Your success in Cisco 300-360 is our sole target and we develop all our 300-360 braindumps in a way that facilitates the attainment of this target. Not only is our 300-360 study material the best you can find, it is also the most detailed and the most updated. 300-360 Practice Exams for Cisco CCNP Wireless 300-360 are written to the highest standards of technical accuracy.
2026 New 300-360 Exam Dumps with PDF and VCE Free: https://www.2passeasy.com/dumps/300-360/
Q1. Which two options describe best practices that must be completed after a wireless installation is finished?
(Choose two.)
A. Make sure that there are no spaces between the devices on the rack that the Wireless Lan Controller isinstalled.
B. Consult with the customer to ensure that the IT staff has a complete set of design and installationdocuments.
C. Make sure the customer is aware that they should consider purchasing a support contract immediately afterthe installation is complete.
D. Spend time with the customer to show them the controller GUI and inform them how they can reach theCisco TAC if they have any problems.
E. Test all the customer’s wireless devices and applications to ensure they are working properly.
Answer: B,E
Q2. An engineer is conducting a location readiness test and wants a selected point to be considered location-ready. Which three possible configurations reflect the minimum number of APs needed? (Choose three.)
A. One AP is resident in each quadrant surrounding the point-in-question.
B. One AP per 1400 sq. ft. on the map.
C. Two APs are resident in each quadrant surrounding the point-in- question.
D. Four APs are deployed on the floor.
E. Three APs are within 70 feet (21 meters) of the point-in- question
F. Three APs are deployed on the floor.
Answer: A,D,E
Explanation:
A point in a WLAN deployment is location ready if the following are all determined to be true:
At least four access points are deployed on the floor.
At least one access point is found to be resident in each quadrant surrounding the point-in- QUESTION NO:. At least one access point residing in each of at least three of the surrounding quadrants is located within 70 feet of the point-in-QUESTION NO:.
Reference:
http://www.cisco.com/c/en/us/td/docs/solutions/Enterprise/Borderless_Networks/Unified_Access/CMX/CMX_LocFund.pdf
Q3. Which two best practices should be considered when a customer wants to purchase and implement Voice over Wireless for Cisco 7925 IP Phones? (Choose two.)
A. Enable lower data rates for 2.4-GHz data WLAN and higher data rates for phones.
B. Use a separate Cisco Wireless Lan Controller.
C. Enable 802.1x and Cisco Centralized Key Management for phone authentication.
D. Use dedicated Access Points only for Voice over Wireless.
E. Set data for 2.4 GHz and voice for 5 GHz using separate SSIDs.
Answer: C,E
Q4. An engineer is assigned to provide wireless coverage in a provincial capital building. Due to the age and historic nature of the building, the ability to run new copper Ethernet cable to desired AP locations is limited. Which requirement should the engineer specify to overcome this restriction?
A. Deploy access points where the survey indicates and connect them via fiber optic cable, using a mediaadapter, and locally provide power.
B. Deploy access points to each phone location converting two spare pairs of copper from the phone line toEthernet and locally provide power.
C. Deploy access point devices where limited cable can be run or exists and connect high- gain antennas andincrease Tx power to increase cell size.
D. Deploy RAP where limited cable can be run or exists, and extend coverage using MAP.
Answer: D
Q5. What is a common cause for signal attenuation?
A. Cinder block wall
B. Office window
C. Metal door
D. Glass wall
Answer: C
Q6. Which three recommendations must be taken into consideration when an engineer is installing a new Voice WLAN? (Choose three.)
A. Use the Cisco wireless phone site survey client utility.
B. Use a separate Cisco Wireless Lan Controller.
C. Enable load balance on voice WLANs.
D. Maintain -67dBM as a minimal RSSI.
E. Set data for 2.4 GHz and voice for 5 GHz using separate SSIDs.
F. Enable lower data rates for 2.4-GHz data WLAN.
Answer: A,D,E
Q7. A customer is deploying a mesh outdoor wireless network based on FCC standards where spectrum analysis shows significant radar energy propagating throughout the coverage area from a local weather station. Which channel must be excluded from the access points RRM calculation to avoid network disruption due to weather radar activity?
A. 132
B. 44
C. 11
D. 36
Answer: A
Explanation:
Weather radars operate within the 5600- to 5650-MHz band, which means that channels 124 and 128 might be affected, but also channels 120 and 132 might suffer from weather radar activity.
Reference: http://www.cisco.com/c/en/us/td/docs/wireless/technology/mesh/7-3/design/guide/Mesh/ Mesh_chapter_0111.html
Q8. A customer wants to implement a wireless network in a historic location, but is concerned about the structural and aesthetic impact to the facility. Which benefit of using wireless mesh addresses these concerns?
A. Power is required only at the installation location.
B. The APs do not have LED lights.
C. More wireless channels can be supported.
D. APs do not need network connections.
Answer: D
Q9. A customer has restricted the AP and antenna combinations for a design to be limited to one model integrated antenna AP for carpeted spaces and one model external antenna AP, with high gain antennas for industrial, maintenance, or storage areas. When moving between a carpeted area to an industrial area, the engineer forgets to change survey devices and surveys several APs. Which option is the best to reduce the negative impact of the design?
A. Deploy the specified access points per area type.
B. Resurvey and adjust the design.
C. Increase the Tx power on incorrectly surveyed access points.
D. Deploy unsurveyed access points to the design.
Answer: B
Q10. A network engineer is configuring QoS with a DSCP value of 46. To which queue must the CoS be mapped for priority queuing of the voice frames?
A. 1
B. 2
C. 5
D. 4
E. 3
Answer: C