It is more faster and easier to pass the Cisco ccnp switch 300 115 exam by using Actual Cisco Implementing Cisco IP Switched Networks questuins and answers. Immediate access to the Replace cbt nuggets ccnp switch 300 115 download Exam and find the same core area ccnp routing and switching switch 300 115 official cert guide questions with professionally verified answers, then PASS your exam with a high score now.


2026 New 300-115 Exam Dumps with PDF and VCE Free: https://www.2passeasy.com/dumps/300-115/

Q1. A network engineer must adjust the STP interface attributes to influence root port selection. Which two elements are used to accomplish this? (Choose two.)

A. port-priority

B. cost

C. forward-timers

D. link type

E. root guard

Answer: A,B

Q2. Which feature must be enabled to eliminate the broadcasting of all unknown traffic to switches that are not participating in the specific VLAN?

A. VTP pruning

B. port-security

C. storm control

D. bpdguard

Answer: A

Q3. After the implementation of several different types of switches from different vendors, a network engineer notices that directly connected devices that use Cisco Discovery Protocol are not visible. Which vendor-neutral protocol could be used to resolve this issue?

A. Local Area Mobility

B. Link Layer Discovery Protocol

C. NetFlow

D. Directed Response Protocol

Answer: B

Q4. What does the command vlan dot1q tag native accomplish when configured under global

configuration?

A. All frames within the native VLAN are tagged, except when the native VLAN is set to 1.

B. It allows control traffic to pass using the non-default VLAN.

C. It removes the 4-byte dot1q tag from every frame that traverses the trunk interface(s).

D. Control traffic is tagged.

Answer: D

Q5. Which option lists the modes that are available for configuring UDLD on a Cisco switch?

A. normal and aggressive

B. active and aggressive

C. normal and active

D. normal and passive

E. normal and standby

Answer: A

Q6. A network engineer notices inconsistent Cisco Discovery Protocol neighbors according to the diagram that is provided. The engineer notices only a single neighbor that uses Cisco Discovery Protocol, but it has several routing neighbor relationships. What would cause the output to show only the single neighbor?

A. The routers are connected via a Layer 2 switch.

B. IP routing is disabled on neighboring devices.

C. Cisco Express Forwarding is enabled locally.

D. Cisco Discovery Protocol advertisements are inconsistent between the local and remote devices.

Answer: A

Q7. Which First Hop Redundancy Protocol is an IEEE Standard?

A. GLBP

B. HSRP

C. VRRP

D. OSPF

Answer: C

Q8. Which VRRP router is responsible for forwarding packets that are sent to the IP addresses of the virtual router?

A. virtual router master

B. virtual router backup

C. virtual router active

D. virtual router standby

Answer: A

Q9. A network engineer configured a fault-tolerance link on Gigabit Ethernet links G0/1, G0/2, G0/3, and G0/4 between two switches using Ethernet port-channel. Which action allows interface G0/1 to always actively forward traffic in the port-channel?

A. Configure G0/1 as half duplex and G0/2 as full duplex.

B. Configure LACP port-priority on G0/1 to 1.

C. Configure LACP port-priority on G0/1 to 65535.

D. LACP traffic goes through G0/4 because it is the highest interface ID.

Answer: B

Q10. What is the maximum number of VLANs that can be assigned to an access switchport without a voice VLAN?

A. 0

B. 1

C. 2

D. 1024

Answer: B