It is more faster and easier to pass the Cisco 640-878 exam by using Pinpoint Cisco Building Cisco Service Provider Next-Generation Networks, Part 2 questuins and answers. Immediate access to the Leading 640-878 Exam and find the same core area 640-878 questions with professionally verified answers, then PASS your exam with a high score now.


2026 New 640-878 Exam Dumps with PDF and VCE Free: https://www.2passeasy.com/dumps/640-878/

Q1. The permit 172.16.32.0 0.0.15.255 access-list entry permits exactly which IP address range? 

A. 172.16.32.0 to 172.16.47.255 

B. 172.16.32.0 to 172.16.48.255 

C. 172.16.32.0 to 172.16.62.255 

D. 172.16.32.0 to 172.16.63.255 

E. 172.16.32.0 to 172.16.64.255 

F. 172.16.32.0 to 172.16.255.255 

Answer: A 

Q2. What is dual IOS mode on the Cisco ASR 1001 Router? 

A. redundant IOS processes that are running on the active RP and standby RP 

B. active and standby IOS processes that are running on a single RP 

C. separate Cisco IOS XE and IOS XR processes that are running on a single RP 

D. separate Cisco IOS XE and IOS XR processes that are running on two different RPs 

E. checkpointed redundant IOS processes that are running on two different RPs in active/active mode 

Answer: B 

Q3. Cisco IP NGN service providers can offer multiple services to their customers by using which type of technology in their core networks? 

A. ATM 

B. SONET/SDH 

C. Frame Relay 

D. IP/MPLS 

E. PBB 

Answer: D 

Q4. Which Cisco IOS access list permits HTTP traffic that is sourced from host 10.1.129.100 port 3030 and that is destined to host 192.168.1.10? 

A. access-list 101 permit tcp any eq 3030 

B. access-list 101 permit tcp 10.1.128.0 0.0.1.255 eq 3030 192.168.1.0 0.0.0.15 eq www 

C. access-list 101 permit tcp 10.1.129.0 0.0.0.255 eq www 192.168.1.10 0.0.0.0 eq www 

D. access-list 101 permit tcp host 192.168.1.10 eq 80 10.1.0.0 0.0.255.255 eq 3030 

E. access-list 101 permit tcp 192.168.1.10 0.0.0.0 eq 80 10.1.0.0 0.0.255.255 

F. access-list 101 permit ip host 10.1.129.100 eq 3030 host 192.168.1.100 eq 80 

Answer: B 

Q5. Which IPv6 address block is reserved for 6to4 tunneling? 

A. 2000::/16 

B. 2001::/16 

C. 2002::/16 

D. 3ffe::/16 

E. fe80::/16 

Answer: C 

Q6. Which statement about Cisco IOS XE software is true? 

A. It uses a two-stage configuration process. 

B. It is identical in look and feel to Cisco IOS software. 

C. It runs on the Cisco ASR 9010 platform. 

D. Packages can be added using the install add and install activate commands. 

E. It runs on the Cisco ME 3400 platform. 

Answer: B 

Q7. Refer to the partial Cisco IOS XR BGP configuration exhibit. 

***Exhibit is Missing*** 

Which two statements are true? (Choose two) 

A. This router uses its Loopback 0 interface IP address when establishing BGP peering with the 

10.2.1.1 router. 

B. This router uses its Loopback 0 interface IP address when establishing BGP peering with the 

192.168.101.11 router. 

C. Test1 refers to a route policy that is defined using the RPL. 

D. Both the IBGP and EBGP sessions will be authenticated. 

E. The IBGP session is missing the mandatory route-policy configuration. 

Answer: A,C 

Q8. Which four statements about REP configurations on a Cisco ME 3400 switch port are true? 

 (Choose four.) 

A. The port must be an NNI type and must be in trunk mode. 

B. Use the rep segment number command to enable REP on the switch port. 

C. A REP segment cannot be wrapped into a ring topology. REP supports only a topology where each REP segment has two exit points via two edge switches. 

D. The port where the segment terminates is called the edge port. 

E. With REP, at least one port is always blocked in any given segment-that is, the alternate port. 

F. If a failure occurs within the segment, the blocked port goes to the forwarding state after it goes through the listening state and the learning state. 

Answer: A,B,D,E 

Q9. Which file extension indicates a bootable installation file in Cisco IOS XR software? 

A. .bin 

B. .tar 

C. .smu 

D. .pie 

E. .vm 

F. .mini 

Answer: E 

Q10. Refer to the Cisco IOS XR commands exhibit. 

***Exhibit is Missing*** 

The router administrator is trying to activate a software package on the router but is not able to do so. Which statement about this problem is true? 

A. The router needs to be in the global configuration mode. 

B. The router needs to be in the admin global configuration mode. 

C. The router needs to be in the admin EXEC mode. 

D. The install activate command is not the correct command to use. 

E. The administrator needs to log in as the "root" user instead of the "admin" user. 

Answer: C 

When upgrading a Cisco ASR 1001 Router, when is the request platform software package expand file bootflash:image-name command required? 

A. to copy the consolidated Cisco IOS XE image to the bootflash: 

B. to perform Cisco IOS ISSU on the standby route processor 

C. to run the router using a consolidated package 

D. to run the router using individual subpackages