Master the 300-080 Troubleshooting Cisco IP Telephony and Video content and be ready for exam day success quickly with this Actualtests 300-080 test preparation. We guarantee it!We make it a reality and give you real 300-080 questions in our Cisco 300-080 braindumps.Latest 100% VALID Cisco 300-080 Exam Questions Dumps at below page. You can use our Cisco 300-080 braindumps and pass your exam.


2026 New 300-080 Exam Dumps with PDF and VCE Free: https://www.2passeasy.com/dumps/300-080/

Q1. Cisco Unified Communications Manager failed to register with the Cisco SAF Forwarder. Assuming that the Cisco IOS SAF Forwarder is configured correctly, which minimum configuration would be needed on Cisco Unified Communications Manager to test registration? 

A. SAF trunk, SAF security profile, Cisco SAF Forwarder, and CCD advertising service 

B. SAF trunk, SAF security profile, Cisco SAF Forwarder, and CCD requesting service 

C. SAF trunk, SAF security profile, Cisco SAF Forwarder, CCD requesting service, and CCD advertising service 

D. SAF trunk, SAF security profile, and Cisco SAF Forwarder 

E. SAF trunk, CCD requesting service, and CCD advertising service 

Answer: B 

Q2. You must integrate a third-party H.323 system with your existing Cisco Unified Communications Manager cluster. When you create an H.323 trunk from the cluster, calls from the cluster to the third-party H.323 system are failing. The vendor of the third-party H.323 device has confirmed that the H.323 call setup time must be reduced. Which two approaches reduce the call setup time from Cisco Unified Communications Manager to the third-party H.323 device? (Choose two.) 

A. Implement a software MTP. 

B. Implement a hardware MTP. 

C. Implement transcoding with the router DSP resources. 

D. Implement transcoding with the Cisco Unified Communications Manager resources. 

Answer: A,B 

Q3. Refer to the exhibits. 

Assume that all learned SAF routes are placed in the SAF_Pt partition. The 3XXX directory number pattern is being advertised by a remote cluster and is also being blocked by the local cluster that is shown in the exhibit. An IP phone is attached to the local cluster and is configured with a CSS that contains the following partitions: SAF_Pt and Internal_Pt in this order. When the IP phone places a call to 3001, what will occur? 

A. The call will succeed and will be placed via the SIP_Trunk. 

B. The call will fail because it will be blocked by the CCD Blocked Learned Route configuration. 

C. The call will be placed in a round-robin fashion between the SAF network and SIP_Trunk. 

D. The call will placed in a round-robin fashion between the SAF network and SIP_Trunk. Every other call will fail. 

Answer: A 

Q4. Which four performance counters are available when monitoring a Cisco MTP device using the Cisco Unified Communications Manager RTMT? (Choose four.) 

A. Resource Total 

B. Resource Available 

C. Out of Resources 

D. Resource Idle 

E. Resource Active 

F. MTP Streams Active 

G. MTP Connection Lost 

H. MTP Instances Active 

Answer: A,B,C,E 

Q5. Some users report that they cannot dial out from headquarters on their Cisco IP Phones to PSTN users, but others can. Which troubleshooting approach is the most direct to isolate the source of the failure of the users that cannot dial out to the PSTN? 

A. Use DNA to analyze the dialing permissions of the Cisco IP Phones. 

B. Use DNA to generate actual calls to the PSTN. 

C. Use RTMT to analyze the dialing permissions of the Cisco IP Phones. 

D. Use RTMT to generate actual calls to the PSTN. 

Answer: A 

Q6. Endpoints are configured for both H.323 and SIP using the same URI and Cisco VCS settings, but the endpoints register only as H.323 endpoints. What is causing this issue? 

A. A firewall is blocking all traffic from the endpoints to the Cisco VCS. 

B. The Cisco VCS has no SIP domains configured. 

C. The Cisco VCS is blocking the endpoints because of duplicate ID entries. 

D. The endpoints do not have the SIP option key installed. 

E. SIP does not work, because SIP is used for Cisco Unified Communications Manager registration only. 

Answer: B 

Q7. Refer to the exhibit. 

Which Cisco Unified Communications Manager trace file level should be selected when enabling traces to send to Cisco TAC for analysis? 

A. State Transition 

B. Arbitrary 

C. Significant 

D. Error 

E. Detailed 

F. Special 

Answer: E 

Q8. Refer to the exhibit. 

Which course of action will resolve the Mobile Connect issues that are shown in the exhibit? 

A. Configure the Mobility softkey on the phone. 

B. Enable the user for Cisco Mobile Connect. 

C. Make the user an owner of the phone device in the phone device configuration page. 

D. Enable the device mobility mode on the phone since it is disabled. 

Answer: C 

Q9. When parsing trace output after the call routing decision and path selection have been made, which two records can be found in the CCM|RouteList? (Choose two.) 

A. PretransfromDigitString 

B. CallingPartyNumber 

C. PretransformCallingPartyNumber 

D. RouteListName 

E. findLocalDevice 

F. RouteListCdrc : 

Answer: D,F 

Q10. Which two issues can prevent an IP Phone from receiving an IP address via DHCP? (Choose two.) 

A. The DHCP server is not on the same VLAN as the phone. 

B. The DHCP scope's leases are exhausted. 

C. DHCP Option 150 is incorrect. 

D. The TFTP server is not reachable. 

E. The DHCP scope is not defined for the subnet of the phone. 

Answer: A,B