Free of ccnp route 300 101 dumps free exam materials and paper for Cisco certification for IT learners, Real Success Guaranteed with Updated ccnp 300 101 pdf dumps vce Materials. 100% PASS ROUTE Implementing Cisco IP Routing exam Today!
2026 New 300-101 Exam Dumps with PDF and VCE Free: https://www.2passeasy.com/dumps/300-101/
P.S. Free 300-101 paper are available on Google Drive, GET MORE: https://drive.google.com/open?id=1oF6hAYEiseB3LPIXYA2sgTXv0r2MX46d
New Cisco 300-101 Exam Dumps Collection (Question 13 - Question 22)
New Questions 13
Which two statements about NetFlow templates are true? (Choose two)
A. Only NetFlow version 9 is template based.
B. NetFlow Version 5 and version 9 are template based.
C. Only NetFlow version 5 is template based.
D. Template can increased bandwidth usage
E. They can increase overall performance.
F. They can reduce bandwidth usage.
Answer: A,D
Explanation: https://www.cisco.com/en/US/technologies/tk648/tk362/technologies_white_paper09186a0 0800a3db9.html
New Questions 14
Which command must be globally enabled on a Cisco router to support IPv6?
A. ip routing ipv6
B. ipv6 unicast-routing
C. ipv6 routing
D. ip classless
E. ipv6 cef
Answer: B
New Questions 15
What are the four main steps in configuring a GRE tunnel over IPsec on Cisco routers? (Choose Four)
A. Configure a physical interface or create a loopback interface to use as the tunnel endpoint.
B. Create the GRE tunnel interfaces.
C. Add the tunnel interfaces to the routing process so that it exchanages routing updates across that interface.
D. Add the tunnel subnet to the routing process so that it exchanages routing updates across that interface.
E. Add all subnets to the crypto access-list, so that IPsec encrypts the GRE tunnel traffic.
F. Add GRE traffic to the crypto access-list, so that IPsec encrypts the GRE tunnel traffic.
Answer: A,B,D,F
New Questions 16
Which two statements about GRE tunnel interfaces are true?
A. To establish a tunnel, the source interface must be in the up/up state.
B. A tunnel destination must be routable, but it can be unreachable.
C. A tunnel can be established when the source interface is in the up/down state.
D. To establish a tunnel, the source interface must be a loopback.
Answer: A,B
Explanation: http://www.cisco.com/c/en/us/support/docs/ip/generic-routing-encapsulation-gre/118361-technote-gre-00.html
New Questions 17
Which two statements about 6to4 tunneling are accurate? (Choose two.)
A. Prepending a reserved IPv6 code to the hexadecimal representation of 192.168.0.1 facilitates 6to4 tunneling.
B. Each 6to4 site receives a /48 prefix in a 6to4 tunnel.
C. 2002::/48 is the address range specifically assigned to 6to4.
D. Prepending 0x2002 with the IPv4 address creates an IPv6 address that is used in 6to4 tunneling.
E. 6to4 is a manual tunnel method.
Answer: B,D
New Questions 18
Refer to the exhibit. The network setup is running the RIP routing protocol. Which two events will occur following link failure between R2 and R3? (Choose two.)
A. R2 will advertise network 192.168.2.0/27 with a hop count of 16 to R1.
B. R2 will not send any advertisements and will remove route 192.168.2.0/27 from its routing table.
C. R1 will reply to R2 with the advertisement for network 192.168.2.0/27 with a hop count of 16.
D. After communication fails and after the hold-down timer expires, R1 will remove the 192.168.2.0/27 route from its routing table.
E. R3 will not accept any further updates from R2, due to the split-horizon loop prevention mechanism.
Answer: A,C
New Questions 19
Which mode of uRPF causes a router interface to accept a packet, if the network to which the packetu2021s source IP address belongs is found in the routeru2021s FIB?
A. Strict mode
B. Loose mode
C. Auto mode
D. Desirable mode
Answer: B
Explanation:
EXPLANATION/REFRENCE
A number of common types of DoS attacks take advantage of forged or rapidly changing source IP addresses, allowing attackers to thwart efforts by ISPs to locate or filter these attacks. Unicast RPF was originally created to help mitigate such attacks by providing an automated, scalable mechanism to implement the Internet Engineering Task Force (IETF) Best Common Practices 38/Request for Comments 2827 (BCP 38/RFC 2827) anti-spoofing filtering on the customer-to-ISP network edge. By taking advantage of the information stored in the Forwarding Information Base (FIB) that is created by the CEF switching process, Unicast RPF can determine whether IP packets are spoofed or malformed by matching the IP source address
and ingress interface against the FIB entry that reaches back to this source (a so-called reverse lookup). Packets that are received from one of the best reverse path routes back out of the same interface are forwarded as normal. If there is no reverse path route on the sam e interface from which the packet was received, it might mean that the source address was modified, and the packet is dropped (by default).
http://www.cisco.com/c/en/us/td/docs/ios-xml/ios/sec_data_urpf/configuration/xe-3s/sec-data-urpf-xe-3s-book/sec-unicast-rpf-loose-mode.html?referring_site=RE&pos=1&page=http://www.cisco.com/c/en/us/td/docs/ios/12_0s/feature/guide/srpf_gsr.html#GUID-FFFA94D5- EEFB-4215-9EE1-DB37CD01C2CA
New Questions 20
Which NAT Command to disable dynamic ARP learning on an interface?
A. R(config-if) # ip nat enable
B. R(config-if) # ip nat inside
C. R(config-if)# ip nat outside
D. R(config)# ip nat service
E. R(config)# ip nat allow static host
Answer: E
New Questions 21
Which two options are requirements for EIGRP authentication? (Choose two)
A. A crypto map must be configured.
B. The Authentication key must be configured under the interface running EIGRP.
C. The authentication key must be configured within the EIGRP routing configuration.
D. The authentication key IDs must match between two neighbors.
E. A separate key chain must be configured.
F. AN IPsec profile must be configured.
Answer: B,D
New Questions 22
When a packet is denied by an IPv6 traffic filter, which additional action does the device perform?
A. It scans the rest of the ACL for a permit entry matching the destination.
B. It generates a TCP Fin bit and sends it to the source.
C. A creates a null route for the destination and adds it to the route table.
D. It generates an ICMP unreachable message for the frame.
Answer: D
Recommend!! Get the Free 300-101 dumps in VCE and PDF From Allfreedumps, Welcome to download: https://www.allfreedumps.com/300-101-dumps.html (New 487 Q&As Version)