 5500 Series Switch model. 

B. The hardware is not able to support MACsec switch-port-level encryption based on IEEE 802.1AE. 

C. The maximum number of RBACL TCAM user configurable entries is 128k. 

D. The SGT Exchange Protocol must use the management (mgmt 0) interface. 

View Answer

Q2. DRAG DROP 

View Answer

Q3. Between which two types of ports does FIP establish Fibre Channel virtual links? (Choose two.) 

A. VE Ports and VE Ports 

B. N Ports and F Ports 

C. VN Ports and VF Ports 

D. VP Ports and VE Ports 

E. VE Ports and VF Ports 

F. E Ports and E Ports 

View Answer

Q4.  

FabricPath switch-id is 25 and load-balance is configured for L3/L4 and rotate amount is 14 byte. What information is true about FabricPath switch-id? 

A. FabricPath topology requires manual configuration of switch-id which has a range from 1 to 4095 

B. Every FabricPath must have a manually configured switch-id for it to form a FabricPath topology 

C. FabricPath topology requires manual configuration of switch-id which has a range from 1 to 4099 

D. You do not have to manually assign a switch ID unless you are running a virtual port channel plus (vPC*) because the system assigns a switch ID for you when you enable FabricPath 

View Answer

Q5. On a Cisco Nexus 7000 Series router, which statement about HSRP and VRRP is true? 

A. When VDCs are in use, only VRRP is supported. 

B. HSRP and VRRP both use the same multicast IP address with different port numbers. 

C. HSRP has shorter default hold and hello times. 

D. The VRRP group IP address can be the same as the router-specific IP address. 

View Answer

Q6. DRAG DROP 

View Answer

Q7. What is the Overlay Transport Virtualization site VLAN used for? 

A. to allow the join interfaces at different sites to communicate 

B. to detect devices at the site that are not capable of OTV 

C. to allow multiple site AEDs to communicate with each other 

D. to detect other OTV edge devices in the site 

View Answer

Q8.  

Customer has configured fabhcpath allocate-delay to 600. What is the effect of this? 

A. The allocate-delay is the time for FPto go into forwarding state 

B. It specifies the time delay for a transitioned value to be propagated throughout the network 

C. It specifies the time delay for a link bringup to detect conflicts 

D. The allocate-delay is the time delay for a new resource to be propagated throughout the network 

View Answer

Q9. Refer to the exhibit. 

This multilayer Cisco Nexus switch had been the active virtual gateway for Group 1 before it became temporarily unavailable. What will happen to GLBP Group 1 when this device becomes available again? 

A. The currently active router remains active. 

B. It depends on the priority value that is configured active on the router. 

C. The Cisco Nexus switch becomes the active virtual gateway after 600 seconds. 

D. It depends on the weighting values that are configured active on the router. 

View Answer

Q10. Which two statements about Cisco Nexus 7000 line cards are true? (Choose two.) 

A. M1, M2, and F1 cards are allowed in the same VDC. 

B. M line cards are service-oriented and likely face the access layer and provide Layer 2 connectivity. 

C. F line cards are performance-oriented and likely connect northbound to the core layer for Layer 3 connectivity. 

D. M line cards support Layer 2, Layer 3, and Layer 4 with large forwarding tables and a rich feature set. 

E. The F2 line card must reside in the admin VDC. 

View Answer