A Review Of Highest Quality 200-125 pdf

Q2. Which two statements about TACACS+ are true? (Choose two.)

A. It can run on a UNIX server.

B. It authenticates against the user database on the local device.

C. It is more secure than AAA authentication.

D. It is enabled on Cisco routers by default.

E. It uses a managed database.

View Answer

Q3. Which WAN topology provides a direct connection from each site to all other sites on the network?

A. single-homed

B. full mesh

C. point-to-point

D. hub-and-spoke

View Answer

Q4. When is a routing table entry identified as directly connected?

A. when the local router is in use as the network default gateway

B. when the network resides on a remote router that is physically connected to the local router

C. when an interface on the route is configure with an ip address and enabled

D. when the route is statically assigned to reach a specific network

View Answer

Q5. Which command can you enter to determine the addresses that have been assigned on a DHCP Server?

A. Show ip DHCP database.

B. Show ip DHCP pool.

C. Show ip DHCP binding.

D. Show ip DHCP server statistic.

View Answer

Q6. Which address class includes network 191.168.0.1/27?

A. Class C

B. Class B

C. Class D

D. Class A

View Answer

Q7. Exhibit:

After you apply the given configuration to R1, you determine that it is failing to advertise the 172.16.10.32/27 network which action is most likely to correct the problem ?

A. enable passive interface

B. enable manual summarization

C. enable autosummarization

D. enable RIPV2

View Answer

Q8. After you configure a new router to connect to a host through the GigabitEthernet0/0 port of the router, you log in to the router and observe that the new link is down. Which action corrects the problem?

A. Use a crossover cable between the host and R1.

B. Use a straight through cable between the host and R1.

C. Configure the host to use R1 as the default gateway.

D. Use a rollover cable between the host and R1.

View Answer

Q9. Which networking Technology is currently recognized as the standard for computer networking?

A. System network architecture

B. Transmission control protocol/Internet protocol

C. Open system Interconnect

D. Open network architecture

View Answer

Q10. Which command can you use to test whether a switch supports secure connections and strong authentication?

A. Switch>ssh u2013v 1-I admin 10.1.1.1

B. Router#ssh u2013v1 u2013I admin 10.1.1.1

C. Router>ssh u2013V2 u2013I admin 10.1.1.1

D. Switch#ssh u2013I admin 10.1.1.1

View Answer

Q11. While troubleshooting a DCHP client that is behaving erratically, you discover that the client has been

assigned the same IP address as a printer that is a staticIP address. Which option is the best way to

resolve the problem?

A. Configure static route to the client.

B. Assign the client the same IP address as the router.

C. Move the client to another IP subnet

D. Move the printer to another IP subnet.

E. Reserve the printer IP address.

View Answer