It is impossible to pass Cisco ccna routing and switching 200 125 exam without any help in the short term. Come to Passleader soon and find the most advanced, correct and guaranteed Cisco ccna 200 125 book practice questions. You will get a surprising result by our Most up-to-date CCNA Cisco Certified Network Associate CCNA (v3.0) practice guides.
2026 New 200-125 Exam Dumps with PDF and VCE Free: https://www.2passeasy.com/dumps/200-125/
P.S. Virtual 200-125 vce are available on Google Drive, GET MORE: https://drive.google.com/open?id=1qSmqe9lmg23sR5XECqlhobCqcIIdpdHn
New Cisco 200-125 Exam Dumps Collection (Question 6 - Question 15)
Q1. Which statement describes the effect of the copy run start command on a router in enable mode?
A. The running configuration of the router is savedto NVRAM and used during the boot process.
B. The router reboots and loads the last saved running configuration.
C. A copy of the running configuration of the router is sent by FTP to a designated server.
D. A new running configuration is loaded from flashmemory to the router.
Answer: A
Q2. Which three describe the reasons large OSPF networks use a hierarchical design? (Choose Three)
A. to speed up convergence
B. to reduce routing overhead
C. to lower costs by replacing routers with distribution layer switches.
D. to decrease latency by increasing bandwidth.
E. to confine network instability to single areas of the network.
F. to reduce the complexity of router configuration.
Answer: A,B,E
Q3. Which feature facilitates the tagging of frames on a specific VLAN?
A. routing
B. hairpinning
C. switching
D. encapsulation
Answer: D
Q4. which add prefix does OSPFv3 use when multiple IPv6 address are configured on a single interface ?
A. all prefix on the interface
B. the prefix that the administrator configure for OSPFv3 use
C. the lowest prefix on the interface
D. the highest prefix on the interface
Answer: A
Explanation: Reference:
http://www.cisco.com/c/en/us/td/docs/ios-xml/ios/iproute_ospf/configuration/15-sy/iro-15-sy- book/ip6-
routeospfv3.html#GUID-05F3F09C-FE3E-41D6-9845-111FB17AD030
u201cIn IPv6, you can configure many address prefixes on an interface. In OSPFv3, all address prefixes on an
interface are included by default. You cannot select some address prefixes to be imported into OSPFv3;
either all address prefixes on an interface are imported, or no address prefixes on an interface are
imported.u201d
Q5. Why would a network administrator configure port security on a switch?
A. to limit the number of Layer 2 broadcasts on a particular switch port
B. to prevent unauthorized Telnet access to a switch port
C. to prevent unauthorized hosts from accessing the LAN
D. block unauthorized access to the switch management interfaces
Answer: C
Q6. Which 2 statements about extended traceroute command is true?
A. it can send packets from specified interface or ip address
B. it can use a specified TTL value.
C. it can validate the reply data.
D. it can use a specificed TOS.
E. it can repeated automatically to a specified interval.
Answer: A,B
Explanation: Reference:
http://www.cisco.com/c/en/us/support/docs/ip/routing-information-protocol-rip/13730- extpingtrace.
html#ext_troute
u201cThis table lists the traceroute command field descriptions:
Source address: The interface or IP address of the router to use as a source address for the probes. The
router normally picks the IP address of the outbound interface to use.
Minimum Time to Live [1]: The TTL value for the first probes. The default is 1, but it can be set to a higher
value to suppress the display of known hops.
Maximum Time to Live [30]: The largest TTL value that can be used. The default is 30. The traceroute
command terminates when the destination is reached or when this value is reached.
Q7. Which MAC protocol sets a random timer to reattempt communication?
A. IEEE 802.1x
B. RARP
C. CSMA/CA
D. CSMA/CD
Answer: D
Q8. Which two address are defined as private ip addresses ?
A. 192.169.32.10
B. 10.172.76.200
C. 172.15.2.250
D. 12.17.1.20
E. 172.31.255.100
Answer: B,E
Q9. which statement about snmpv2 is true ?
A. it requires password at least eight characters in length
B. it requires passwords to be encrypted
C. its privacy algorithms use md5 encryption by default
D. its authentic and privacy algorithms are enabled without default values
Answer: D
Q10. Which two statements about firewalls are true ?
A. They can be used with an intrusion prevention system.
B. They can limit unauthorized user access to protect data.
C. Each wireless access point requires its own firewall.
D. They must be placed only at locations where the private network connects to the internet.
E. They can prevent attacks from the internet only.
Answer: A,B
P.S. Easily pass 200-125 Exam with 2passeasy Virtual Dumps & pdf vce, Try Free: https://www.2passeasy.com/dumps/200-125/ (573 New Questions)