The Refresh Guide To 300-075 exam question

Q1. Which two actions ensure that the call load from Cisco TelePresence Video Communication Server to a Cisco Unified Communications Manager cluster is shared across Unified CM nodes? (Choose two.)

A. Create a neighbor zone in VCS with the Unified CM nodes listed as location peer addresses.

B. Create a single traversal client zone in VCS with the Unified CM nodes listed as location peer addresses.

C. Create one neighbor zone in VCS for each Unified CM node.

D. Create a VCS DNS zone and configure one DNS SRV record per Unified CM node.

E. In VCS set Unified Communications mode to Mobile and remote access and configure each Unified CM node.

View Answer

Q2. Which two options for a Device Mobility-enabled IP phone are true? (Choose two.)

A. The phone configuration is not modified.

B. The roaming-sensitive parameters of the current (that is, the roaming) device pool are applied.

C. The user-specific settings determine which location-specific settings are downloaded from the Cisco Unified Communications Manager device pool.

D. If the DMGs are the same, the Device Mobility-related settings are also applied.

View Answer

Q3. A local gateway is registered to Cisco TelePresence Video Communication Server with a prefix of 7. The administrator wants to stop calls from outside the organization being routed through it. Which CPL configuration accomplishes this goal?

A)

B)

C)

D)

E)

A. Exhibit A

B. Exhibit B

C. Exhibit C

D. Exhibit D

E. Exhibit E

View Answer

Q4. Which function can be implemented without MTP resources?

A. DTMF relay conversion

B. terminating a media stream that uses the same codec

C. music on hold

D. SIP early offer

View Answer

Q5. What is an advantage of TEHO?

A. TEHO implemented with ISRs eliminates PSTN toll charges.

B. TEHO implemented with ISRs can reduce PSTN toll charges.

C. TEHO implemented with AAR reduces toll charges.

D. TEHO implemented with CFUR reroutes calls.

View Answer

Q6. Which gateway does the Cisco Unified Communications Manager control all call activity?

A. SIP

B. MGCP

C. H.323

D. Media

View Answer

Q7. Which command is needed to utilize local dial peers on an MGCP-controlled ISR during an SRST failover?

A. ccm-manager fallback-mgcp

B. telephony-service

C. dialplan-pattern

D. isdn overlap-receiving

E. voice-translation-rule

View Answer

Q8. Which three messages does a Cisco VCS use to monitor the Presence status of endpoints?

(Choose three.)

A. start-call

B. in-all

C. end-call

D. call-ended

E. call-started

F. registration

View Answer

Q9. The network administrator of Enterprise X receives reports that at peak hours, some calls between remote offices are not passing through. Investigation shows no connectivity problems. The network administrator wants to estimate the volume of calls being affected by this issue.

Which two RTMT counters can give more information on this? (Choose two.)

A. CallsRingNoAnswer

B. OutOfResources

C. LocationOutOfResources

D. RequestsThrottled

E. CallsAttempted

View Answer

Q10. When configuring a video ISDN gateway. Which two actions are requirements for the cisco preferred Architecture for enterprise collaboration? (choose two)

A. Use SIP instead of H.323.

B. Perform dial string manipulation on Cisco Unified Communications Manager.

C. Use an * (asterisk) at the end of each ISDN number, as a suffix.

D. Use H.323 instead of SIP.

E. Use an ! (exclamation point) at the end of each ISDN number, as a suffix.

View Answer