Your success in Cisco 642-997 is our sole target and we develop all our 642-997 braindumps in a way that facilitates the attainment of this target. Not only is our 642-997 study material the best you can find, it is also the most detailed and the most updated. 642-997 Practice Exams for Cisco CCNP Data Center 642-997 are written to the highest standards of technical accuracy.


2026 New 642-997 Exam Dumps with PDF and VCE Free: https://www.surepassexam.com/642-997-exam-dumps.html

Q1. Which function does the graceful restart feature allow a Cisco Nexus 7000 Series router to perform? 

A. Perform a rapid route convergence. 

B. Initialize a standby supervisor transparently when one is present. 

C. Remain in the data forwarding path through a process restart. 

D. Maintain a management connection throughout a router restart. 

Answer: C 

Q2.  

What is the status of FC interface associated with ethernet 1/5 indicate? 

A. Trunk VSAN 11 is isolated B. Inteface vfc 5 is up and running for the assigned VSAN 

C. Trunk VSAN 11 is intializing 

D. VSAN to FC mapping is not working as expected 

Answer: B 

Q3. Which three Cisco UCS C-Series CNAs support Adapter FEX? (Choose three.) 

A. Qlogic QLE8152 

B. Broadcom BCM57712 

C. Cisco UCS P81E 

D. Cisco UCS VIC 1220 

E. Emulex OCe10102-FX-C 

F. Intel X520 

Answer: BCD 

Q4. What is the grace period in a graceful restart situation? 

A. how long the supervisor waits for NSF replies 

B. how often graceful restart messages are sent after a switchover 

C. how long NSF-aware neighbors should wait after a graceful restart has started before tearing down adjacencies 

D. how long the NSF-capable switches should wait after detecting that a graceful restart has started, before verifying that adjacencies are still valid 

Answer: C 

Q5. Which protocol is responsible for the discovery of FCoE capabilities on a remote switch? 

A. DCE 

B. DCBx 

C. CDP 

D. LLDP 

Answer: B 

Q6. Refer to the exhibit. 

Which three statements about the Cisco Nexus 7000 switch are true? (Choose three.) 

A. An emulated switch ID must be unique when the vPC+ feature is used. 

B. Switches with FabricPath and vPC+ consume two switch IDs. 

C. Emulated switch IDs must be numbered from 1 to 99. 

D. Each switch ID must be unique in the FabricPath topology. 

E. Switch IDs must be configured manually. 

Answer: BDE 

Q7. Which two statements about SAN zoning on Cisco Nexus switches are true? (Choose two.) 

A. Zoning is enforced by examining the destination ID field. 

B. Devices can only belong to one zone. 

C. Only one zone set can be activated at any time. 

D. A zone can only be a member one zone set. 

E. Zoning must be administered from the primary SAN switch in the fabric. 

F. Zone configuration changes are nondisruptive. 

Answer: CF 

Q8. What is the Overlay Transport Virtualization site VLAN used for? 

A. to allow the join interfaces at different sites to communicate 

B. to detect devices at the site that are not capable of OTV 

C. to allow multiple site AEDs to communicate with each other 

D. to detect other OTV edge devices in the site 

Answer: D 

Q9. Which FCoE component is responsible for the encapsulation and de-encapsulation of Fibre Channel frames in Ethernet? 

A. distributed FCF 

B. FCoE node 

C. FCoE logical endpoint 

D. Fibre Channel forwarder 

E. FCoE forwarder 

Answer: C 

Q10. Refer to the command below. When configuring an SVS connection on the Cisco Nexus 5000 Series Switch, which device is being referenced as the remote IP address? 

nexus5500-2(config-svs-conn)# remote ip address 10.10.1.15 port 80 vrf management 

A. ESX or ESXi host 

B. vCenter 

C. vPC peer switch 

D. Cisco IMC management 

Answer: B