Ucertify cisco 200 355 Questions are updated and all ccna wireless 200 355 answers are verified by experts. Once you have completely prepared with our ccna wireless 200 355 dumps exam prep kits you will be ready for the real 200 355 wifund pdf exam without a problem. We have Leading Cisco ccna wireless 200 355 dumps dumps study guide. PASSED 200 355 pdf First attempt! Here What I Did.


2026 New 200-355 Exam Dumps with PDF and VCE Free: https://www.2passeasy.com/dumps/200-355/

Q1. Refer to the exhibit. 

What does the yellow shield with the exclamation mark indicate? 

A. The network uses open authentication and no encryption. 

B. The network uses an unsupported channel. 

C. The signal is too distorted to connect. 

D. The AP that is transmitting this SSID uses the wrong RF domain. 

E. This is the ad-hoc network. 

Answer: A 

Q2. What are three functions of RRM? (Choose three.) 

A. dynamic channel assignment 

B. detection and avoidance of interference 

C. dynamic antenna polarization 

D. dynamic transmit power control 

E. dynamic controller selection 

F. detection and avoidance of AP client load 

Answer: A,B,D 

Q3. Which two actions would you use to begin to troubleshoot an access point that fails to join a wireless LAN controller successfully? (Choose two.) 

A. SSH to the AP. 

B. SSH to the Cisco WCS. 

C. SSH to the Cisco WLC. 

D. Issue the Cisco WLC command debug capwap events enable 

E. Issue the Cisco WLC command show capwap events 

Answer: C,D 

Q4. What tab contains access point configuration in the WCS? 

A. Controller > Access Points 

B. Configure > Access Points 

C. General > Configure > Access Points 

D. System > Configure > Access Points 

Answer: B 

Q5. Refer to the exhibit. 

Which two options does this icon represent about the status of the respective AP on a Cisco WCS version 7.0 map? (Choose two.) 

A. The 802.11a/n radio is administratively disabled. 

B. The 802.11a/n radio has a minor fault. 

C. The 802.11a/n radio has a major fault. 

D. The 802.11b/g/n radio is administratively disabled. 

E. The 802.11b/g/n radio has a minor fault. 

F. The 802.11b/g/n radio has a major fault. 

Answer: C,D 

Q6. A customer cannot access the GUI on the Cisco 5508 Wireless Controller from the management interface due to network failure. Which interface can the customer use to access the WLC GUI until the network issues are resolved? 

A. virtual 

B. dynamic 

C. console port 

D. service port 

Answer: D 

Q7. Which two of the following authentication methods used for WiFi security require the use of certificates? (Choose two.) 

A. PEAP 

B. EAP-FAST 

C. WPA2 

D. WPA1 

E. EAP-TLS 

F. EAP-MD5 

Answer: A,E 

Q8. What technology consists of small, low-power digital radios? 

A. LTE 

B. WiFi 

C. ZigBee 

D. Bluetooth 

Answer: C 

Q9. Which type of frames are ACK and CF-ACK? 

A. control 

B. management 

C. RTS/CTS 

D. association 

Answer: A 

Q10. Refer to the exhibit. 

A customer has enabled the primary DNS server to return the correct controller IP address in response to a CISCO-CAPWAP-CONTROLLER.localdomain request coming from new access points associating to the wireless network. The access points seem to still be receiving the wrong IP address and cannot associate to the primary controller. 

Why are the access points receiving the wrong IP information? 

A. The DHCP option 43 has an incorrect controller IP address configured. 

B. The DNS server must be configured to respond to CISCO-LWAPP-CONTROLLER.localdomain request. 

C. The controller and wireless action point need to be Layer 2 adjacent. 

D. The controller must be configured for DHCP option 15 request. 

Answer: A