Master the ccna wireless 200 355 official cert guide pdf free download Implementing Cisco Wireless Network Fundamentals content and be ready for exam day success quickly with this Actualtests 200 355 wifund pdf practice test. We guarantee it!We make it a reality and give you real ccna wireless 200 355 dumps questions in our Cisco ccna wireless 200 355 official cert guide braindumps.Latest 100% VALID Cisco ccna wireless 200 355 official cert guide pdf free download Exam Questions Dumps at below page. You can use our Cisco 200 355 vce braindumps and pass your exam.


2026 New 200-355 Exam Dumps with PDF and VCE Free: https://www.2passeasy.com/dumps/200-355/

Q1. Which type of management tasks can be completed on a Cisco WLC remotely from a wireless client? 

A. All management and configuration tasks can be performed from a wireless client except for using debug commands. 

B. In the default configuration, no management or configuration is possible through the GUI or CLI on the Cisco WLC. 

C. The default configuration of the Cisco WLC allows only CLI access and then only the use of show commands, so no configuration is possible. 

D. All management and configuration tasks, except uploads from and downloads to the Cisco WLC, are permitted. 

Answer: B 

Q2. Which Cisco WCS tool allows you to view current reports, open specific types of reports, create and save new reports, and manage scheduled runs? 

A. Reports menu 

B. Reports launch page 

C. Scheduled Run results 

D. saved reports 

Answer: B 

Q3. A network engineer requires an antenna for a point-to-point bridge with at least 20 dBi of gain. Which antenna is appropriate for the task? 

A. Yagi 

B. patch 

C. parabolic dish 

D. dipole 

E. internal omnidirectional 

Answer: C 

Q4. In what WCS menu would an engineer locate the WCS software version? 

A. Administration > Settings 

B. Help > About Cisco WCS 

C. Help > Online Help 

D. Administration > License Center 

Answer: B 

Q5. Which type of basic radiation pattern does a Yagi antenna have? 

A. circular 

B. semicircular 

C. straight line 

D. cone 

Answer: D 

Q6. Tablets and other wireless clients are unable to connect at any 802.11 n data rates. What is the most likely cause of this problem? 

A. WLAN > General properties are incorrectly configured. 

B. WLAN > QoS properties are incorrectly configured. 

C. WLAN > Security properties are incorrectly configured. 

D. WLAN > Advanced properties are incorrectly configured. 

E. Wireless > AP > 802.11 a/n is incorrectly configured. 

F. Wireless > 802.11a/n > Network is incorrectly configured. 

Answer: C 

Q7. Which two items are needed to discover the IP address of a new Cisco Aironet 1260 autonomous AP that just finished booting? (Choose two.) 

A. username = "cisco" and password = "cisco" 

B. username = "Admin" and password = "Cisco" 

C. username=Cisco and password=Cisco 

D. show int vlan1 

E. show int bvi1 

F. show int gigabitethernet0 

G. show int radio0-802.11n 

H. show int radio1-802.11n 

Answer: C,E 

Q8. Refer to the exhibit. A customer is determining whether a Windows 7 laptop is operating on the correct IEEE 802.11 standard. Which standard is being used by the laptop in the exhibit? 

A. 802.11b 

B. 802.11g 

C. 802.11n 

D. 802.11p 

Answer: C 

Q9. Which two items are used to help convert a lightweight AP into an autonomous AP? (Choose two.) 

A. HTTP express setup on the AP 

B. Cisco WCS template 

C. Cisco WLC CLI 

D. Windows Cisco Conversion Tool 

E. image with naming convention of platform_name-k9w7-tar.default 

F. image with naming convention of platform_name-rcvk9w8-tar 

Answer: C,E 

Q10. What three components must be the same on a controller and the RADIUS server when adding a RADIUS server to a WLC? (Choose three.) 

A. Username 

B. Shared Secret 

C. Index Priority 

D. Port Number 

E. IP Address 

F. Network Mask 

Answer: B,D,E